Megascape Technology WCRVS-01 Wireless Car Rear Vision System User Manual

Download:
Mirror Download [FCC.gov]
Document ID	382096
Application ID	Nq+7iyCYX9zQMaAB/M9tJg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	26.85kB (335636 bits)
Date Submitted	2003-12-17 00:00:00
Date Available	2003-12-17 00:00:00
Creation Date	2003-09-08 17:43:36
Producing Software	Acrobat 5.0 Scan Plug-in for Windows
Document Lastmod	2003-09-08 17:45:30
Document Title	User Manual
Document Creator	Acrobat 5.0 Scan Plug-in for Windows

Introduction
Congratulations! You have chosen a smart system helping you to safely back
up or change lanes.
It is easy to install, and easy to operate.
Full installation takes a few easy steps : setup the Vrdeo Receiver in the car,
connect the wmera appropriately, then set the channel and tum on the powerl
Wirelus Car Rear Vision System consists of a Color Wdeo Camera with built-
in 2.4GHz Video Sender, and a Vldeo Receiver unit which you sonnet: to a
display in the wr. Also included is a Power Supply Cigarette Plug which you
can use in the vehicle, and a remote control for the Camera Video Sender.
Important Safety Instructions
All the safety and operating instructions should be read before the product is
operated.
Cleaning - Unplug this product from the power before cleaning. Do not use
quurd cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Use only with the bracket included in the package. Any mounting of the
product should follow the manufacturer’s instructions.
Power-Cord Protection — Power supply cords should be routed and protected.
Servicing — Do not attempt to service this product yourself as opening or
removing covers may expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Damage Requiring Service - Unplug this product and refer servicing to
qualified service personnel under the following conditions:
) Vln'len the power-supply cord or plug is damaged.
b If the product does not operate normally by following the operating
instmctions. Adjust only those controls that are covered by the
operating instructions as an improper adjustment of other controls may
result in damage and will often require extensive work by a qualified
technician to restore the product to its normal operation.
b if the product has been dropped or damaged in any way
i Whenthe productefltibitsadisfinctchangein performance—this
indicates a need for service
' FCC Caution
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE
(2) THIS DEVICE MUST ACCEPTANY INTERFERENCE RECENED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERTAION.
This equipment generates and uses radio frequency energy, and if not
installed and used properly in strictaccordance with the manufacturers
instructions, it may cause interference to radio and television reception. It has
been type tested and found to comply with the limits for remote control
devices in accordance wit the specifications in Sub-Parts B and C of Part 15
of FCC Rules. which are designed to provide reasonable protection against
such interference in a residential instalhfion. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be
determined by unplugging the equipment, try to correct the interference by
referring to the troubleshooting.
Precaution
Please make sure the vehicle is parked at a safe place, the engine and the
power of the vehicle are switched off before installation.
Installation
Step1. — Setting up the Wdeo Receiver
1. Connect the included AV able to the AV out jack of the Video
Receivert ,
Connect the other end to AV in jack to the display.
Plug the Power Supply Cigarette Plug into the video Receivers Jack.
Position the Video Receiver in a convenient location within easy ream
of the driver.
PQ’N
Stepz — Setting up the Video Sender Camera
Use the screws to fix the bracket and the Video Sender Camera.
DC 12V (6V'24V)
Connect the Video Sender Camera to the vehicle DC power supply system,
(Consult the automobile technician it necessary) Special Free Voltage
Technology was applied to this model; you can connect to any voltage input
from ev to 24V,
The polarization foolproof function ensures proper installtion.
Do not mount the camera to the vehicle before testing
Step3. - Channel setting and testing.
Set the channel mm on the Video Receiver to eny channel 1, 2, 3, or 4.
Press the Power button on the remote control of COD Camera, and select the
channel (1-4) you set on the Video Receiver.
Tum on the display. and switch it to the AV input, you will receive the image.
Finally, adjust the angle of the camera for the best result, and mount it firmly,
About Night Wsion
Night Wsion function will be automatically on when light is low‘ You can use
the remote control to turn onloff lR manually if necessary.
REMOTE CONTROL
FUNCTlON:
]nght\lision :
(ch1~4. atpnesent) l
: Channel Sdect
Troubleshooting
If you cannot get any signal at all
Check the channel slide on the V'mo Receiver , and select the same channel
on the Remote Control ofthe Camera.
Check the channel of the diSplay, make sure it is on the right AV channel.
If the signal is poor, or them is interference.
Try to change the channel. (Switch the channel on the Receiver first, then
filfil‘i'ET‘Zté 9°33? 9993999.“ Q‘flnflc’f E“? 9123?) _________
(Q 7)) O BOTHANTENNASARE up
(Q 777
,..__--_..--....-....
<<< ”7 O naewgwssmm
(u 177
__________________________________________
4 CAMERAS ARE LINED
IN A CIRCLE,
AROUND THE RECEIVER
Introduction
it is easy to install, and easy to operate.
The Car LCD System consists of a 5.6—INCH TFT-LCD Monitor with AV and
power cord, a bracket, and a Power Supply Cigarette Plug which you can use
in the vehicle. and a remote control for the TFT-LCD Monitor.
(A) TFT-LCD
(8) Power Supply
Cigarette Charger
1:2‘ Hz r=l
Important Safety Instructions
Cleaning — Unplug this product from the power before cleaning. Do not use
liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Use only with the bracket included in the package. Any mounting of the
product should follow the manufacturer’s instructions
Power-Cord Protection — Power supply cords should be routed and protected.
Servidng - Do not attempt to service this product yourself as opening or
removing covers may expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Damage Requiring Service — Unplug this product and refer servicing to
qualified service personnel under the followrng conditions:
) When the power-supply cord or plug is damaged.
b if the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions as an improper adjustment of other controls may
result in damage and will often require extensive work by a qualified
technician to restore the product to its normal operation.
) If the product has been dropped or damaged in any way
7 Men the product exhibits a distinct change in performance — this
indicates a need for service
FCC Caution
THIS DEVICE COMPLlES WITI-I PART 15 OF THE FCC RULES.
OPERATION lS SUBJECT TO THE FOLLOWING TWO CONDITIONS: ‘
(1) THlS DEVlCE MAY NOT CAUSE HARMFUL lNTERFERENCE
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESlRED
OPERTAION.
This equipment generates and uses radio frequency energy, and if not
installed and used properly in strict accordance with the manufacturers
instructions, it may muse interference to radio and television reception. It has
been type tesmd and found to comply with the limits for remote control
devices in awordance witthe specifications in Sub-Parts B and C of Part 15
of FCC Rules, which are designed to provide reasonable protection against
such interference in a residential installation. However, there is no guarantee
that interference will not occur in a particular installation. if this equipment
does cause interference to radio or television reception, which can be
determined by unplugging the equipment, try to correct the interference by
referring to the troubleshooting.
Precaution
Please make sure the vehicle is parked at a safe place, the engine and the
power of the vehicle are switched off before installation.
(A) TFT—LCD
1.00nnedeerhe.V|deoUneandAudbine.nfl1ePwerLEDfightindlm
Wheeispowefsupply
2.Twnonthepo«er
3. Vldeo signal (1.) N'l'SC (2.) PAL. AmoSwlwhing
4. MenuistSelectitetnby"adj|1stkey'artderlter‘rnenukey”or”enterkey"(lR)
"NU NTSC PA]. We
Bright ya m afiliufid by “adiust key"
Cd“ ' yes yes filmed by "adjust key"
Cal-mast yes yes adjusted by "adjua key"
Tint yes no adjusted by "adjus key" (NTSC only)
Sanning yes yes flip image by “select key” , ~
Dim° yes yes adjusted by "Edit-S! REY"
Default yes yes reset
Exit yes yes save and exit
5. Volume key adjusted by “volumd adqu key”.
6. Channel key: Switching W channel ifyuu conned TV tunef box‘

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2003:09:08 17:45:30+08:00
Create Date                     : 2003:09:08 17:43:36+08:00
Creator                         : Acrobat 5.0 Scan Plug-in for Windows
Page Count                      : 8
Mod Date                        : 2003:09:08 17:45:30+08:00
Creation Date                   : 2003:09:08 17:43:36+08:00
Producer                        : Acrobat 5.0 Scan Plug-in for Windows
Metadata Date                   : 2003:09:08 17:45:30+08:00

EXIF Metadata provided by EXIF.tools