Musical Electronics G-100 G-Go Portable Wireless Speaker User Manual G GO USER GUIDE
Musical Electronics Ltd G-Go Portable Wireless Speaker G GO USER GUIDE
User Manual
1
MODEL :G-GO
USER’S Guide
2
Contents
A. Package contents
B. Important Safety Instructions
C. Your G-GO
D. Power Up
E. Get Connected
F. Get Listening
G. USB Universal Charging
H. Trouble Shooting
I. Specifications
3
A. Package contents
Your G-Go comes with the items shown below.
l AC adaptor
l User’s guide and Quick start guide
B. Important Safety Instruction
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE
COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the presence
of uninsulated dangerous voltage within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying
the appliance.
NOTE:
Changes or Modifications not expressly approved by the party responsible
could void the user’s authority to operate this device.
CAUTION
RISK OF ELECTRIC SH
OCK
DO NOT OPEN
4
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection. Lightning and
power surges ARE NOT covered under warranty for this product.
Section 15.105 Information to the user.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
5
C. Your G-Go
Keys/Jacks
EQ
+
-
Power Button
Vol Up Botton
Vol Down Botton
EQ
Play Button
Forward Button
Reverse Button
Pair
Handle
USB
External Jack Door
DC IN
LINE IN
White LED Blue LED
OPEN
LOCK Door Lock
OPEN
LOCK Door Lock
Battery Door
6
LED status Indicator
LED Status Speaker Status
White Lit Steady Power On
Flashes Battery is low;
Pause music when playback
Blue Lit Steady Connected to Bluetooth device
Flashes Pair mode
Splash Proof
G-Go is splash proof, which is suitable for outdoor use.
D. Power Up
AC Connection or Battery installation
1. Insert the supplied AC adaptor (DC 9V 1.8A) to DC IN. Connect the other
end to a wall outlet. Or, For portable use, insert four “AA” size batteries in
the battery compartment
2. Press Power button and then white LED lit steady
Note: For portable use, white LED flashes when battery is low and need
replacing new batteries.
PRECAUTION WHEN USING BATTERIES
² Use only the size and type of batteries specified.
² Do not mix different types of batteries together (e.g. alkaline, rechargeable and
standard (carbon Zinc) or old batteries with fresh ones.
² Exhausted batteries must be removed to prevent any battery leakage.
² Dispose of batteries properly according to environmental regulations.
² Battery (battery pack or battery installed) shall not be exposed to excessive heat such
as sunshine, fire or the like.
7
E. Get connected
Wireless stream audio from any Bluetooth device (Phone, Computer, etc.)
via Bluetooth
1. Prepare your G-Go for pairing
i. Press Bluetooth button and blue LED flashes
ii. Blue LED flashes in pair mode
iii. Blue LED lit up steady when connected
Noted: Press and hold Bluetooth button for 3 seconds to disconnect the
Bluetooth connection. G-Go then go back to pair mode and blue LED flashes.
2. Prepare your phone or device for pairing
i. Turn on Bluetooth feature on your Bluetooth device
ii. Add or Search for “G-go”
iii. When “G-go” appears, select it.
iv. When pairing successful, ready to stream music.
3. Reconnection between your Bluetooth device and G-GO
Select “G-go” entry on the Bluetooth device to reconnect the recently linked
Bluetooth devices
Playback with other audio devices via Line In
Insert one end of the audio cable (not supplied) into the Line-out jack on your
external audio devices and the other end into Line in G-Go.
Noted: Audio content via Line In will override wireless audio via Bluetooth.
Go-Go go back to Bluetooth mode automatically when take out audio from
Line In.
F. Get Listening
Play/Pause
Press Play button to start playback and press again to pause playback. White
LED flashes when pause the music.
Volume Control
Increase or decrease the volume using + or – buttons. White LED flashes once
when volume pressed up/down. White LED lit steady when reach to maximum
or minimum volume.
8
EQ
There are 4 preset EQ settings. EQ1 = Flat, EQ2=Rock, EQ3=Pop, EQ4=Jazz.
Press EQ button to cycle through the following options: EQ1, EQ2, EQ3 and
EQ4. White LED flash 1, 2, 3 or 4 times when EQ button pressed to indicate if
on preset EQ1, 2, 3 or 4.
Note: Default setting is EQ1 (Flat).
Forward or Reverse
Press forward or reverse buttons to skip to the beginning of the
current/previous or next track.
G. USB Universal Charging
Charge any phones or any device with a USB jack
Noted: Charging current 1A
H. Trouble Shooting
Problem Solution
Hearing distortion Lower the volume on your G-Go and/or phone/device
Not loud enough Turn up the volume on your phone/device or your G-Go
Unable to pair with Bluetooth device Confirm your phone/device is Bluetooth compatible
I. SPECIFICATIONS
l Bluetooth Range 33ft (10m), Class 2
l Bluetooth profile supported A2DP
l Power 2 x 3.5W <10%THD
l Battery Life About 8 hours (varies by volume level and audio content)
l AC Adaptor 9V 1.8A
l Battery 4x”AA” size batteries (not supplied)
l Output current of USB charging jack: 5V 1A
l Water resistance level IPX4
Specifications are subject to change without notice.
For operating assistance, please contact customer service at (email address)
or (phone no.).
Life Lab International Limited
ELECTRI
C
SHOCK
DO NOT
OPEN