Microsoft HS-107W Nokia BH-102 Bluetooth Headset User Manual HS 107W UG en1 with FCC IC notice

Microsoft Mobile Oy Nokia BH-102 Bluetooth Headset HS 107W UG en1 with FCC IC notice

Users manual

Nokia Bluetooth Headset BH-1029207246/11011987231454446HS-107W_UG_en1_with_FCC&IC_notice.fm Page 1 Wednesday, December 5, 2007 3:31 PM
ENGLISHDECLARATION OF CONFORMITYHereby, NOKIA CORPORATION declares that this HS-107W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/.© 2008 Nokia. All rights reserved.Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners.Reproduction, transfer, distribution, or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited.Bluetooth is a registered trademark of Bluetooth SIG, Inc.Nokia operates a policy of ongoing development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice.To the maximum extent permitted by applicable law, under no circumstances shall Nokia or any of its licensors be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.The contents of this document are provided "as is". Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice.The availability of particular products may vary by region. Please check with your Nokia dealer for details.Export controlsThis device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited.HS-107W_UG_en1_with_FCC&IC_notice.fm Page 2 Wednesday, December 5, 2007 3:31 PM
ENGLISHIntroductionWith the Nokia Bluetooth Headset BH-102, you can make and receive calls while on the move. You can use the headset with compatible phones that support Bluetooth wireless technology.Read this user guide carefully before using the headset. Also, read the user guide for your phone. It provides important safety and maintenance information. Keep the headset out of the reach of small children.Bluetooth wireless technologyBluetooth wireless technology allows you to connect compatible devices without cables. The phone and the headset do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices.The headset complies with the Bluetooth Specification 2.0 + EDR that supports the Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device.Get startedThe headset contains the following parts shown on the title page: earloop (1), charger connector (2), earpiece (3), blue indicator light (4), multifunction key (5), and microphone (6).HS-107W_UG_en1_with_FCC&IC_notice.fm Page 3 Wednesday, December 5, 2007 3:31 PM
ENGLISHBefore using the headset, you must charge the battery and pair the headset with a compatible phone.Parts of the device are magnetic. Metallic materials may be attracted to the device. Do not place credit cards or other magnetic storage media near the device, because information stored on them may be erased.ChargersThis device is intended for use when supplied with power from the following chargers: AC-3, AC-4, AC-5, and DC-4.Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, and may be dangerous.When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord.Charge the batteryBefore charging the battery, carefully read “Battery information”.1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector (8). The indicator light is on during charging. Charging the battery fully may take up to 2 hours.3. When the battery is fully charged, the indicator light turns off. Disconnect the charger from the headset and the wall outlet.The fully charged battery has power for up to 10 hours of talk time or up to 250 hours of standby time.When battery power is low, the headset beeps once every minute and the indicator light flashes quickly.HS-107W_UG_en1_with_FCC&IC_notice.fm Page 4 Wednesday, December 5, 2007 3:31 PM
ENGLISHSwitch on or offTo switch on, press and hold the multifunction key for about 2 to 4 seconds. The headset beeps, and the indicator light is displayed. The headset tries to connect to a paired device.To switch off, press and hold the multifunction key for about 4 to 8 seconds.Pair the headset1. Ensure that your phone is switched on and the headset is switched off.2. Press and hold the multifunction key (for about 4 to 8 seconds) until the indicator light starts to flash quickly.3. Activate the Bluetooth feature on the phone, and set the phone to search for Bluetooth devices.4. Select the headset from the list of found devices.5. Enter the passcode 0000 to pair and connect the headset to your phone. In some phones, you may need to make the connection separately after pairing. You only need to pair the headset with your phone once.If the pairing is successful, the headset appears in the phone menu where you can view the currently paired Bluetooth devices.When the headset is connected to your phone and is ready for use, the indicator light flashes slowly.HS-107W_UG_en1_with_FCC&IC_notice.fm Page 5 Wednesday, December 5, 2007 3:31 PM
ENGLISHBasic usePut on the headsetTo use the headset on your right ear, attach the earloop as shown in Figure 7; to use the headset on your left ear, attach the earloop from the other side. Slide the earloop over your ear (9), and gently push the earpiece into your ear. Point the headset towards your mouth (10).Call handlingTo make a call, use your phone in the normal way when the headset is connected to your phone.To redial the number you last called (if your phone supports this feature with the headset), when no call is in progress, press the multifunction key twice.To activate voice dialling (if your phone supports this feature with the headset), when no call is in progress, press and hold the multifunction key for about 2 to 4 seconds. Proceed as described in the phone user guide.To answer or end a call, press the multifunction key. To reject a call, press this key twice.To adjust the volume during a call, use the phone volume keys.To switch a call between the headset and a compatible phone, press and hold the multifunction key for about 2 to 4 seconds.Clear settings or resetTo delete the pairings from the headset, switch on the headset, and press and hold the multifunction key for over 8 seconds until the headset beeps twice and the indicator light flashes quickly.HS-107W_UG_en1_with_FCC&IC_notice.fm Page 6 Wednesday, December 5, 2007 3:31 PM
ENGLISHTo reset the headset if it stops functioning, even though it is charged, plug the headset into a charger.TroubleshootingIf you cannot connect the headset to your compatible phone, check that the headset is charged, switched on, and paired with your phone.Battery informationYour device is powered by a rechargeable battery. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Use of an unapproved charger may present a risk of fire, explosion, leakage, or other hazard.If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed.Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time.Always try to keep the battery between 15°C and 25°C (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime of the battery. A device with a hot or cold battery may not work temporarily. Battery performance is HS-107W_UG_en1_with_FCC&IC_notice.fm Page 7 Wednesday, December 5, 2007 3:31 PM
ENGLISHparticularly limited in temperatures well below freezing.Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.Never use any charger that is damaged.Important: Battery talk and standby times are estimates only and depend on network conditions, features used, battery age and condition, temperatures to which battery is exposed, and many other factors. The amount of time a device is used for calls will affect its standby time. Likewise, the amount of time that the device is turned on and in the standby mode will affect its talk time.Care and maintenanceYour device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage.• Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely.• Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged.• Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.• Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards.• Do not attempt to open the device.HS-107W_UG_en1_with_FCC&IC_notice.fm Page 8 Wednesday, December 5, 2007 3:31 PM
ENGLISH• Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics.• Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.• Do not paint the device. Paint can clog the moving parts and prevent proper operation.If the device is not working properly, take it to the nearest authorised service facility for service.DisposalThe crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies to the European Union and other locations where separate collection systems are available. Do not dispose of these products as unsorted municipal waste.By returning the products to collection you help prevent uncontrolled waste disposal and promote the reuse of material resources. More detailed information is available from the product retailer, local waste authorities, national producer responsibility organizations, or your local Nokia representative. For the product Eco-Declaration or instructions for returning your obsolete product, go to country-specific information at www.nokia.com.FCC/IndustryCanada noticeThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference; and 2. This device must accept any interference received, including interference that may cause HS-107W_UG_en1_with_FCC&IC_notice.fm Page 9 Wednesday, December 5, 2007 3:31 PM
ENGLISHundesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. NOTE: Changes or modifications not expressly approved by Nokia could void the user's authority to operate the equipment.HS-107W_UG_en1_with_FCC&IC_notice.fm Page 10 Wednesday, December 5, 2007 3:31 PM

Navigation menu