Microsoft WE07M Bluetooth Headset User Manual HS 97W en1 with FCC IC notice ps

Microsoft Mobile Oy Bluetooth Headset HS 97W en1 with FCC IC notice ps

Contents

Manual 1

Nokia Bluetooth Headset BH-209
9204656/1
78
9
11
1
2
3
4
5
6
10
HS-97W_en1_with_FCC&IC_notice.ps Page 1 Wednesday, July 4, 2007 12:38 PM
ENGLISH
DECLARATION OF CONFORMITY
Hereby, NOKIA CORPORATION declares that
this HS-97W product is in compliance with
the essential requirements and other
relevant provisions of Directive 1999/5/EC. A
copy of the Declaration of Conformity can be
found at http://www.nokia.com/phones/
declaration_of_conformity/.
© 2007 Nokia. All rights reserved.
Reproduction, transfer, distribution or
storage of part or all of the contents in this
document in any form without the prior
written permission of Nokia is prohibited.
Nokia and Nokia Connecting People are
registered trademarks of Nokia Corporation.
Other product and company names
mentioned herein may be trademarks or
tradenames of their respective owners.
Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
Nokia operates a policy of ongoing
development. Nokia reserves the right to
make changes and improvements to any of
the products described in this document
without prior notice.
Under no circumstances shall Nokia be
responsible for any loss of data or income or
any special, incidental, consequential or
indirect damages howsoever caused.
The contents of this document are provided
"as is". Except as required by applicable law,
no warranties of any kind, either express or
implied, including, but not limited to, the
implied warranties of merchantability and
fitness for a particular purpose, are made in
relation to the accuracy, reliability or
contents of this document. Nokia reserves
the right to revise this document or
withdraw it at any time without prior notice.
The availability of particular products may
vary by region. Please check with the Nokia
dealer nearest to you.
Unauthorized changes or modifications to
this device may void the user's authority to
operate the equipment.
Export Controls
This device may contain commodities,
technology or software subject to export
laws and regulations from the US and other
HS-97W_en1_with_FCC&IC_notice.ps Page 2 Wednesday, July 4, 2007 12:38 PM
ENGLISH
countries. Diversion contrary to law is
prohibited.
Introduction
The Nokia Bluetooth Headset BH-209
allows you to make and receive calls
while on the move. You can use the
headset with compatible mobile
devices that support Bluetooth
wireless technology.
Read this user guide carefully before
using the headset. Also read the user
guide for your mobile device, which
provides important safety and
maintenance information. Keep the
headset out of reach of small children.
Bluetooth wireless technology
Bluetooth wireless technology allows
you to connect compatible devices
without cables. The phone and the
headset do not need to be in line of
sight, but they should be within
10 meters (33 feet) of each other.
Connections may be subject to
interference from obstructions, such
as walls, or other electronic devices.
The headset complies with the
Bluetooth Specification 2.0 + EDR
that supports the Headset Profile 1.1
and Hands-Free Profile 1.5. Check
with the manufacturers of other
devices to determine their
compatibility with this device.
There may be restrictions on using
Bluetooth technology in some
locations. Check with your local
authorities or service provider.
HS-97W_en1_with_FCC&IC_notice.ps Page 3 Wednesday, July 4, 2007 12:38 PM
ENGLISH
Get started
The headset contains the following
parts shown on the title page: green
indicator light (1), multifunction key
(2), charger connector (3), earloop (4),
earpiece (5), and microphone (6).
Before using the headset, you must
charge the battery and pair the
headset with a compatible mobile
device.
Parts of the headset are magnetic.
Metallic materials may be attracted to
the headset. Do not place credit cards or
other magnetic storage media near the
headset, because information stored on
them may be erased.
Chargers
Check the model number of any charger
before using it with this headset. The
headset is intended for use with the
AC-3, AC-4, and DC-4 chargers.
Warning: Use only chargers
approved by Nokia for use
with this particular
enhancement. The use of any other types
may invalidate any approval or warranty
and may be dangerous.
When you disconnect the power cord of
any enhancement, grasp and pull the
plug, not the cord.
Charge the battery
The headset has an internal,
nonremovable, rechargeable battery.
Do not attempt to remove the battery
from the device, as you may damage
the device.
1. Connect the charger to a wall
outlet.
2. Connect the charger cable to the
charger connector. The indicator
light is on while charging. It may
take a while before charging starts.
HS-97W_en1_with_FCC&IC_notice.ps Page 4 Wednesday, July 4, 2007 12:38 PM
ENGLISH
If charging does not start,
disconnect the charger, plug it in
again, and retry. Charging the
battery fully may take up to
2hours.
3. When the battery is fully charged,
the indicator light turns off.
Disconnect the charger from the
headset and the wall outlet.
The fully charged battery has power
for up to 6 hours of talk-time or up to
150 hours of standby time. However,
the times may vary with different
compatible Bluetooth devices, usage
settings, usage styles, and
environments.
When battery power is low, the
indicator light quickly flashes twice
about every 3 seconds.
Switch the headset on or off
To switch on, press and hold the
multifunction key until the headset
beeps four times and the indicator
light is displayed.
To switch off, press and hold the
multifunction key until the headset
beeps four times and the indicator
light is displayed briefly.
Pair the headset
1. Ensure that your phone is switched
on and the headset is switched off.
2. Press and hold the multifunction
key until the indicator starts to
flash quickly and the headset beeps
twice.
3. Activate the Bluetooth feature on
the phone, and set the phone to
search for Bluetooth devices.
4. Select the headset from the list of
found devices.
5. Enter the passcode 0000 to pair
and connect the headset to your
phone. In some phones you may
need to make the connection
HS-97W_en1_with_FCC&IC_notice.ps Page 5 Wednesday, July 4, 2007 12:38 PM
ENGLISH
separately after pairing. You only
need to pair the headset with your
phone once.
If the pairing is successful, the
headset appears in the phone menu
where you can view the currently
paired Bluetooth devices. When the
indicator light flashes twice every 5
seconds, the headset is connected to
the mobile device and ready for use.
Basic use
Place the headset on the ear
To use the headset with the supplied
earloop, insert the earloop into the
small opening at the back of the
headset (9).
Slide the earloop over your ear (10),
and gently plug the earpiece into your
ear. Push or pull the earloop to set its
length. Set the headset so that it
points toward your mouth (11). To use
the headset on the left ear, rotate the
earloop so that the loop is to the left
of the Nokia logo (Figures 7 and 8).
Call handling
To make a call, use your phone in the
normal way when the headset is
connected to your phone.
If your phone supports last number
redialing with the headset, press the
multifunction key twice when no call
is in progress.
If your phone supports voice dialing
with the headset, press the
multifunction key when no call in
progress, and proceed as described in
the user guide of your mobile device.
HS-97W_en1_with_FCC&IC_notice.ps Page 6 Wednesday, July 4, 2007 12:38 PM
ENGLISH
To answer or end a call, press the
multifunction key. To reject the call,
press and hold the multifunction key
for about 3 seconds.
To adjust the volume, use the volume
keys on your mobile device.
To switch the call between the
headset and a compatible device,
press and hold the multifunction key
for about 2 seconds.
Reset
To reset the headset if it stops
functioning, although it is charged,
plug the headset into a charger.
Battery information
Your device is powered by a rechargeable
battery. The battery can be charged and
discharged hundreds of times, but it will
eventually wear out. Recharge your
battery only with Nokia approved
chargers designated for this device.
Unplug the charger from the electrical
plug and the device when not in use. Do
not leave a fully charged battery
connected to a charger, since
overcharging may shorten its lifetime. If
left unused, a fully charged battery will
lose its charge over time.
Never use any charger that is damaged.
Leaving the device in hot or cold places,
such as in a closed car in summer or
winter conditions, will reduce the
capacity and lifetime of the battery.
Always try to keep the battery between
15°C and 25°C (59°F and 77°F). A device
with a hot or cold battery may not work
temporarily, even when the battery is
fully charged. Battery performance is
particularly limited in temperatures well
below freezing.
HS-97W_en1_with_FCC&IC_notice.ps Page 7 Wednesday, July 4, 2007 12:38 PM
ENGLISH
Do not dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged.
Care and maintenance
Your device is a product of superior
design and craftsmanship and should be
treated with care. The following
suggestions will help you protect your
warranty coverage.
• Keep the device dry. Precipitation,
humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If your
device does get wet, allow it to dry
completely.
• Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can be
damaged.
• Do not store the device in hot areas.
High temperatures can shorten the
life of electronic devices, damage
batteries, and warp or melt certain
plastics.
• Do not store the device in cold areas.
When the device returns to its normal
temperature, moisture can form
inside the device and damage
electronic circuit boards.
• Do not attempt to open the device.
• Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.
• Do not use harsh chemicals, cleaning
solvents, or strong detergents to
clean the device.
• Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.
HS-97W_en1_with_FCC&IC_notice.ps Page 8 Wednesday, July 4, 2007 12:38 PM
ENGLISH
All of the above suggestions apply
equally to your device, battery, charger,
or any enhancement. If any device is not
working properly, take it to the nearest
authorized service facility for service.
Disposal
The crossed-out wheeled-bin
symbol on your product,
literature, or packaging reminds
you that in the European Union
all electrical and electronic products,
batteries, and accumulators must be
taken to separate collection at the end of
their working life. Do not dispose of these
products as unsorted municipal waste.
Return the products to collection to
prevent possible harm to the
environment or human health from
uncontrolled waste disposal and to
promote the sustainable reuse of
material resources. Collection
information is available from the product
retailer, local waste authorities, national
producer responsibility organizations, or
your local Nokia representative. For more
information, see product Eco-Declaration
or country-specific information at
www.nokia.com.
FCC/Industry
Canada notice
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: 1. This device may not cause
harmful interference; and 2. This device
must accept any interference received,
including interference that may cause
undesired operation. This equipment has
been tested and found to comply with the
limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
HS-97W_en1_with_FCC&IC_notice.ps Page 9 Wednesday, July 4, 2007 12:38 PM
ENGLISH
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver. Connect the
equipment into an outlet on a circuit
different from that to which the receiver is
connected. Consult the dealer or an
experienced radio/TV technician for help.
NOTE: FCC Radiation Exposure Statement:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This transmitter must not be
co-located or operating in conjunction with
any other antenna or transmitter. NOTE:
Changes or modifications not expressly
approved by Nokia could void the user's
authority to operate the equipment.
HS-97W_en1_with_FCC&IC_notice.ps Page 10 Wednesday, July 4, 2007 12:38 PM

Navigation menu