Motorola Solutions 92FT7000 User Manual FCC Certification Report for the

Motorola Solutions, Inc. FCC Certification Report for the

Exhibit 8 Instruction Manual HDT401

Applicant: Motorola, Inc. FCC ID:AZ492FT7000Exhibit 8VIII. Instruction Manual1.) Quick Reference Card HDT 400 Series2.) Safety Warnings - Handheld Data Terminal, HDT FamilySafe and Efficient Operation of Motorola Two Way Radio Products
Battery Charge LED(see figure below)• No light - Not in use• Red light - Battery charging (8 hours for fullcapacity)• Green light - Battery fully chargedImportant NoteBattery is considered damaged when charging takesmore than 8 hours. Contact service to replace battery.Data Communication With Host(see figure above)Communication between the HDT 401 and the hostcomputer can be established when the HDT 401 restsin the Office Dock. When data flows from theHDT 401 to the host computer, the Data Out yellowLED lights.When data flows from the host computer to theHDT 401, the Data In yellow LED lights.Approved Accessories• FNN6001B: Battery – Lithium Ion 3.6V1450mAH.• FLN9202A: Belt Holster – full size with pocket.• FLN9623A: Belt Holster – slipper.• FLN9438A: Stylus pen.• FKN4886A: Serial cable (1m) standard EIARS232 DB9.• FKN4871A: Serial cable (1m) coiled for Cameroprinter DIN8.• FKN4792A: Serial cable (20cm) DB25 withnegative supply pin.• FKN4793A: Serial cable (1m) DB25 with powerpins.HDT 401Hand-held Data Terminalwith Local Area Network Radio ModemAnd LASER Barcode ScannerQuick Reference CardSwitching OnPress the Power On/Off button for more than 2seconds. The Power Indication Light will illuminate,indicating that the battery is O.K. and the device isoperative.Switching OffPress the Power On/Off button for more than 2seconds and release. The Power Indication Light willturn off.HDT 401 HolsterOffice DockPower On/OffButtonKeypad ScreenBuzzerBattery Pack(Do not remove)Indication LightLaser ScannerInfraredcommunicationAperture!C a u t i o nCAUTIONTo avoid possible eye injury, do not staredirectly at the laser beam of the scanner.Important Care Instructions: Use a soft damp cloth to clean theinfrared communication aperture and laser window.
Front PanelThe HDT 401 Keys are assigned to operate accordingto the specific usage of the device. However, theitems shown below refer to basic operations availablein all HDT 401 configurations.Setting the Office DockLocal Computer ControlA local computer configuration enables a cascadeconnection of up to 31 Office Dock units (155HDT 401 devices) to one RS-485 port in the hostcomputer. For connections, see figure below.Remote Computer ControlA remote computer control configuration enables acascade connection of up to 3 Office Dock units (15HDT 401 devices) to the host computer. A LineModem is used for communication with remotelocated host computer. For connections, see figurebelow.and Motorola are registered trademarks of Motorola Inc.©Motorola Inc., 2000 68P02959C84-A@6802959C84@ ToPhoneLineJ2J1AC Power OutletLine Modem(28.8 or 33.6kb/s)J1RS-232To Third Office Dock UnitJ2To more Office Dock UnitsJ3J4Host ComputerRS-485cables J3J4RS-485 to RS-232 ConverterNavigation KeysScreen Light(When pressed withShift key, contrastlevel increasescyclically).IMPORTANT: Tosave battery power,use Screen Lightonly when needed.Barcode ScannerKeys (for left-handand right-hand users)ScreenIndication Light(Operation is definedby configuration)Shift KeySpace Key(Operation is definedby configuration)
68P02960C25-O Safety WarningsPlease retain for future use Safe and Efficient Operationof Motorola Two Way Radio Products RF OPERATIONAL CHARACTERISTICS Your radio contains a transmitter which transmits using very short bursts of data;a receiver which receives radio frequency (RF); and an internal antenna. EXPOSURE TO RADIO FREQUENCY ENERGY Your Motorola radio product is designed to comply with the following national and international standards and guidelines regarding exposure of human be-ings to radio frequency electromagnetic energy: • United States Federal Communications Commission, Code of Federal Regulations; 47 CFR part 2 sub-part J • American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers (IEEE) C 95. 1-1992• Institute of Electrical and Electronic Engineers (IEEE), C95.1-1999 Edition • National Council on Radiation Protection and Measurements (NCRP) of the United States, Report 86, 1986 • International Commission on Non-Ionizing Radiation Protection (ICNIRP (1998)• National Radiological Protection Board of the United Kingdom, (1995)• Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to Radiofrequency Electromagnetic Fields in the Frequency Range from 3 kHz to 300 GHz, 1999• Australian Communications Authority Radiocommunications (Electro-magnetic Radiation - Human Exposure) Standard 1999 (applicable to wireless phones only). To assure optimal radio product performance and to make sure human expo-sure to radio frequency electromagnetic energy is within the guidelines set forth in the above standards, always adhere to the following procedures: PORTABLE RADIO PRODUCT OPERATION & EME EXPOSURE BODY-WORN OPERATION To maintain compliance with FCC RF exposure guidelines, if you wear a radio product on your body when transmitting, always place the radio product in a Motorola supplied or approved clip, holder, holster, case, or body harness. Use of non-Motorola-approved accessories may exceed FCC RF exposure guidelines. If you do not use a body-worn accessory, and are not using the radio product held in the normal use position, ensure the radio product is at least one inch (2.5 cms) from your body when transmitting .APPROVED ACCESSORIES For a list of approved Motorola accessories, please contact the local autho-rized Motorola dealer. ELECTROMAGNETIC INTERFERENCE / COMPATIBILITY NOTE : Nearly every electronic device is susceptible to electromagnetic inter-ference (EMI) if inadequately shielded, designed or otherwise configured for electromagnetic compatibility FACILITIES To avoid electromagnetic interference and/or compatibility conflicts, turn off your radio product in any facility where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy .AIRCRAFT When instructed to do so, turn off your radio product when on board an air-craft. Any use of a radio product must be in accordance with airline regula-tions or airline crew instructions.HANDHELD DATATERMINALHDT Family EME Warnings A5 landscapeHTD400 Page 1 Wednesday, October 11, 2000 5:33 PM
MEDICAL DEVICESPacemakers The Health Industry Manufacturers Association recommends that a minimum separation of 6 inches (15 centimeters) be maintained between a handheld wireless radio product and a pacemaker.These recommendations are con-sistent with the independent research by, and recommendations of, Wireless Technology Research. Persons with pacemakers should: 1. ALWAYS keep the radio product more than six inches (15 centimeters) from their pacemaker when the radio product is turned ON . 2. Not to carry the radio product in the breast pocket.3. Use the radio product away from the pacemaker to minimize the poten-tial for interference.4. Turn the radio product OFF immediately if you have any reason to sus-pect that interference is taking place. Hearing Aids Some digital wireless radio products may interfere with some hearing aids. In the event of such interferences you may want to consult your hearing aid manufacturer to discuss alternatives. Other Medical Devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from RF energy.Your physician may be able to assist you in obtaining this information. Safety and General Use While Driving Check the laws and regulations on the use of radio products in the area where you drive. Always obey them.When using your radio product while driving, please: 1. Give full attention to driving and to the road.2. Use hands-free operation, if available.3. Pull off the road and park before making or answering a call if driving conditions so require. OPERATIONAL WARNINGSFOR VEHICLES WITH AIR BAG Do not place a radio prod uct in the area over an air bag or in the air bag deployment area. Air bags inflate with great force. If a portable radio product is placed in the air bag deployment area and the air bag inflates, the radio product may be propelled with great force and cause serious injury to occu-pants of the vehicle. POTENTIALLY EXPLOSIVE ATMOSPHERES Turn off your two way radio product prior to entering any area with a poten-tially explosive atmosphere, unless it is a radio product type especially qual-ified for use in such areas as “Intrinsically Safe” (for example, Factory Mutual, CSA, or UL Approved). Do not remove, install, or charge batteries in such areas. Sparks in a potentially explosive atmosphere can cause an explosion or fire resulting in bodily injury or even death. NOTE: The areas with potentially explosive atmospheres referred to above include fueling areas such as; below decks on boats, fuel or chemical transfer or storage facilities, areas where the air contains chemicals or particles such as grain, dust, or metal powders;and any other area where you would normally be advised to turn off your vehicle engine. Areas with potentially explosive atmospheres are often but not always posted. BLASTING CAPS AND AREAS To avoid possible interference with blasting operations, turn off your radio product when you are near electrical blasting caps, in a "blasting area", or in areas posted: "turn off two-way radio." Obey all signs and instructions.All batteries can cause property damage and/or bodily injury such as burns if a conductive material such as jewelry, keys, or beaded chains touch exposed terminals. The conductive material may complete an electrical circuit (short circuit) and become quite hot. Exercise care in handling any charged battery, particularly when placing it inside a pocket, purse, or other container with metal objects.!C a u t i o nOPERATIONAL CAUTIONSBATTERIES !W A R N I N G! EME Warnings A5 landscapeHTD400 Page 2 Wednesday, October 11, 2000 5:33 PM

Navigation menu