Motorola Mobility T6EM1 In-Vehicle Bluetooth Module User Manual Exh D1 TCU1P03 m1202d user manual
Motorola Mobility LLC In-Vehicle Bluetooth Module Exh D1 TCU1P03 m1202d user manual
Exhibit D Users Manual per 2 1033 b3
MOTOROLA INC FCC ID: IHDT6EM1
MOTOROLA BLUETOOTH MODULE TCU1P03_m1202d USER MANUAL
[Models EVUVRB41U3 and EVGRB41E3]
1. GENERAL:
The Bluetooth Module TCU1P03_m1202d facilitates a wireless Bluetooth
interface between a wireless handset and other Bluetooth-enabled devices. The Bluetooth
Module TCU1P03_m1202d is assembled internally to a Motorola Telematics Control
Unit, which is a finished product supplied to the automotive market. The Bluetooth
Module TCU1P03_m1202d should be considered a module.
2. ANTENNA AND MODULE INSTALLATION:
The module utilizes an external antenna through a pc board mounted connector
that is unique to this application. The external antenna used in this application is a BMW
supplied antenna, BMW part number 6 928 461. The unit is designed for installation
within the Telematics Control Unit and located in an automobile, usually in the trunk
area. The device is mounted within a metal housing. Due to the low power at which the
unit transmits (0.0014 W max.), placement from an SAR perspective is not critical.
No end-user installation is involved of the Bluetooth module and is only
performed by Motorola or approved contractor. Any unauthorized changes or
modifications not expressly approved by Motorola could void the user’s authority to
operate this equipment.
3. I/O CONNECTION:
A board mounted 48-pin female connector is utilized to provide power and
vehicle bus communications to the module. This connector will only mate with a
corresponding connector in the Telematics Control Unit..
4. SPECIFICATIONS:
• Frequency range: 2402 MHz – 2480 MHz
• Operating current: 1.5A nominal
• Operating voltage: 13.2V nominal
• Operating temp. range: -30°C to +70°C
• Storage temp. range: -40°C to +85°C
• Output power: 0.0014 W max
5. Other
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.