Music Tribe Commercial MY Sdn Bhd ULM100M Wireless Microphone User Manual Unlock 13

MUSIC Group Services PH Corp Wireless Microphone Unlock 13

User Manual

ULTRALINK ULM100USB
High-Performance 2.4 GHz Digital Wireless
Microphone with USB Receiver
ULM100USB Hook-Up
XENYX QX2442USB
B115MP3
Laptop
ULM100USB Controls
ULM100USB Controls
1. POWER/STATUS LED
2. W VOLUME Button (Mute/volume down)
3. V VOLUME Button (Power on/volume up)
4. USB connector
5. Wireless Link Status LED
ULM100USB Getting Started
1. Press the V button to power on the ULM100M
wirelessmicrophone.
2. Connect the ULM100R wireless receiver to the wireless
only USB connector on the wireless enabled device or to
a USB port on a computer. The ULM100M will sync to the
receiver automatically.
3. Use the W and V buttons on the ULM100M wireless
mic to adjust the volume.
4. Press and hold the W button to mute the volume of
theULM100M.
5. Press the V button to un-mute the volume of
theULM100M.
6. Disconnect the ULM100R wireless receiver. The ULM100M
wireless microphone will power o when no wireless
signal is detected for more than 1 minute.
Specication
RF output +17 dBm (50 mW)
Working range 120 m Maximum
(Lineof Sight)
Dynamic range > 67 dB
Frequency response 20 Hz – 14.7 kHz
(Wireless Link) (+0 / -0.3 dB)
THD+N (%) (Wireless Link) > 65 dB (0.03%)
Sampling rate 31.25 kHz
Audio coding Pulse-coded
modulation (PCM)
RF channel 2.4 GHz ISM Band
(2417 - 2471 MHz),
19Channels
Latency 9 ms
Power supply current 160 mA @ +2.7 VDC,
(Microphone) 140 mA @ +3.0 VDC
Power supply current 100 mA @ +5 VDC
(USB receiver)
Dimensions (W x D x H) 1.8 x 1.8 x 9.6"
45 x 45 x 245 mm
Weight 0.4 lbs / 0.2 kg
(1)
(2) (3)
(5)(4)
Model: ULM100R
Type of product: Wireless Microphone
Model: ULM100M
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
Responsible Party Name: MUSIC Group Services
US Inc.
Address: 18912 North Creek
Parkway,
Suite 200 Bothell,
WA98011, USA
Phone/Fax No.: Phone: +1 425 672 0816
Fax: +1 425 673 7647
ULTRALINK ULM100USB
complies with the FCC rules as mentioned in the
followingparagraph:
This equipment has been tested and found to comply with
the limits for a ClassB digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged
to try to correct the interference by one or more of the
followingmeasures:
t Reorient or relocate the receiving antenna
t Increase the separation between the equipment
andreceiver
t Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected
t Consult the dealer or an experienced radio/TV technician
forhelp
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesiredoperation.
Important information:
Changes or modications to the equipment not expressly
approved by MUSIC Group can void the user’s authority to use
the equipment.
Operation in the 2.4 GHz ISM (Industrial, Scientic, Medical)
frequency band may be subject to interference from other
transmitting equipment operating in this band. Inthe
event of such interference, please verify and reassign
the transmitting channels of any potentially interfering
transmittingequipment.
ULTRALINK ULM100USB
LEGAL DISCLAIMER
TECHNICAL SPECIFICATIONS AND APPEARANCES ARE
SUBJECT TO CHANGE WITHOUT NOTICE AND ACCURACY IS
NOT GUARANTEED. BEHRINGER, KLARKTEKNIK, MIDAS,
BUGERA, AND TURBOSOUND ARE PART OF THE MUSICGROUP
MUSICGROUP.COM. ALL TRADEMARKS ARE THE PROPERTY
OF THEIR RESPECTIVE OWNERS. MUSICGROUP ACCEPTS
NO LIABILITY FOR ANY LOSS WHICH MAY BE SUFFERED
BY ANY PERSON WHO RELIES EITHER WHOLLY OR IN PART
UPON ANY DESCRIPTION, PHOTOGRAPH OR STATEMENT
CONTAINED HEREIN. COLORS AND SPECIFICATIONS MAY
VARY FROM ACTUAL PRODUCT. MUSIC GROUP PRODUCTS
ARE SOLD THROUGH AUTHORIZED FULLFILLERS AND
RESELLERS ONLY. FULLFILLERSAND RESELLERS ARE NOT
AGENTS OF MUSICGROUP AND HAVE ABSOLUTELY NO
AUTHORITY TO BIND MUSICGROUP BY ANY EXPRESS OR
IMPLIED UNDERTAKING OR REPRESENTATION. THISMANUAL
IS COPYRIGHTED. NO PART OF THIS MANUAL MAY BE
REPRODUCED OR TRANSMITTED IN ANY FORM OR BY
ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING
PHOTOCOPYING AND RECORDING OF ANY KIND, FOR ANY
PURPOSE, WITHOUT THE EXPRESS WRITTEN PERMISSION OF
MUSICGROUPIPLTD.
ALL RIGHTS RESERVED.
© 2013 MUSICGroupIPLtd.
Trident Chambers, Wickhams Cay, P.O. Box 146,
Road Town, Tortola, British Virgin Islands
LIMITED WARRANTY
For the applicable warranty terms and conditions
and additional information regarding MUSIC Group’s
Limited Warranty, please see complete details online at
www.music-group.com/warranty.
For USB Receiver:
This equipment meets the government's requirements for
exposure to radio waves. .
For body worn operation, this equipment has been tested and
meets the FCC RF exposure guidelines.
The highest SAR value for this USB Receiver as reported to the
FCC when tested for use at the Body-worn is 0.071 W/kg.
This equipment complies with the European Council
Recommendation of 12 July 1999 on the Limitation of
Exposure of the General Public to Electromagnetic Fields
[1999/519/EC].
For Microphone:
This equipment should be installed and operated with a
minimum distance of 15mm between the radiator and your
head.

Navigation menu