NIDEC MOBILITY G8C-930M ETACS User Manual User s Manual
OMRON Automotive Electronics Co. Ltd. ETACS User s Manual
User's Manual
5/22
2. User’s manual
Keyless Entry System
Press the remote control switch, and all doors and tailgate will be locked or unlocked
as desired.
To lock
Press the LOCK switch, and all doors and tailgate will be locked.
To unlock
Press the UNLOCK switch, and all doors and tailgate will be unlocked.
ڹNOTE
The indicator lamp comes on each time a switch is pressed.
If the UNLOCK switch is pressed and any of the doors or the tailgate is not opened within
approximately 30 seconds, relocking will automatically occur.
The keyless entry system does not operate in the following conditions:
xThe key is left in the key cylinder.
xThe doors or tailgate is open.
The remote control switch will operate within about few meters from the vehicle.
However, the operating range of the remote control switch may changeif the vehicle is
located near a power station, or radio/TV broadcasting station.
If either of the following problems occurs, the battery may be exhausted.
xThe remote control switch is operated at the correct distance from the vehicle,
but the doors and the tailgate are not locked/unlocked in responce.
xThe indicator lamp is dim or does not come on.
For further information, please consult your service point.
UNLOCK switch
LOCK switch
indicator lamp
6/22
Immobilizer System
The immobilizer system is designed to reduce significantly the possibility of vehicle theft.
The purpose of the system is to immobilize the vehicle if an invalid start attempt.
A valid start attempt can only be archeived by using a key “registerd” to the immobilizer
system.
ڹNOTE
In the following cases, the vehicle may not be able to receive the registerd ID code from
the registered key and the motor may not start.
xWhen the key contacts or is close to other metallic or magnetic object.
xWhen the key grip contact metal of another key.
xWhen the key contacts or is close to other immobilizing keys( including keys of
other vehicles).
In cases like these, remove the object or additional key from the vehicle key and turn the key
back to “ACC” or “LOCK” position. Then try again to start the motor.
ڹ
CAUTION
Don’t make any alternations or additions to the remote control switch and
immobilizer system; alternations or additions could cause failure of their.
7/22
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’ authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.