NIDEC MOBILITY G8D-333A-B Remote keyless receiver User Manual 1

OMRON Automotive Electronics Co. Ltd. Remote keyless receiver 1

Manual

2. User’s manual (provisionally) REMOTE TRANSMITTER You can lock and unlock your vehicle with the remote transmitter. LOCK When you push the LOCK button, all the doors will lock. You cannot lock any of the doors with the remote transmitter if any door is open or the key is in the ignition switch. UNLOCK When you push the UNLOCK button once, all the door s will unlock. If you unlock the doors with the remote transmitter, but do not open any of the doors within 30 seconds, the doors will automatically relock. You cannot unlock any of the doors with the remote transmitter if the key is in the ignition switch. PANIC Panic mode allows you to remotely sound’s horn to attention. To activate this mode, press the PANIC button. Your vehicle’s horn will beep for about 150 seconds. To cancel Panic mode before 150 seconds, press any button on the remote transmitter. SLIDE DOOR LEFT When you push the SILDE DOOR LEFT button. Open or close the left slide door. To activate this mode, press and hold the SLIDE DOOR LEFT button for about one second. SLIDE DOOR RIGHT When you push the SILDE DOOR RIGHT button. Open or close the right slide door. To activate this mode, press and hold the SLIDE DOOR RIGHT button for about one second. - 2 -
△! CAUTION The remote control switch is a precision electronic device. Therefore, pay attention to the following: ･ Do not impose shock on the remote control switch. ･ Keep the remote control switch dry. ･ Do not disassemble the remote control switch. Your keyless entry system operates on a radio frequency subject to Federal Communications Commission (FCC) rules and Industry Canada rules. This device complies with Part 15 of the FCC Rules. Operation is subject to the following tow conditions. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation of the device. “Complies with RSS-210 of Industry Canada.” NOTICE This equipment has been tested and found to comply with the limits for a Class B device, pursuant to part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications However there is no guarantee that interference will not occur in particular installation. If this equipment dose cause harmful interference to radio or radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. −Reorient or relocate the receiving antenna. −Increase the separation between the equipment and receiver. −Connect the equipment into an outlet on a circuit different from that to which the receiver is connected −Consult the dealer or an experienced radio/TV technician for help. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Navigation menu