NETIS SYSTEMS PL7622R 300Mbps AV600 Wireless Powerline Adapter User Manual PKUM05964 PL7622
NETIS SYSTEMS CO., LTD. 300Mbps AV600 Wireless Powerline Adapter PKUM05964 PL7622
User Manual
LAN
W
A
N
5 6
料号：PKUM05964
PKUM05964
品名：安装指南 netis PL7622 多国语种 V2 105*148mm 80g双胶黑白印刷 折叠
Appendix:
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
1. The equipment complies with RF exposure limits set forth for an
uncontrolled environment. The antenna(s) used for this transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment.
3. This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including
interference that may cause undesired operation