Midmark 9A408H1 Wireless Hand Controller User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1224932
Application ID	PqUA3dHPj1FXNr/MAf8ssQ==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	10.89kB (136085 bits)
Date Submitted	2010-01-08 00:00:00
Date Available	2010-01-08 00:00:00
Creation Date	2009-11-09 09:21:17
Producing Software	Acrobat Distiller 9.2.0 (Windows)
Document Lastmod	2009-11-09 09:21:17
Document Title	untitled

Specifications
Range of Operation ................. 20 ft (6 m) radius
The wireless control’s “association” is preset at the factory.
This procedure is only required if there is a malfunction, or if you
are attempting to use the controller with a chair other than the one
it was originally associated with.
Association Procedure:
A. Using the wired hand or foot control, press & hold
the Stop & Home buttons simultaneously.
Batteries:
Hand Control ......................... AA (qty: 2)
Foot Control .......................... AA (qty: 2)
(Note: Battery access cover is located on back of controller)
(after two seconds you will hear a single “beep”)
B*. Using the wireless hand control, press & hold
the Stop & Home buttons until you hear three “beeps”.
(one long “beep” indicates the association failed. Repeat Steps A & B)
C. Check for proper operation of wireless hand control.
D. Repeat procedure for wireless foot control.
* Note: Step B must be performed within 3 seconds of Step A,
failure to do so will cause the procedure to fail.
MA771100i
Troubleshooting
• When any control button is pressed, that controller
sounds a single “beep”. (All functions operate)
Cause:
Low Battery
Solution: Replace batteries
• When any control button is pressed,
nothing happens. (No “beeps”, no movement, etc.)
Causes: 1. Batteries completely dead
2. Wireless controller has lost
“association” to chair.*
Solution: 1. Replace batteries
2. Perform Association Procedure*.
* The wireless controllers will only function with the
chair they have been “associated” with. This
prevents unwanted movement in locations with
more than one chair.
If further service is required,
contact your authorized Midmark dealer.
Compliance Information
FCC Compliance Statement
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense.
Any modifications to this product may violate the rules
of the Federal Communications Commission and make
operation of the product unlawful.
Declaration of Conformity

Midmark Corporation declares that
9A408001 thru 9A408008 conforms to
the applicable requirements of the
Radio Equipment & Telecommunications
Equipment Directive 1999/5/EC, Annex II.
Serial Number:
Limited Warranty
General Information
SCOPE OF WARRANTY
Attention: Wired Hand & Foot Controls
Midmark Corporation (“Midmark”) warrants to the original purchaser its
new Alternate Care products and components (except for components
not warranted under “Exclusions”) manufactured by Midmark to be free
from defects in material and workmanship under normal use and
service. Midmark’s obligation under this warranty is limited to the repair
or replacement, at Midmark’s option, of the parts or the products the
defects of which are reported to Midmark within the applicable warranty
period and which, upon examination by Midmark, prove to be defective.
Wired hand & foot controls are shipped standard with
all models. A wired controller (either hand or foot) is
required to perform the Association Procedure.
This procedure may be required in the event of a
malfunction, do not discard the wired controllers.
(Refer to: Association Procedure in this User Guide)
The applicable warranty period, measured from the date of delivery to
the original user, shall be one (1) year for all warranted products and
components.
EXCLUSIONS
This warranty does not cover and Midmark shall not be liable for the
following: (1) repairs and replacements because of misuse, abuse,
negligence, alteration, accident, freight damage, or tampering;
(2) products which are not installed, used, and properly cleaned as
required in the Midmark “Installation” and or “Installation / Operation
Manual for this applicable product. (3) products considered to be of a
consumable nature; (4) accessories or parts not manufactured by
Midmark; (5) charges by anyone for adjustments, repairs, replacement
parts, installation, or other work performed upon or in connection with
such products which is not expressly authorized in writing in advance
by Midmark.
EXCLUSIVE REMEDY
Midmark’s only obligation under this warranty is the repair or replacement of defective parts. Midmark shall not be liable for any direct,
special, indirect, incidental, exemplary, or consequential damages or
delay, including, but not limited to, damages for loss of profits or loss
of use.
NO AUTHORIZATION
Intended Use
This product is intended to control patient positioning
while providing better patient access by eliminating
the cord from the hand & foot controls.
Authorized CE Representative
Countries in the EEC should direct all questions,
incidents, and complaints to Midmark’s authorized
CE Representative listed below:
Promotal
22, Rue de St. Denis
53500 Ernee,
FRANCE
Phone: 33-2-430-517-76
Fax: 33-2-430-569-10
Calling for Service
No person or firm is authorized to create for Midmark any other
obligation or liability in connection with the products.
077-0520-00
Wireless Hand / Foot Controls
9A408
APPLICABLE WARRANTY PERIOD
ALL to present
Quality Assurance Manager
Gene Harshbarger
Midmark Corp.
60 Vista Dr.
P.O. Box 286
Versailles, OH 45380
U.S.A.
User’s Guide
THIS WARRANTY IS MIDMARK’S ONLY WARRANTY AND
IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED. MIDMARK MAKES NO IMPLIED WARRANTIES
O F ANY KIND INCLUDING ANY WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR
PURPOSE. THIS WARRANTY IS LIMITED TO THE REPAIR
OR REPLACEMENT OF DEFECTIVE PARTS.
If service is required, contact your Midmark dealer
or to locate your nearest service provider, log onto:
http://www.midmark.com
This guide outlines basic operation of the wireless
hand / foot control accessory. If service is required,
contact your authorized Midmark dealer.
To contact Midmark directly:
Dealer (name / phone):
1-800-Midmark (1-800-643-6275)
8:00 am until 5:00 pm Mon-Fri (EST)
SF-1487 REV. A1
___________________________________
___________________________________
___________________________________
___________________________________
Date of Purchase:
Midmark Corporation
60 Vista Drive
Versailles, OH 45380-0286
Phone: 937-526-3662
Fax: 937-526-5542
midmark.com
_____________________
© Midmark Corporation 2007
003-1735-00 Rev.B

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Create Date                     : 2009:11:09 09:21:17-05:00
Modify Date                     : 2009:11:09 09:21:17-05:00
Producer                        : Acrobat Distiller 9.2.0 (Windows)
Format                          : application/pdf
Title                           : untitled
Document ID                     : uuid:390a70a9-5181-45de-b39d-3f55f3dc06eb
Instance ID                     : uuid:4359c6ae-952c-409c-a56d-7550ad84977a
Page Count                      : 2

EXIF Metadata provided by EXIF.tools