Murata LB1FJ Communication Module User Manual LBWA1ZZ1CA Installation Manual

Murata Manufacturing Co., Ltd. Communication Module LBWA1ZZ1CA Installation Manual

Users manual

8
Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 15 March 2016
5. Notice
or
※When the product is small, as for these words mentioned above, the posting to a manual is possible.
Contains Transmitter Module FCC ID:VPYLB1FJ Contains FCC ID: VPYLB1FJ
This device complies with Part 15 of FCC Rules and Industry Canada’s licence-exempt RSSs. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout brouillage subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
●Please describe the following warning to the manual.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
For OEM integration only – device cannot be sold to general public.
Therefore we will ask OEM to include the following statements required
by FCC/IC on the product and in the Installation manual Notice.
Please describe the following warning on the final product which contains this module.
or Contains Transmitter Module IC :772C-LB1FJ Contains IC: 772C-LB1FJ
9
Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 15 March 2016
5. Notice
●When installing it in a mobile equipment.
Please describe the following warning to the manual.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non
contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition et d’exposition
aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement doit être installé et utilisé en gardant une
distance de 20 cm ou plus entre le radiateur et le corps humain.
10
Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 15 March 2016
5. Notice
●When installing it in a portable equipment.
<FCC>
If portable equipment use only BT/BLE.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules.
This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption rate (SAR).
In the case of conditions other than the above.
The available scientific evidence does not show that any health problems are associated with using low power wireless devices.
There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low
levels of radio frequency energy (RF)in the microwave range while being used. Whereas high levels of RF can produce health
effects (by heating tissue), exposure of low-level RF that does not produce heating effects causes no known adverse health
effects. Many studies of low-level RF exposures have not found any biological effects. Some studies have suggested that some
biological effects might occur, but such findings have not been confirmed by additional research. TYPE1FJ has been tested and
found to comply with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules.
This module needs to take a SAR test.
11
Copyright © Murata Manufacturing Co., Ltd. All rights reserved. 15 March 2016
5. Notice
Note)
Portable equipment : Equipment for which the spaces between human body and antenna are used within 20cm.
Mobile equipment : Equipment used at position in which the spaces between human body and antenna exceeded 20cm.
It is necessary to take a SAR test with your set mounting this module. (It is no need to take test for only BT/BLE on FCC.)
Class II permissive change application is necessary using the SAR report.
Please contact Murata.
Les connaissances scientifiques dont nous disposons n’ont mis en évidence aucun problèmede santé associé à l’usage des
appareils sans fil à faible puissance. Nous ne sommes cependant pas en mesure de prouver que ces appareils sans fil à faible
puissance sont entièrement sans danger. Les appareils sans fil à faible puissance émettent une énergie fréquence radioélectrique
(RF) très faible dans le spectre des micro-ondes lorsqu’ils sont utilisés. Alors qu’une dose élevée de RF peut avoir des effets sur
la santé (enchauffant les tissus), l’exposition à de faibles RF qui ne produisent pas de chaleur n’a pas de mauvais effets connus
sur la santé. De nombreuses études ont été menées sur les expositions aux RF faibles et n’ont découvert aucun effet biologique.
Certaines études ont suggéré qu’il pouvait y avoir certains effets biologiques, mais ces résultats n’ont pas été confirmés par des
recherches supplémentaires. TYPE1FJ a été testé et jugé conforme aux limites d’exposition aux rayonnements énoncées pour un
environnement noncontrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition et
d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC.
<IC>
This module needs to take a SAR test.

Navigation menu