Mine Safety Appliances E5KTX10046340 Wireless Video Transmission System EVOLUTION 5000 User Manual
Mine Safety Appliances Company (MSA) Wireless Video Transmission System EVOLUTION 5000
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 391855 |
| Application ID | Rbi47D8vXU7vpIP8g1LvEQ== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 77.16kB (964499 bits) |
| Date Submitted | 2004-01-27 00:00:00 |
| Date Available | 2004-01-23 00:00:00 |
| Creation Date | 2003-12-18 09:13:10 |
| Producing Software | Acrobat Distiller 5.0.5 (Windows) |
| Document Lastmod | 2003-12-18 09:13:10 |
| Document Title | Microsoft Word - 10048454 E5K VTS Instructions for Use 19th Nov 2003 FINAL – |
| Document Creator | PScript5.dll Version 5.2 |
| Document Author: | SalzmannPMS |
EVOLUTION 5000 Transmitter Wireless Video Transmission System Operation and Instructions 10048454 / 00 Table of Contents Before Use / Description Rechargable Batteries Battery Installation and Care Before Use / Description Battery Maintenance About the Transmitter Caution Warnings and Cautions Cleaning Caution Caution Limitations Warning Operation Troubleshooting Getting Started Service Turning the Transmitter ON and OFF Channel Selection Button Using Interface- Indicators and Warnings Battery LED / System Status Maintenance and Adjustments General Maintenance Warning Battery Information Features and Benefits Specifications Introduction Warranty and Service Ordering Information 1 Before Use / Description Specification Introduction Construction Flame resistant, Congratulations on the purchase of your new water resistant, MSA EVOLUTION 5000 Thermal Imaging externally mounted to Transmitter. This handheld unit provides the TIC. advanced technology backed by years of MSA Approximate Height 210 mm, 8.5 in quality, dedication, and service. Dimensions Width 140 mm, 5.5 in Length 120 mm, 5 in This high definition Transmitter provides the latest in available transmission technology EVOLUTION 5000 w/ battery 455 g, 16.1 oz w/o battery 360 g, 12.7 oz Before Use / Description The Weight Power Source Thermal Rechargable Li Ion battery Imaging Transmitter is a highly sophisticated piece of Power at room max 430 mA when both electronic equipment. The unit is designed to Consumption temperature Channel LED´s are lit and withstand the firefighting conditions of heat, the battery LED is driving spray, and frequent impact normally flashing red seen in the Fire Service. Exsessive rough Operating 1 Li Ion handling may damage the Transmitter and Time battery pack render it inoperable. It is not recommended EIRP 450 mW Transmission Line of 1 mile Range sight Channel 1 Frequency 2458 MHz Channel 2 Frequency 2474 MHz that the Transmitter run for extended periods Transmitting in high-heat conditions. Power The EVOLUTION 5000 Thermal Imaging Camera and Transmitter is intended as an aid to fire and rescue operations, and training. It is not a replacement for standard firefighting > 4 hours techniques and precautions. Users must ensure This device complies with part 90 of the FCC that the fire department´s standard operating rules. Operation is subject to the following two procedures are followed while using the conditions: (1) this device may not cause Transmitter. harmful interference, and (2) this device must About the Transmitter accept any interference received, including The EVOLUTION 5000 Thermal Imaging interference that may cause undesired operation Transmitter is: • equipped with two user selectable channels to provide the best transmission of images. • designed ergonomically for the firefighting environment. • designed to EVOLUTION easily attach 5000 TIC for to the rapid deployment without compromising the TIC´s design when not in use. Warning and Cautions WARNING CAUTION The user must be trained and thoroughly before use. If not fully charged, the system limitations of the Transmitter. Use in will not operate for the specified amount of controlled exercises is suggested before time. Monitor level during use and be using the equipment in actual emergency prepared to exit the hazardous area when a situations. Improper use of the equipment in low battery warning is observed. a hazardous atmoshere could result in serious injury or death. Electromagnetic radiation (radio transmission) may cause interference. Minimize other Do not rely on the TIC´s image as the sole nearby means interference occurs. of navigation or deviate from standard fire-fighting practices during use. radio system is designed to withstand normal extremes. impacts that occur in fire service, such Exposure to excessive thermal conditions impacts may alter the transmission or may result in deterioration and loss of damage the unit. certain high temperature FAILURE TO FOLLOW THE ABOVE CAUTIONS This Transmitter is not rated as "Intrinscally CAN RESULT IN SERIOUS PERSONAL INJURY Safe". OR DEATH. Do not use the system in LIMITATIONS Before entering a hostile environment, test the Transmitter as specified in Although the Transmitter is water resistant, the thermal imaging camera does not the provide under water images. instructions to ensure that it is functional. After each use inspect the system to The system will show reduced or no performance when transmitting video signals determine if servicing is required. through thick walls of concrete or other Replacement batteries must be identical to building materials. the ratings and configuration of those supplied with the equipment. exessive at sparks may cause an explosion. if Do not drop the Transmitter. Although the environments, or atmosheres where static or transmissions Most electronic devices will cease to operate transmission. Ensure that the battery is fully charged familar with the proper operation and Do not remove the case or cover of the Operation electronics. Only authorized personnel may Operation service the unit. Getting started FAILURE WARNINGS TO FOLLOW CAN THE RESULT PERSONAL INJURY OR DEATH. IN ABOVE SERIOUS The rechargable batteries supplied with the Transmitter must be fully charged before use. Also, periodically check and replace the battery in an actively-used transmission system. See "Battery care and Installation" later in this manual. The unit must be attached to the EVOLUTION 5000 TIC. Attaching the Transmitter to the EVOLUTION 5000 TIC Place a fully charged battery inside the housing. Open the housing Fasten the TRANSMITTER to the EVOLUTION 5000 TIC housing Insert the fully charged battery Secure the antenna inside of the front handle of the EVOLUTION 5000 TIC Close the housing q Place the transmitter EVOLUTION 5000 TIC housing and onto the connect the Transmitter via cable to the SMA video outlet of the EVOLUTION 5000 TIC Turning the system ON and OFF Once the Transmitter is properly mounted to the TIC turn on the EVOLUTION 5000 TIC [see instructions for use of the TIC]. The Transmitter will switch on automatically. The system will begin to operate on channel one [1]. The system shows the ON mode with a lit battery and channel LED. Verify that the Transmitter is functioning – the thermal image must be shown on the display of the receiver station or monitor. • The Transmitter is now ready for use The system is now ready for operation NOTE: If the EVOLUTION 5000 TIC is switched to standby mode, the Transmitter will continue to transmit a video signal. Turning the camera completely OFF will automatically switch OFF the Transmitter. Channel Selection Button The green channel selection button offers the ability to change the transmitting frequency. Pushing the button for about one second will change from channel 1 to channel 2 or vice-versa. It is also possible to switch OFF the Transmitter seperately. To turn the Transmitter OFF, press and hold the channel selection button [green] in for four seconds. • To avoid inadvertent switching of the channels Channel LED [green] changes or shutdown, the green button One lit LED indicates channel 1 is selected. must be held for four seconds to turn OFF Two lit LEDs indicate channel 2 is selected. the Transmitter. When the wireless video tansmission system is • When all LED indicators shut OFF the user turned OFF, all LED´s are darkened. may release the green button • The Transmitter is now OFF Battery Information Rechargable Batteries The EVOLUTION 5000 Transmitter runs on one Lithium Ion battery. Although this is the same type battery used in the EVOLUTION 5000 TIC the Transmitter is powered seperately Battery Installation and Care Install the battery as described in point 3 "getting started"]. To turn the Transmitter ON again push the channel selection button and hold it for approximately one second. The Transmitter will restart on the same Battery Maintenance After each use, inspect: • battery contacts for damage channel in which it was switched off. User interface-indicators and warnings Normal battery shown. Battery LED / System Status A lit battery and channel LED indicates that the Transmitter is on and fully operational. • Green indicates full or nearly full battery. • Yellow indicates marginal battery capacity. • Red indicates battery warning and nominally 15 minutes of battery capacity remaining. • Flashing Red indicates battery shutdown is imminent [about one minute of warning time]. • batteries for damage or leakage Maintenance and Adjustments General Maintenance After each use, inspect • the Transmitter for structural, heat and / or chemical damage. • the mechanical hardware to ensure no screws are loose and no O-rings or gaskets are loose or misplaced. Image indicates no damage. Stand Alone Battery Charger • to ensure that all warning labels are intact. • battery - see "Battery Care and Installation" • charger and Transmitter LED´s for proper indication that the system is operating The battery charger [sold seperately] is the same that properly. is used with the EVOLUTION 5000 TIC or is available as accessory [see ordering information]. Please NOTE: Transmitter not meeting the above inspection must be removed from service and consult your EVOLUTION 5000 TIC users manual for returned for repair. battery charging instructions. The battery must be removed from the Transmitter prior to charging. Truck Charger Cleaning When the Transmitter is attached to the EVOLUTION After each use, clean all external surfaces by wiping 5000 TIC, the combined unit cannot be used with the with a solution of mild detergent and warm water. EVOLUTION 5000 Truck Charger or Truck Bracket. Dry with a lint-free cloth, to avoid scratching the The Transmitter must be completely detached from surfaces. the TIC before inserting the TIC into the Truck Charger or Truck Bracket. The Transmitter battery cannot be charged while inside the Transmitter. Periodically check connector terminals, video socket, channel switch, locking latch and hinge for contamination. Clean with a lint-free cloth. CAUTION Although the EVOLUTION 5000 TIC and CAUTION EVOLUTION 5000 Transmitter use the same type of battery, each component is powered seperately. The Transmitter battery does not provide power to the TIC and the TIC battery does not provide power to the Transmitter. Battery indicators Do not use solvents or paint thinners to clean the Transmitter; otherwise, the protective case may become degraded. are independent for each device. WARNING Do not remove the Transmitter cover or electrical casing. Only authorized personnel may service the unit. Troubleshooting Guidelines Symptom Possible Solution Check cable connection to SMA video outlet of the TIC. Is the cable threaded correctly ?. No LED´s lit MSA Warranty Check power connections. Is power available ? Is a battery inside the camera and is the EVOLUTION 5000 TIC turned ON ? Is a battery inside the Transmitter ? Are the batteries fully charged ? THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED, IMPLIED OR STATUTORY, AND IS STRICTLY LIMITED TO THE TERMS HEREOF: SELLER SPECIFICALLY DISCLAIMS ANY WARRANTY OF MERCHANTIBILITY OR OF FITNESS FOR A PARTICULAR PURPOSE: Push the channel switch for approximately one second. Service If your EVOLUTION 5000 Transmitter is in need of service or repair, please contact the MSA Service Exclusive remedy - It is expressly agreed that purchaser´s sole and exclusive remedy for breach of the above warranty, for any tortious conduct of seller, or for any other cause of action, shall be the repair and / or replacement at the seller´s option, of any equipment or parts thereof, which after eamination by seller is proven to be defective. Replacement equipment and / or parts will be provided at no cost to purchaser, F.O.B. seller´s plant. Failure of seller to successfully repair any nonconforming product shall not cause the remedy established hereby to fail of its essential purpose. Exclusion of Consequential Damage Purchaser specifically understands and agrees that under no circumstances will seller be liable to purchaser for economic, special, incidental or consequential damages or losses of any kind whatsoever, including but not limited to, loss of anticipated profits and any other loss caused by reason of nonoperation of the goods. This exclusion is applicable to claims for breach of warranty, tortious conduct or any other cause of action against seller. Describe the Problem to the representative as completely as possible. 1. Verify with your representative that the product should be returned to MSA. 2. Before returning the product, decontaminate and clean your Transmitter to remove any hazardous materials that may have settled on the product during use. 3. Laws and / or shipping regulations prohibit the shipment of hazardous or contaminated materials. 4. Products suspected of contamination will be professionally decontaminated at the customer´s expense before servicing. 5. Ship returned products [including those under warranty] with pre-paid transportation charges; MSA cannot accept returned goods on a freightcollect basis. Warranty - seller warrants that this product will be free from mechanical defect or faulty workmanship for a period of one [1] year from date of purchase, provided it is maintained and used in accordance with seller´s instructions and / or recommendations. The seller shall be released from all obligations under this warranty in the event repairs or modifications are made by persons other than its own or authorized service personnel or if the warranty claim results from physical abuse or misuse of the product. No agent, employee or representative of the seller has any authority to bind the seller to any affirmation, representation or warranty concerning the goods sold under this contract. Inspect battery contacts for dirt, corrosion or damage. If necessary clean or replace battery. Center at 1-877-MSA-FIRE. Warranty and Service MSA Factory Repair & Service Policy Card To help process your repair requests, please provide the following information: Please complete this form in full. Thank you. Customer´s billing address: Customer´s shipping address: Company Name Company Name Street / P.O. Box Street / P.O. Box City / State / Zip City / State / Zip Contact name Phone number Product name Fax number Model number Your PO number To save time - please check ONE of these alternatives: Description of problem / special instructions: Repair and return [PO number must be provided Estimate required before return Warranty claim [original MSA invoice no._____________________________] Medical RA no._____________________________ Authorized by: Title: Date: FOR CALIBRATION OR REPAIR; PLEASE PROVIDE THE INFORMATION REQUESTED ABOVE: PLEASE USE A SEPERATE SHEET FOR EACH EQUIPMENT / UNIT. 10 7 Ordering Information Part number Description 10046340 EVOLUTION 5000 Transmitter 10041100 Charger, 110 / 220 VAC with cigarette lighter adapter 10038412 Lithium Ion battery 10046342 Replacement Strap 10048454 "Operation and Instructions" Manual 10048134 Receiver station w/ LCD-monitor 10048135 Receiver station w/o LCD-monitor 11 Manufactured by MINE SAFETY APPLIANCES COMPANY P I T T S B U R G H ; P E N N S Y L V A N I A ; U . S . A . 1 5 2 3 0
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Create Date : 2003:12:18 09:13:10+01:00 Modify Date : 2003:12:18 09:13:10+01:00 Page Count : 13 Creation Date : 2003:12:18 08:13:10Z Mod Date : 2003:12:18 08:13:10Z Producer : Acrobat Distiller 5.0.5 (Windows) Author : SalzmannPMS Metadata Date : 2003:12:18 08:13:10Z Creator : SalzmannPMS Title : Microsoft Word - 10048454 E5K VTS Instructions for Use 19th Nov 2003 FINAL .EXIF Metadata provided by EXIF.tools