Monterey 46AR09G USB Transceiver User Manual R09G

Monterey International Corporation USB Transceiver R09G

Users Manual

RF Transceiver Operation procedure   1. Insert two AAA batteries to the RF Keyboard, and close the battery door. 2. Plug in the Transceiver to the USB port of P.C. 3. Press the Connect button of RF Mouse for pairing with the Transceiver within 2 mins. 4. Access LED will go off and RF Mouse is ready. If Access LED is still Blinking, please repeat the above procedure 1 to 3 again.
Federal Communication Commission Interference Statement  THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.  Notice: (1) A Unshielded-type power cord is required in order to meet FCC emission limits and also to prevent   interference to the nearby radio and television reception. It is essential that only the supplied power   cord by used. (2) Use only shielded cables to connect I/O devices to this equipment. (3) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Navigation menu