Microsoft BH-104A Mono Bluetooth Headset User Manual BH 104 en2 with FCC IC notice

Microsoft Mobile Oy Mono Bluetooth Headset BH 104 en2 with FCC IC notice

Manual

Nokia Bluetooth Headset BH-1049213523/28214356791011 12BH-104_en2_with_FCC&IC_notice.fm Page 1 Wednesday, February 11, 2009 10:37 AM
ENGLISHDECLARATION OF CONFORMITYHereby, NOKIA CORPORATION declares that this BH-104 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/.Hereby, NOKIA CORPORATION declares that this BH-104A product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/.© 2008-2009 Nokia. All rights reserved.Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation. Nokia tune is a sound mark of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners.Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited.Bluetooth is a registered trademark of Bluetooth SIG, Inc.Nokia operates a policy of ongoing development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice.To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or BH-104_en2_with_FCC&IC_notice.fm Page 2 Wednesday, February 11, 2009 10:37 AM
ENGLISHcontents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice.The availability of particular products may vary by region. Please check with your Nokia dealer for details.Export ControlsThis device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited.IntroductionWith the Nokia Bluetooth Headset BH-104, you can make and receive calls while on the move.Read this user guide carefully before using the headset. Also, read the user guide for your phone.This product may contain small parts. Keep them out of the reach of small children. The surface of this device is nickel-free.Bluetooth wireless technologyBluetooth wireless technology allows you to connect compatible devices without cables. The phone and the headset do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices.The headset is compliant with Bluetooth Specification 2.1 + EDR supporting the Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device.BH-104_en2_with_FCC&IC_notice.fm Page 3 Wednesday, February 11, 2009 10:37 AM
ENGLISHGet startedThe headset contains the following parts shown on the title page: indicator light (1), earloop (2), volume keys (3), answer/end key (4), earpiece (5), power key (6), charger connector (7), and microphone (8).Before using the headset, you must charge the battery and pair the headset with a compatible phone.Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not place credit cards or other magnetic storage media near the device, because information stored on them may be erased.Charge the batteryBefore charging the battery, carefully read “Battery and charger information”.Warning: Use only chargers approved by Nokia for use with this particular model. The use of any other types may invalidate any approval or warranty, and may be dangerous.When you disconnect the power cord of any accessory, grasp and pull the plug, not the cord.1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector. The red indicator light is displayed during charging. Charging the battery fully may take up to 2 hours.3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then from the wall outlet.The fully charged battery has power for up to 10 hours of talk time or up to 200 hours of standby time.BH-104_en2_with_FCC&IC_notice.fm Page 4 Wednesday, February 11, 2009 10:37 AM
ENGLISHTo check the battery charge when the headset is not connected to a charger, press the power key. If the indicator light is green, the charge level is sufficient. If the light is yellow, you may need to recharge the battery soon. If the light is red, recharge the battery.When the battery charge is low, the headset beeps every 5 minutes and the red indicator light flashes.Switch on or offTo switch on, press and hold the power key for about 2 seconds. The headset beeps, and the green indicator light is displayed. The headset tries to connect to a paired phone.To switch off, press and hold the power key for about 2 seconds when the headset is on. The headset beeps, and the red indicator light is briefly displayed. If the headset is not connected to a phone within about 30 minutes, it switches off automatically.Pair and connect the headsetBefore using the headset, you must pair and connect it with a compatible phone.1. Ensure that your phone is on and the headset is off.2. Press and hold the power key (for about 5 seconds) until the green indicator light starts to flash quickly.3. Within about 3 minutes, activate the Bluetooth feature on the phone, and set it to search for Bluetooth devices.4. Select the headset from the list of found devices.5. If necessary, enter the passcode 0000 to pair and connect the headset to your phone. In some phones, you may need to make the BH-104_en2_with_FCC&IC_notice.fm Page 5 Wednesday, February 11, 2009 10:37 AM
ENGLISHconnection separately after pairing.When the headset is connected to your phone and is ready for use, the green indicator light flashes about every 5 seconds.Basic usePlace the headset on the earThe headset is ready to be used on the left ear. To use the headset on the right ear, rotate the earloop so that it is to the right of the Nokia logo (11 and 12).Slide the earloop behind your ear (9), and gently push the earpiece against your ear. Carefully bend the earloop around your ear for the best fit. Push or pull the earloop to set its length. Point the headset towards your mouth (10).CallsTo make a call, use your phone in the normal way when the headset is connected to it.To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the answer/end key twice.To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the answer/end key for about 2 seconds. Proceed as described in the phone user guide.BH-104_en2_with_FCC&IC_notice.fm Page 6 Wednesday, February 11, 2009 10:37 AM
ENGLISHTo answer or end a call, press the answer/end key. To reject a call, press this key twice.To adjust the volume, press either volume key.To mute or unmute the microphone, press both volume keys at the same time. When the microphone is muted, the green indicator light flashes twice about every 5 seconds.To switch a call from the headset to a compatible phone, press and hold the answer/end key for about 2 seconds, or switch off the headset. To switch the call back to the headset, press and hold the answer/end key for about 2 seconds, or switch on the headset.Turn lights on or offBy default, the indicator lights are shown in all situations. To turn the lights off in some situations (for example, during a call or when the headset is connected to a phone) or back on, press and hold the power key and the answer/end key for about 5 seconds when the headset is connected to a phone.Clear settings or resetTo delete the pairings from the headset when it is switched off, press and hold the power key and the answer/end key (for about 5 seconds) until the red and green indicator lights start to alternate.To reset the headset if it stops functioning, even though it is charged, connect the headset to a charger while you press and hold the power key.TroubleshootingIf you cannot connect the headset to your compatible phone, check that the headset is charged, switched on, and paired with your phone.BH-104_en2_with_FCC&IC_notice.fm Page 7 Wednesday, February 11, 2009 10:37 AM
ENGLISHBattery and charger informationThis device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, AC-8, and DC-4. The exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E, EB, X, AR, U, A, C, or UB. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Use of an unapproved charger may present a risk of fire, explosion, leakage, or other hazard.If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed.Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time.Always try to keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime of the battery. A device with a hot or cold battery may not work temporarily. Battery performance is particularly limited in temperatures well below freezing.Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.BH-104_en2_with_FCC&IC_notice.fm Page 8 Wednesday, February 11, 2009 10:37 AM
ENGLISHNever use any charger that is damaged.Important: Battery talk and standby times are estimates only and depend on network conditions, features used, battery age and condition, temperatures to which battery is exposed, and many other factors. The amount of time a device is used for calls will affect its standby time. Likewise, the amount of time that the device is turned on and in the standby mode will affect its talk time.Care and maintenanceYour device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage.• Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely.• Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged.• Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.• Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards.• Do not attempt to open the device.• Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics.BH-104_en2_with_FCC&IC_notice.fm Page 9 Wednesday, February 11, 2009 10:37 AM
ENGLISH• Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.• Do not paint the device. Paint can clog the moving parts and prevent proper operation.These suggestions apply equally to your device, charger, or any accessory. If any device is not working properly, take it to the nearest authorised service facility for service.RecycleThe crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more environmental information, see the product Eco-Declarations at www.nokia.com/environment.Always return your used electronic products, batteries, and packaging materials to a dedicated collection point. This way you help prevent uncontrolled waste disposal and promote the recycling of materials. More detailed information is available from the product retailer, local waste authorities, national producer responsibility organisations, or your local Nokia representative. Check how to recycle your Nokia products at www.nokia.com/werecycle, or if browsing on a mobile device, www.nokia.mobi/werecycle.BH-104_en2_with_FCC&IC_notice.fm Page 10 Wednesday, February 11, 2009 10:37 AM
ENGLISHFCC/Industry Canada noticeThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference; and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. NOTE: Changes or modifications not expressly approved by Nokia could void the user's authority to operate the equipment.BH-104_en2_with_FCC&IC_notice.fm Page 11 Wednesday, February 11, 2009 10:37 AM

Navigation menu