NEC of America KMP6J1F1-1A Dual-Band GSM/GPRS Phone User Manual General Safety

Amendment RF Warning page

Radio Frequency (RF) Signals

THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

Your wireless phone contains a radio transmitter and receiver. Your NEC phone is designed and manufactured not to

exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of

the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the

general population. The guidelines are based on standards that were developed by independent scientific organizations

through periodic and thorough evaluation of scientific studies.

The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate

(SAR). The SAR limit set by the FCC is 1.6W/kg.* Tests for SAR are conducted using standard operating positions

accepted by the FCC with the phone transmitting at its highest certified power level in all tested frequency bands. Although

the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well

below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the

power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the output.

Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed

the limit established by the government-adopted requirement for safe exposure. The tests are performed on position and

locations (for example, at the ear and worn on the body) as required by FCC for each model. The highest SAR value for this

model phone as reported to the FCC when tested for use at the ear is (TBD)W/kg, and when worn on the body, is

(TBD)W/kg. (Body-worn measurements differ among phone models, depending upon available accessories and FCC

requirements). While there may be differences between the SAR levels of various phones and at various positions, they all

meet the government requirement.

Body-worn Operation

The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in

compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be

found under the Display Grant section at http://www.fcc.gov/oet/fcid after search on FCC ID A98-KM P6J 1F1-1A.

For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used with a NEC

accessory designated for this product or when used with an accessory that contains no metal and that positions the handset

a minimum of 1.5 cm from the body.

*In the United States, the SAR limit

for wireless mobile phones used by

the public is 1.6 watts/kg (W/kg)

averaged over one gram of tissue.

SAR values may vary depending upon

national reporting requirements and

the network band.