Mettler Toledo SMARTSCAN Smart Scan with RFID for XPR Balances User Manual SmartScan

Mettler-Toledo GmbH Smart Scan with RFID for XPR Balances SmartScan

Contents

User Manual Smart Scan

SmartScan
for XPR Balances
English
1
Installation
This accessory must be installed by a METTLER TOLEDO service technician.
2
Compliance Information
United States of America
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
30491783A12/13/2018 3:21 PM- Schema ST4 PDF engine -Layout by Victor Mahler
Supplementary Sheet
Deutsch
Español
Français
简体中文
日本語
Mettler-Toledo GmbH
Im Langacher 44
8606 Greifensee, Switzerland
www.mt.com/contact
Subject to technical changes.
© Mettler-Toledo GmbH 12/2018
30491783Aen, de, es, fr, zh, ja
30491783

Navigation menu