Monoprice MP34710 SOUNDBAR User Manual FS68C SB 100
Monoprice, Inc. SOUNDBAR FS68C SB 100
User Manual
User’s Manual
SB-100
Accessories
1
2
Personal.
3
4
6
7
8
9
1.DISPLAY
2.OPTICAL
3.COAXIAL
4.AUX
2
1
3
4
10
LUM RESET
-10 +10
PAIR INPUT
TREBLE- TREBLE+
BASS- BASS+
MUSIC MOVIE
NEWS 3D
2
3
4
5
6
7
8
9
10
11
12
16
17
18
19
20
21
22
13
14
15
1
23
1.STANDBY:Standby mode for power on/off.
2. PAIR: Connect or disconnect to the pairing device.
(Press the button more than 2 seconds)
3. LUM: Indicator on/off. (This button can not work under standby status)
4. Loop playback. (Only work under USB and mode.)
5. VOL+: Volume increase adiustment button.
6. Pre button: Previous track. (Only work under and BT mode.)
7. VOL-: Volume Downward Adiustment Button.
8. -10: Backwards ten songs. (Only work under USB) mode.
9. TREBLE-: Treble Decrease Button.
10. BASS-: Bass Decrease Button.
11. MUSIC: Select the MUSIC EQ effect.
12. NEWS: Select the MUSIC EQ effect.
13. MUTE mode.
14. INPUT: AUX/USB/BT/OPT/COA selecion
15. RESET: Reset all soundbar volume levels and switch EQ
back to Music setting. Press and hold button for 2 seconds
16. Stop button: Press to stop. (Only work under USB mode.)
17. Next button: Next track. (Only work under USB and BT mode.)
18. +10: Forwards ten songs. (Only work under USB mode.)
19. TREBLE+: Treble lncrease Button.
20. BOSS+: Bass lncrease Button.
21. MOVIE: Select the MOVIE EQ effect.
22. 3D: Select the 3D EQ effect.
23.Play/Pause (Only work under USB and BT mode.)
11
12
T
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. such modifications could void the
user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
This equipment complies with FCC’s RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna(s) must not be co-located or
conjunction with any other antenna or transmitter.
1