Motorola Solutions 89FT5796 Data-only integrated transciever User Manual iOFCC8

Instruction Manual

Applicant: Motorola Inc FCC ID: AZ489FT5796

IDEN, Motorola Inc., 8000 Sunrise Blvd., Plantation, FL 33322, USA WWW.MOT.COM/iDEN Page: 8-1

Exhibit 8:

No user instruction manual is provided since the modem will be marketed as an Original Equipment

Manufacturer (OEM) transceiver module to be embedded in a variety of end products, as described in 47 CFR

2.1091(d)(4). It is supplied neither with battery nor antenna, only with an antenna connector. The

characteristics of having an antenna connector and no antenna are like those of transmitters classified as a

mobile device, as defined in 47 CFR 2.1091(b), rather than a handheld portable device as defined in 47 CFR

2.1093(b).

The type of antenna utilized with this OEM transceiver module, be it interior or exterior to the end product, is

not at the discretion of this applicant. Given the 0.7 Watt output power of this transceiver module, and the

manufacturer’s discretion for selecting an antenna, it is possible that in use the ERP of this module could

exceed the ERP limit in 47 CFR 2.1091(c) for exemption from routine environmental review. Thus, this

module was environmentally evaluated for RF Exposure as a mobile device, and was found to be compliant

with the MPE General Population limits for a mobile device in Table 1(B) of 47 CFR 2.1310 as required by 47

CFR 2.1091(c).

Since the end product may, in some cases, be used within a digital device such as a laptop computer to be

marketed in the United States, it is our expectation that the end product may bear a separate FCC identifier in

accordance with 47 CFR 2.925(b)(1). It will be the responsibility of the OEM to conduct appropriate RF

exposure evaluations, develop user manual information and obtain FCC equipment authorization for the end

product manual information needed to gain Authorization. It is our intention to provide the OEM party with a

letter notifying them of the need to comply with 47 CFR part 2 subpart J, et. al., once a purchasing agreement

has been reached