Microsoft HF-22 Bluetooth Car Kit User Manual CK 100 QIG with FCC IC en1
Microsoft Mobile Oy Bluetooth Car Kit CK 100 QIG with FCC IC en1
Contents
- 1. Manual 1
- 2. Manual 2
Manual 2
CK-100_QIG_with_FCC&IC_en1.fm Page 1 Wednesday, April 30, 2008 12:29 PM Nokia Car Kit CK-100 9210212/1 CK-100_QIG_with_FCC&IC_en1.fm Page 2 Wednesday, April 30, 2008 12:29 PM CK-100_QIG_with_FCC&IC_en1.fm Page 3 Wednesday, April 30, 2008 12:29 PM ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION, declares that this HF-22 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The product is in conformity with the limits defined in Directive 2004/104/EC (amending Directive 72/245/EEC), Annex I, paragraph 6.5, 6.6, 6.8 and 6.9. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. 0434 © 2008 Nokia. All rights reserved. Nokia, Nokia Connecting People, Navi and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation. Bluetooth is a registered trademark of Bluetooth SIG, Inc. Export controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited. Introduction This quick installation guide briefly describes how to connect the car kit to a car radio system. For details and information about the parts and installation of the car kit, see the user and installation guide on the CD that is supplied with the car kit. CK-100_QIG_with_FCC&IC_en1.fm Page 4 Wednesday, April 30, 2008 12:29 PM ENGLISH Safety information • Do not smoke when working on the Observe the following safety car. Ensure that there is no source guidelines when you connect the car of fire or flame nearby. kit to a car radio system: • Only a qualified service technician • Take care not to cause damage to electrical cables, fuel or brake should install or service the car kit lines, or safety equipment during using the approved original Nokia installation work. parts supplied in the sales package. Faulty installation or service may • Ensure that cables are placed so be dangerous and may invalidate that they will not be subject to any warranty which may apply to mechanical wear and tear (for the car kit. example, not laid under car seats or • Do not wire the car kit equipment over sharp edges). to the high-voltage lines of the ignition system. Integration with a car radio system To connect the hands-free unit HF-22 of the car kit to a car radio system with the ISO cable CA-135, see Figure 1 or 2 at the start of this guide. You can select if the car kit amplifier is used for calls and the car radio amplifier is used for music, or if the car kit amplifier is used for both. CK-100_QIG_with_FCC&IC_en1.fm Page 5 Wednesday, April 30, 2008 12:29 PM ENGLISH If you want to use the loudspeaker SP-3 for calls, use the power cable PCU-4 instead of the ISO cable. For instructions, see the user and installation guide on the CD. You can connect the car kit to a loudspeaker with an impedance of at least 2 ohms. The optimal impedance is 4 ohms. Use the car kit amplifier for calls and music Make the connections as shown in Figure 1 to use the built-in amplifier of the car kit for calls and music played on a device that supports the A2DP Bluetooth profile. After you have connected the ISO cable, connect the input device CU-11 and the microphone MP-2 to the hands-free unit. Use the car kit amplifier for calls and the car radio amplifier for music Make the connections as shown in Figure 2 to use the amplifier and equaliser of your car radio for music played on a device that supports the A2DP Bluetooth profile. The built-in amplifier of the car kit is used for calls. Cut the loop indicated with scissors in the figure. Connect the stereo outputs of the hands-free unit to the AUX input of the car radio. Use an appropriate cable specific to your car radio (this cable is not supplied with the car kit). After you have connected the ISO cable and the stereo output cable, connect the input device CU-11 and the microphone MP-2 to the handsfree unit. CK-100_QIG_with_FCC&IC_en1.fm Page 6 Wednesday, April 30, 2008 12:29 PM ENGLISH FCC/Industry Canada notice NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. NOTE: Changes or modifications not expressly approved by Nokia could void the user's authority to operate the equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Create Date : 2008:04:30 12:29:45+03:00 Modify Date : 2008:04:30 12:29:45+03:00 Page Count : 6 Creation Date : 2008:04:30 09:29:45Z Mod Date : 2008:04:30 09:29:45Z Producer : Acrobat Distiller 5.0.5 (Windows) Author : rjp Metadata Date : 2008:04:30 09:29:45Z Creator : rjp Title : CK-100_QIG_with_FCC&IC_en1.fmEXIF Metadata provided by EXIF.tools