Micro Star MS6820 Wireless 11g MiniPCI Card User Manual 6823 TOC
Micro Star International Co Ltd Wireless 11g MiniPCI Card 6823 TOC
Contents
USERS MANUAL 2
Wireless 11g MiniPCI Card MP54G User’s Guide Infrastructure Mode : The difference between Infrastructure network and Ad-hoc network is that the former one includes an Access Point. In an Infrastructure network, the Access Point can manage the bandwidth to maximize bandwidth utilization. Additionally, the Access Point enables users on a wireless LAN to access an existing wired network, allowing wireless users to take advantage of the wired networks resources, such as Internet, email, file transfer, and printer sharing. The scale and range of the Infrastructure network are larger and wider than that of the Ad-hoc networking. Wireless 11g MiniPCI Card MP54G User’s Guide >>> 1.3 Specifications Hardware Specifications Compliant Standards IEEE 802.11g/b Bus and Connector Types 32-bit 3.3V Type IIIA 124-pin Golden Finger Security Mechanism Hardware-Base WEP Privacy Hardware-Base AES Privacy (driver update) Operational Environment Operational Temperature: 0 ~ 55OC Humidity: 10 ~ 90% (Non-Condensing) Weight and Dimension Weight:11.5g Dimension: 50.8 x 59.6 x 4.9mm Radio Frequency Specifications Raw Data Rates and Modulation Types IEEE802.11b (Auto-Fallback) CCK: 11 and 5.5Mbps DQPSK: 2Mbps DBPSK: 1Mbps IEEE802.11g (Auto-Fallback) OFDM: 54, 48, 36, 24, 18, 12, 9, 6Mbps Communication Protocol DSSS (Direct Sequence Spread Spectrum) with ACK Half-Duplex Access Method Infrastructure Mode: Station-To-LAN Architecture Ad-Hoc Mode: Station-To-Station Architecture Wireless 11g MiniPCI Card MP54G User’s Guide Frequency, Bandwidth, and Channels 2.4 ~ 2.4835GHz Frequency Band 11 Channels Maximum 3 Non-Overlapped Channels 25MHz Bandwidth Per Channel Transmitter Output Power Output Power: 14dBm ± 1dBm Wireless Coverage Up to 500m Receiving Sensitivity ≤ -82dBm @ 11Mbps (DSSS/CCK) ≤ -68dBm @ 54Mbps (OFDM) Software Specifications Security Mechanism 64-/128-Bit WEP Key AES-CCM Authentication Mode (driver update) WPA Support (driver update) LEAP/PEAP Support (firmware upgrade) Authentication Mechanism Open Authentication (Default) Shared-Key Authentication Operating System Microsoft® Windows® 98SE/ME/2000/XP Wireless 11g MiniPCI Card MP54G User’s Guide >>> 1.4 System Requirements Before installing the MP54G, your PC should meet the following: Desktop/notebook PC with an available MiniPCI slot. Windows® 98SE/ME/2000/XP operating system. Minimum 5M bytes free disk space for installing the driver and utilities. CD-ROM drive, double speed or higher. >>> 1.5 Package Contents Unpack the package and check all the items carefully. If any item contained is damaged or missing, please contact your local dealer as soon as possible. Also, keep the box and packing materials in case you need to ship the unit in the future. The package should contain the following items: One Wireless 11g MiniPCI Card. One Quick Installation Guide. One CD title including drivers, utilities, user’s manual and quick guide. Wireless 11g MiniPCI Card MP54G User’s Guide >>> 1.6 Product View External antenna connectors (J1: Main, J2: Aux) Connect to external antennas for enhanced data transmission and reception. The external antennas are well designed on the desktop or notebook computers. NOTE: Please connect the J1(Main) connector if there is only one antenna to connect. J1 Golden Finger J2 Wireless 11g MiniPCI Card MP54G User’s Guide Hardware Installation The following diagrams provide you with a basic installation for the MP54G, including how to install and remove the MiniPCI card. The instruction below is suitable for most computers with MiniPCI slot. For more information about the MiniPCI module, please refer to your computer’s manual. >>> 2.1 Installing the MP54G 1. Locate the Mini PCI slot on the mainboard. 2. Place the MP54G over the MiniPCI slot (at an angle of 30 degrees). Then, gently insert it into the slot until the golden finger of the card gets fully inserted. 3. Press down the card, and the retaining clips (on two sides of the slot) will lock onto the notches of the card. Foolproof notch 30 Wireless 11g MiniPCI Card MP54G User’s Guide >>> 2.2 Removing the MP54G 1. Locate the MiniPCI slot with MP54G installed. 2. Press the retaining clips outwards, and the card should bound upwards slightly after being released from the slot. 3. Remove the card from the MiniPCI slot carefully. Wireless 11g MiniPCI Card MP54G User’s Guide Software Installation This section describes the procedures of installing the driver and utility. Follow the instruction step by step to finish the installation. If you use Windows® 98SE/ME, please prepare the Windows® Setup CD at hand before installing the driver; because the system will ask you to insert the Setup CD to copy files during the installation. >>> 3.1 Installing on Windows® 98SE/ME Step 1. Insert the driver CD into your CD-ROM drive, and the Setup program should launch automatically. The card should be installed into your computer before installing the driver and utility. If the Autorun program doesn’ t launch, click Start at the taskbar and select Run...; type E:\setup.exe in the Open box and click OK, where E is your CD-drive. Click Windows 98SE 10
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 8 Has XFA : No XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:03d2f4a5-1bd2-4436-85dd-cc7abc7ece6b Modify Date : 2004:02:06 14:06:56-05:00 Create Date : 2004:02:06 14:06:45-05:00 Metadata Date : 2004:02:06 14:06:56-05:00 Document ID : uuid:210da80d-b0b8-40fa-9fed-f6e7f4cdcc15 Format : application/pdf Title : 6823-TOC Creator : Adobe PageMaker 7.0 Author : user Subject : 6823-TOC Producer : Acrobat Distiller 5.0 (Windows)EXIF Metadata provided by EXIF.tools