Musical Electronics 3300281T Wireless Stereo Headphones User Manual
Musical Electronics Ltd Wireless Stereo Headphones
User Manual
Start Here Quick Start 3300281 ® See the User’s Guide for complete instructions. Install 3 AAA batteries T H E PERF O R M A NCE YOU NE ED ® AA Package Contents AA AA Wireless Stereo Headphones ALK/RCH Set to ALK for alkaline batteries Set to RCH for rechargeable batteries User’s Guide AC Adapter Headphones Transmitter RCA Cable /8” (3.5mm) Phono Adapter Quick Start ¼” (6.3mm) Adapter Connect transmitter to audio source Use your headphones MULT I JOG ENTE R FM UNBA L 75 Ω AM LOOP RO NT A UDI O ANTENNA Audio Out FM AM TUNING ST AT IO N MP X VS B MODE DIALOGU E ENHANCEMENT MAST ER VO LU ME A-B -or- ¹/8” Headphone Jack DOWN -or- UP ¼” Headphone Jack Turn on © 2013. Ignition L.P. All rights reserved. Auvio is a registered trademark used by Ignition L.P. Package and user documentation are recyclable. User documentation contains recycled material. 3300281F_QS_EN.indd 1 Turn on Volume Printed in China 04F13 3300281 4/3/2013 10:41:49 AM T H E PERFORMANCE YOU NE ED ® Wireless Stereo Headphones Transmitter Charging Connectors 3-foot (91.4cm) RCA Cable 1/4“ (6.3mm) Adapter Power LED Lights when the headphones are turned on. Quick Start Features Completely wireless, with a 150-foot (45.72m) range Please read this user’s guide before using your new headphones. for use virtually anywhere in your home Padded earcups and adjustable headband for comfort Power On/Off Volume 3300281 Connect Transmitter 1. Connect the transmitter to your audio source using the included RCA cable, matching the colors to your output jacks. If needed, use the included ¹/8“ or 1/4“ adapters. Back View of Transmitter Front View of Transmitter 2. Connect the AC adapter to the transmitter and plug into a standard power outlet. ¹/8” Stereo Headphone Jack -or- 3300281F_UG_EN.indd 1-5 -or- ¼” Stereo Headphone Jack charging performance use ONLY NiMH batteries. 1. Insert three AAA alkaline or rechargeable batteries (neither included), matching the polarity symbols (+ and –) marked inside. On/Off Turn the transmitter on or off. AUDIO IN L/R DC 12V Power LED Lights red when the transmitter is turned on. Blinks blue when charging. Lights blue when charged. Charge Rechargeable Batteries (Optional) 1. Turn off the headphones. 2. Make sure rechargeable batteries are installed and ALK/RCH is set to RCH. 3. Dock your headphones on the transmitter in the direction as shown. Make sure the LED on the transmitter blinks blue. 2. Switch ALK/RCH to ALK for alkaline or RCH for rechargeable batteries. Charging Connectors ALK/RCH alkaline batteries with the ALK/RCH switch set to RCH. Alkaline batteries can get hot or explode if you try to recharge them. Engineered to reduce interference and disruptive noise Audio Out n Note: When using rechargeable batteries, for best w Warning: Never install Transmitter also charges the headphones when rechargeable batteries are used User’s Guide Install Batteries AA Stereo Headphones AC Adapter 1/8“ (3.5mm) Phono Adapter User’s Guide Adjustable Headband AA Package Contents AA ® Battery Notes: Dispose of old batteries promptly and properly. Do not burn or bury them. Use only fresh batteries of the required size and recommended type. Do not mix old and new batteries of different sizes or types. If you do not plan to use the headphones for an extended time, remove the batteries. Batteries can leak chemicals that can damage electronic parts. When the power LED on the headphones blinks, replace your alkaline batteries or charge the rechargeable batteries. Charging Connectors Line up triangle icons. Power LED Blinks blue when charging. Lights blue when charged. n Note: Charge for at least 20 hours when using new rechargeable batteries for the first time. Recycle Rechargeable Batteries Recycle your old rechargeable batteries at one of the many collection sites in the U.S. and Canada. To find the site nearest you, visit www.call2recycle.org or call 1-800-822-8837. 4/3/2013 10:31:11 AM Use Your Headphones Select a location which provides the best performance. 1. Press 1to turn on the transmitter. The power LED lights red. 2. Slide Power On/Off to On to turn on the headphones. The power LED lights blue. 3. Set the headphone volume to minimum. 4. Turn on the audio source, and gradually increase the volume to a comfortable level. nNote: Place your transmitter away from strong light; avoid pointing it at a window where sunlight might prevent optimum reception. Remove objects between the transmitter and headphones. To preserve battery life, be sure to turn off the headphones when you are not using them. wCAUTION: Do not connect the transmitter to a speaker output. Doing so could damage the transmitter or the audio source. Listening Safely Set the headphone volume to the lowest setting before listening. After you begin listening, adjust the volume to a comfortable level. Do not listen at extremely high volume levels. Extended highvolume listening can lead to permanent hearing loss. 3300281F_UG_EN.indd 6-10 If you connect the transmitter to an audio source headphone jack, set the audio source’s volume to the middle position. Then adjust VOLUME on the headphones to the desired level. Turn off the headphones before turning off the transmitter. This prevents you hearing a loud click that may be generated when you turn off the transmitter. Specifications Transmitter: Carrier Frequency .......................................911.4 and 915.6 MHz Power Source .................................12V DC, 200 mA AC Adapter Modulation Method .............................................FM Modulation Receiver: Sensitivity................................................. <2µV (with 20 dB S/N) S/N Ratio (@-50dBm)....................................... >60 dB (A weight) Audio Distortion . ................................................................. <2% Max. Audio Output ............................................................ 8 mW Channel Separation............................................................ >45dB Operation Distance..................................up to 150 feet (45.72m) Power Requirement.......3 AAA alkaline or rechargeable batteries ................................................................................(not included) Overall Frequency Response.....................................80Hz-20KHz installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Limited Warranty This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular Ignition L.P. warrants this product against defects in materials and workmanship under normal use by the original purchaser for one (1) year after the date of purchase. IGNITION L.P. MAKES NO OTHER EXPRESS WARRANTIES. This warranty does not cover: (a) damage or failure caused by or attributable to abuse, misuse, failure to follow instructions, improper installation or maintenance, alteration, accident, Acts of God (such as floods or lightning), or excess voltage or current; (b) improper or incorrectly performed repairs by persons who are not a Ignition L.P. Authorized Service Facility; (c) consumables such as fuses or batteries; (d) ordinary wear and tear or cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs of product removal, installation, set-up service, adjustment or reinstallation; and (g) claims by persons other than the original purchaser. Should a problem occur that is covered by this warranty, take the product and the sales receipt as proof of purchase date to the place of purchase. Ignition L.P. will, at its option, unless otherwise provided by law: (a) repair the product without charge for parts and labor; (b) replace the product with the same or a comparable product; or (c) refund the purchase price. All replaced parts and products, and products on which a refund is made, Specifications are subject to change and improvement without notice. Actual product may vary from the product images in this document. FCC Information become the property of Ignition L.P. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period. IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON THE EXPIRATION OF THE STATED WARRANTY PERIOD. EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. You may contact Ignition L.P. at: Ignition L.P., 3102 Maple Ave., Suite 450, Dallas, TX 75201 02/09 For product support, call 1-866-315-0426 Complies with the European Union’s “Restriction of Hazardous Substances Directive,” which protects the environment by restricting specific hazardous materials and products. © 2013. Ignition L.P. All rights reserved. Auvio is a registered trademark used by Ignition L.P. Printed in China 04F13 3300281 10 4/3/2013 10:31:11 AM
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Create Date : 2013:05:23 17:30:15+08:00 Creator : Adobe InDesign CS4 (6.0) Modify Date : 2013:05:23 17:30:15+08:00 Title : Trapped : False Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Metadata Date : 2013:05:23 17:30:15+08:00 Creator Tool : Adobe InDesign CS4 (6.0) Format : application/pdf Document ID : uuid:fcd5a16f-31f7-4b34-aca1-bae13ff46dc2 Instance ID : uuid:3495a48c-b01c-4004-9ca2-c515e2a32e4b Producer : Adobe PDF Library 9.0 Page Count : 3EXIF Metadata provided by EXIF.tools