NIDEC MOBILITY G8D-344H-B Automotive Security Receiver User Manual Discription
OMRON Automotive Electronics Co. Ltd. Automotive Security Receiver Discription
Manual
- 2 -
2. User’s manual (provisionally)
REMOTE TRANSMITTER
You can lock and unlock your vehicle with the remote transmitter.
LOCK
When you push the LOCK button, all the doors will lock.
You cannot lock any of the doors with the remote transmitter if any door is open or the key is in the
ignition switch.
UNLOCK
When you push the UNLOCK button ones , only the driver’s door unlocks. The remaining door unlock
when you push the button a second time. If you unlock the doors with the remote transmitter, but do not
open any of the doors within 30 seconds, the doors will automatically relock.
You cannot unlock any of the doors with the remote transmitter if the key is in the ignition switch.
BOOT
RELEASE
To open the boot, push the BOOT RELEASE button for approximately one second.
The boot will not open if the key is in the ignition switch.
PANIC
MODE
Panic mode allows you to remotely sound your vehicle’s horn to attract attention. To activate this mode,
press and hold the PANC button for about one second. Your vehicle’s horn will beep for about 30 seconds.
To cancel panic mode before 30 seconds, press any button on the remote transmitter. You can also turn
the ignition switch to ON.
Panic mode will not activate if the ignition switch is in ON.
△
! CAUTION
The remote control switch is a precision electronic device. Therefore, pay attention to the following:
･ Do not impose shock on the remote control switch.
･ Keep the remote control switch dry.
･ Do not disassemble the remote control switch.
Your keyless entry system operates on a radio frequency subject to Federal Communications
Commission (FCC) rules and Industry Canada rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following tow
conditions.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation of the device.
“Complies with RSS-210 of Industry Canada.”
NOTICE
This equipment has been tested and found to comply with the limits for a Class B device, pursuant to
part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction, may cause harmful interference to radio communications However
there is no guarantee that interference will not occur in particular installation. If this equipment dose
cause harmful interference to radio or radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures.
−Reorient or relocate the receiving antenna.
−Increase the separation between the equipment and receiver.
−Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
−Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.