Motorola Solutions 89FT5811 iDEN iM1100 Wireless Modem User Manual IM1100 FCC insert

Motorola Solutions, Inc. iDEN iM1100 Wireless Modem IM1100 FCC insert

Contents

Addendum to Users Manual

This revision contains changes that have occurred since the printing of your
iM1100 User’s Guide. This information supersedes the corresponding
information in the Safety section of your manual.
THIS RADIO PRODUCT MEETS THE GOVERNMENT’S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your wireless radio product is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy
set by the Federal Communications Commission of the U.S. Government. These limits are
part of comprehensive guidelines and establish permitted levels of RF energy for the general
population. The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all persons,
regardless of age and health.
The exposure standard for wireless mobile devices employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.*Tests for
SAR are conducted using standard operating positions reviewed by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level of the device
while operating can be well below the maximum value. This is because the radio device is
designed to operate at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna, the lower the power
output.
Before a radio product is available for sale to the public, it must be tested and certified to the
FCC that is does not exceed the limit established by the government-adopted requirement for
safe exposure. The tests are performed in positions and locations as required by the FCC for
each model. The highest SAR value for this radio product when tested for use during packet
data transmission is 0.55 W/kg.
The FCC has granted an Equipment Authorization for this model wireless modem with all
reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR
information on this model wireless modem is on file with the FCC and can be found under the
Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID
AZ489FT5811.
Additional information on Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications Industry Association (CTIA) web-site at http://www.wow-com.com.
*In the United States and Canada, the SAR limit for wireless modems used by the public is
1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial
margin of safety to give additional protection for the public and to account for any variations
in measurements.
Manual Revision
iM1100 User Guide
Operation
To maintain FCC RF exposure compliance, position the antenna and the
radio product at least one inch (2.5 cm) from any part of the body of the
user or bystanders when using the supplied antenna. When using any
approved accessory antenna, position it at least eight inches (20 cm) from
any part of any person.
MOTOROLA, the Stylized M Logo, and
all other trademarks indicated as such
herein are trademarks of Motorola, Inc.
Reg. U.S. Pat. & Tm. Off. ©2002
Motorola
All other product or service names are the
property of their respective owners.
Printed in U.S.A. All Rights Reserved.
NNTN4319A
@NNTN4319A@

Navigation menu