NEC of America BKJ4142 Cellular/ PCS GSM and Cellular WCDMA Phone with WLAN, Bluetooth and RFID User Manual RF Warning Page
NEC Corporation of America Cellular/ PCS GSM and Cellular WCDMA Phone with WLAN, Bluetooth and RFID Users Manual RF Warning Page
Contents
- 1. Users Manual RF Warning Page
- 2. Users Manual
Users Manual RF Warning Page
HedloFreduaflWfiHSaneis THIS MODEL PHONE MEETS THE US. GOVERNMENTS REQUIREMENTS FOR EXPOSURE TO RADIO WAVES. Your Memes phone wntflns a radio trasrmter and receiver. Your phone Is designed and maruaclued not to exceed the erriesim Iinlts fame to ram frequency (RF) allergy set by the Fedaal Oornnurloaflons Canrnlssion of the U.S. Government. These limits are part of oorroret‘mslve guidelines all establish permuted IevflsotFlFHte‘gvltrmMmmz-mmfim guidelines as based on standards that were deveoped by independent scientific organizaticns through periodic and thorough evaluation of adenine snags The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Plate (SAFl). The SAR limit set by the FCC Is 1.6 W/kg.’ Tests for SAH are conducted using standard operating poslfions accepted by the FCC with the phone transmitting at Its highest certified power level in all tested frequency bands. Although the SAR ls determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value This Is bmause the phone ls designed to operate at multiple power levels so as to use only the power required to reach the network. In general. the closer you are to a wireless base station antenna. the lower the output Before a phone model ls available for sale to the public. it must be tested and certified to the FCC that It does not exceed the limit lltabllshed by the U.S. govemmentAadooted requirement for safe exposure. The tests are performed on position and locations (for example, at the oar and worn on the body) as required by FCC for each model. The highest SAR value for this model phone as reported to the FCC when tested for use at the ear Is 056 WIkg. and when mm on the body. ls 0.89 W/kg (Body-wom measurements differ among phone models. depending upon available accessories and FCC requirements). While there may be differences between the SAR levels of various phones and at various positions. they all meet the U5. govemment requirement. TmFCClBsgtantma'lEqunHltAudulzz-mm fu‘tfisrnmeiphmemmallrwu'mdsm levels evaluated as In compliance with the FCC RF exposure guidelines. SAR Inforrnatlon on this mmlsmfllelmmt‘heFCCa'ldmibe found under the Display Grant section at ht‘tps:/lguIlfpssa.fcc.gov/Detcf/ees/reports/ mam eflH search on FCC D A98- BKJ4142 For body worn operation. this phone has been tested and meets the FCC FlF exposure guidelines when used with an accessory designated for this product or when used wlth m emssory that contains no metal and that positions the handset a minimum of 1.0 cm from UH body. can . mm v HQ} AMEiflé’l Non—compliance with the above restrictions may result in violation of FCC FiF Exposure guidelines. ' In the United States, the EAR limit for Wireless moblle phones used by the public is i G watts/kg iW/kg) averaged over one gram of tissue. SAR values may vary depending upon national reporting requirements and the network band. Facilia'zflle’tlone This moplle phone complies with part 15 of the FCC Rules. Operation is Subject to the followmg two conditions: (i) This device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation. This mobile phone has been tested and found to comply with the limits for a Class 8 digital device. pursuant to Part 15 of the FCC Fiules. These limits are designed to provide reasonable protection against harmful intenerence in a residential installation. This equipment generates. uses and can radiate radio frequency energy and. If not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However. there is no guarantee that interference will not occur In a particular installation; if this equipment does cause harmful interference to radio or television reception. which can be determined by turning the equipment off and on, the user is encouraged to try to Correct the interference by one or more of the following measures: Reonent or relocate the receiving antenna. -increase the separation between the equipment and receiver . Connect the equipment into an outlet on a Circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/ TV technician for help. Changes or modifications not expressly approved by the party responsmle for compliance could void the user's authority to operate the equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V4.4 (128-bit) User Access : Print, Extract, Print high-res Create Date : 2012:01:04 13:44:22+09:00 Creator : 共用機tmpr28c Modify Date : 2012:01:06 11:06:29-05:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Creator Tool : 共用機tmpr28c Metadata Date : 2012:01:06 11:06:29-05:00 Producer : HyperGEAR PDFOCRLib Ver5.0.4 Date: 2009/04/12 Format : application/pdf Document ID : uuid:04cb514b-1840-417f-a994-683370974b21 Instance ID : uuid:0fb3f12d-6278-4fa0-bb61-fdaacf5f18fb Page Count : 2EXIF Metadata provided by EXIF.tools