NEC of America 7N2P14 PCS GSM Phone with RFID User Manual RF Warning Page

NEC Corporation of America PCS GSM Phone with RFID Users Manual RF Warning Page

Contents

Users Manual RF Warning Page

Download: NEC of America 7N2P14 PCS GSM Phone with RFID User Manual RF Warning Page
Mirror Download [FCC.gov]NEC of America 7N2P14 PCS GSM Phone with RFID User Manual RF Warning Page
Document ID933424
Application IDAC1Sv7MS4YW9cKSpNWDtYw==
Document DescriptionUsers Manual RF Warning Page
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize7.26kB (90789 bits)
Date Submitted2008-04-25 00:00:00
Date Available2008-10-22 00:00:00
Creation Date2008-04-17 10:16:12
Producing SoftwareAcrobat Distiller 5.0.5 (Windows)
Document Lastmod2008-04-25 13:01:57
Document TitleUsers Manual RF Warning Page
Document CreatorPScript5.dll Version 5.2

ODN_FCC.book
1 ページ
2008年4月17日
木曜日
午後7時16分
Radio Frequency (RF) Signals
THIS MODEL PHONE MEETS THE U.S. GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO
WAVES.
Your wireless phone contains a radio transmitter and receiver. Your phone is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. The guidelines are based on standards that were
developed by independent scientific organizations through periodic and thorough evaluation of scientific
studies.
The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific
Absorption Rate (SAR). The SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the maximum value. This is because the
phone is designed to operate at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station antenna, the lower the output.
Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does
not exceed the limit established by the U.S. government-adopted requirement for safe exposure. The tests are
performed on position and locations (for example, at the ear and worn on the body) as required by FCC for
each model. The highest SAR value for this model phone as reported to the FCC when tested for use at the
ear is 0.946 W/kg, and when worn on the body, is 0.412 W/kg. (Body-worn measurements differ among phone
models, depending upon available accessories and FCC requirements). While there may be differences
between the SAR levels of various phones and at various positions, they all meet the U.S. government
requirement.
The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the
FCC and can be found under the Display Grant section at https://gullfoss2.fcc.gov/oetcf/eas/reports/
GenericSearch.cfm after search on FCC ID A98-7N2P14.
For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used
with an accessory designated for this product or when used with an accessory that contains no metal and that
positions the handset a minimum of 1.5 cm from the body.
* In the United States, the SAR limit for wireless mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over
one gram of tissue. SAR values may vary depending upon national reporting requirements and the network band.
ODN_FCC.book
2 ページ
2008年4月17日
木曜日
午後7時16分
FCC Regulations
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation; if this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract
XMP Toolkit                     : 3.1-702
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Create Date                     : 2008:04:17 10:16:12Z
Modify Date                     : 2008:04:25 13:01:57-04:00
Metadata Date                   : 2008:04:25 13:01:57-04:00
Creator Tool                    : PScript5.dll Version 5.2
Format                          : application/pdf
Creator                         : 
Title                           : 
Document ID                     : uuid:7f520ebb-94b0-423e-920d-a0ecdae31c03
Instance ID                     : uuid:52b7e369-0d5a-449a-a8d7-2085fdedbd5d
Has XFA                         : No
Page Count                      : 2
Page Layout                     : SinglePage
Author                          : 
EXIF Metadata provided by EXIF.tools
FCC ID Filing: A98-7N2P14

Navigation menu