NEC of America QLC5698 Cellular/ PCS GSM & Cellular WCDMA Phone with WLAN, Bluetooth and NFC User Manual RF Warning

NEC Corporation of America Cellular/ PCS GSM & Cellular WCDMA Phone with WLAN, Bluetooth and NFC Users Manual RF Warning

Contents

Users Manual RF Warning

Download: NEC of America QLC5698 Cellular/ PCS GSM & Cellular WCDMA Phone with WLAN, Bluetooth and NFC User Manual RF Warning
Mirror Download [FCC.gov]NEC of America QLC5698 Cellular/ PCS GSM & Cellular WCDMA Phone with WLAN, Bluetooth and NFC User Manual RF Warning
Document ID1568859
Application IDe6gzokLSvh/QtlkxWI6leQ==
Document DescriptionUsers Manual RF Warning
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize6.47kB (80835 bits)
Date Submitted2011-10-27 00:00:00
Date Available2012-04-24 00:00:00
Creation Date2017-11-03 14:39:11
Producing SoftwareGPL Ghostscript 9.18
Document Lastmod2017-11-03 14:39:11
Document TitleUsers Manual RF Warning

Radio Frequency (RF) Signals
THIS MODEL PHONE MEETS THE U.S.
GOVERNMENT'S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your wireless phone contains a radio transmitter
and receiver. Your phone is designed and
manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the
U.S. Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population. The
guidelines are based on standards that were
developed by independent scientific organizations
through periodic and thorough evaluation of
scientific studies.
The exposure standard for wireless mobile
phones employs a unit of measurement known
as the Specific Absorption Rate (SAR). The
SAR limit set by the FCC is 1.6 W/kg.* Tests
for SAR are conducted using standard
operating positions accepted by the FCC with
the phone transmitting at its highest certified
power level in all tested frequency bands.
Although the SAR is determined at the
highest certified power level, the actual SAR
level of the phone while operating can be well
below the maximum value. This is because the
phone is designed to operate at multiple
power levels so as to use only the power
required to reach the network. In general, the
closer you are to a wireless base station
antenna, the lower the output.
Before a phone model is available for sale to
the public, it must be tested and certified to
the FCC that it does not exceed the limit
established by the U.S. government-adopted
requirement for safe exposure. The tests are
performed on position and locations (for
example, at the ear and worn on the body) as
required by FCC for each model. The highest
SAR value for this model phone as reported
to the FCC when tested for use at the ear is
0.57 W/kg, and when worn on the body, is 0.79
W/kg. (Body-worn measurements differ among
phone models, depending upon available
accessories and FCC requirements). While
there may be differences between the SAR
levels of various phones and at various
positions, they all meet the U.S. government
requirement.
The FCC has granted an Equipment Authorization
for this model phone with all reported SAR levels
evaluated as in compliance with the FCC RF
exposure guidelines. SAR information on this
model phone is on file with the FCC and can be
found under the Display Grant section at
https://gullfoss2.fcc.gov/oetcf/eas/reports/
GenericSearch.cfm after search on FCC ID A98QLC5698.
For body worn operation, this phone has been
tested and meets the FCC RF exposure
guidelines when used with an accessory
designated for this product or when used with
an accessory that contains no metal and that
positions the handset a minimum of 1.0 cm
from the body.
Non-compliance with the above restrictions
may result in violation of FCC RF Exposure
guidelines.
---------------------------------------------------------------------------* In the United States, the SAR limit for
wireless mobile phones used by the public is
1.6 watts/kg (W/kg) averaged over one
gram of tissue. SAR values may vary
depending upon national reporting
requirements and the network band.
FCC Regulations
This mobile phone complies with part 15 of
the FCC Rules. Operation is subject to the
following two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference received,
including interference that may cause
undesired operation.
This mobile phone has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation; if this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Create Date                     : 2011:09:09 10:00:21+09:00
Modify Date                     : 2011:10:27 12:38:52-04:00
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Metadata Date                   : 2011:10:27 12:38:52-04:00
Format                          : application/pdf
Document ID                     : uuid:267ec8c4-8b4d-4851-a11a-96fb7f56cadf
Instance ID                     : uuid:a668847e-0910-4b02-bf6d-11b35ba5e8a5
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: A98-QLC5698

Navigation menu