Murata Electronics North America HN1010 Data Transceiver User Manual 02 0114 HN1510

Murata Electronics North America Data Transceiver 02 0114 HN1510

Contents

Users Manual Revised 071402

FCC ID: HSW-HN1510Cirronet Inc. will place the following statement in the front of each user/installersmanual:Important Regulatory InformationCirronet Product FCCID: HSW-XXXXFill in FCC ID numberNote: This unit has been tested and found to comply with the limits for aclass A digital device, pursuant to part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmful interferencewhen the equipment is operated in a commercial environment. Thisequipment generates, uses, and can radiate radio frequency energy and,if not installed and used in accordance with the instruction manual, maycause harmful interference to radio communications. Operation of thisequipment in a residential area is likely to cause harmful interference inwhich case the user will be required to correct the interference at theirexpense.
FCC ID: HSW-HN1510In order to meet FCC s MPE requirements, Cirronet Corporation will add the followingstatements to the each users manual. It may be on the second page.Notice to users/installers using the 24 dBi parabolic dish antenna in conjunctionwith all Cirronet RF products. FCC rules limit the use of this antenna, when connected to Cirronet RF products forpoint-to-point applications only. It is the responsibility of the installer to ensure thatthe system is prohibited from being used in point-to-multipoint applications, omni-directional applications, and applications where there are multiple co-located intentionalradiators transmitting the same information. Any other mode of operation using thisantenna is forbidden.Information to user/installer regarding FCC s Maximum Permissible Exposure(MPE) limits.Notice to users/installers using the following fixed antennas, with Cirronet RFproducts:Andrews 24dBi parabolic dish,Andrews 18dBi parabolic dish,Cushcraft 15dBi Yagi,Mobile Mark 14dBi Corner Reflector,Mobile Mark 9dBi Corner ReflectorThe field strength radiated by any one of these antennas, when connected to CirronetRF products, may exceed FCC mandated RF exposure limits. FCC rules requireprofessional installation of these antennas in such a way that the general public will notbe closer than 2 m from the radiating aperture of any of these antennas. End users ofthese systems must also be informed that RF exposure limits may be exceeded ifpersonnel come closer than 2 m to the apertures of any of these antennas. Notice to users/installers using the following mobile antennas, with Cirronet RFproducts:Mobile Mark 12dBi omni-directional,Mobile Mark 9dBi omni-directional,MaxRad 5dBi whip,Cirronet Patch antenna,Ace 2dBi dipole,Mobile Mark 2dBi StubThe field strength radiated by any one of these antennas, when connected to CirronetRF products, may exceed FCC mandated RF exposure limits. FCC rules requireprofessional installation of these antennas in such a way that the general public will notbe closer than 20 cm from the radiating aperture of any of these antennas. End users ofthese systems must also be informed that RF exposure limits may be exceeded ifpersonnel come closer than 20 cm to the apertures of any of these antennas.

Navigation menu