NEC of America MP6J1E1-1F Dual-Band GSM Phone User Manual 1

Download:
Mirror Download [FCC.gov]
Document ID	238396
Application ID	4KaeRSX5HBuVVEk1pI19RQ==
Document Description	Users Manual 1
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	176.88kB (2211000 bits)
Date Submitted	2002-04-23 00:00:00
Date Available	2002-06-14 00:00:00
Creation Date	2002-04-22 11:20:42
Producing Software	Acrobat 5.0 Scan Plug-in for Windows
Document Lastmod	2002-04-22 11:21:06
Document Title	Users Manual 1
Document Creator	Acrobat 5.0 Paper Capture Plug-in for Windows

Radio Frequency (RF) Signals
THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES
Your wireless phone contains a radio transmitter and receiver. Your NEC phone is
designed and manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive guidelines and establish permitted
levels of RF energy for the general population. The guidelines are based on standards
that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.*
Tests for SAR are conducted using standard operating positions accepted by the FCC
with the phone transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power level, the actual
SAR level of the phone while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output.
Before a phone model is available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed on positions and locations (for
example, at the ear and worn on the body) as required by the FCC for each model. The
highest SAR value for this model phone as reported to the FCC when tested for use at the
ear is 0.850 W/kg, and when worn on the body, as described in this user guide, is 0.296
W/kg. (Body-worn measurements differ among phone models, depending upon available
accessories and FCC requirements.) While there may be differences between the SAR
levels of various phones and at various positions, they all meet the government
requirement.
Body-worn Operation
This device was tested for typical body-worn operations with the back of the phone kept
1.5 cm. from the body. To maintain compliance with FCC RF exposure requirements,
use only belt-clips, holsters or similar accessories that maintain a 1.5 cm. separation
distance between the user’s body and the back of the phone, including the antenna,
whether extended or retracted. The use of third-party belt-clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of
accessories that do not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
*In the United States, the SAR limit for mobile phones used by the public is 1.6 watts/kg
(W/kg) averaged over one gram of tissue. SAR values may vary depending upon
national reporting requirements and the network band.
************************************************************************
Separate Section in another location of the manual:
ABOUT THE ANTENNA
Your phone has a built-in antenna. As with any other radio transmitting device, do not
touch the antenna unnecessarily when the phone is switched on.
Contact with the antenna affects call quality and may cause the phone to operate at a
higher power level than needed.
Not touching the antenna during a call optimizes the antenna performance and the talktime of your phone.
Use a pictogram to depict where the antenna is; use an “X” and illustrate where not to
touch the phone and how the phone should be held “normal position”


---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2002:04:22 11:21:06-03:00
Create Date                     : 2002:04:22 11:20:42-03:00
Creator                         : Acrobat 5.0 Paper Capture Plug-in for Windows
Producer                        : Acrobat 5.0 Scan Plug-in for Windows
Page Count                      : 33
Mod Date                        : 2002:04:22 11:21:06-03:00
Creation Date                   : 2002:04:22 11:20:42-03:00
Metadata Date                   : 2002:04:22 11:21:06-03:00
Has XFA                         : No

EXIF Metadata provided by EXIF.tools