NIDEC MOBILITY G8D-625M-A-HF FOB User Manual 1
OMRON Automotive Electronics Co. Ltd. FOB 1
User manual
2. User’s manual
Keyless Entry System
Press the remote control switch, and all doors and tailgate will be locked or unlocked as
desired.
PANIC switch
indicator lamp
UNLOCK switch
BOOT RELEASE switch*
LOCK switch
* OPTION
To lock
Press the LOCK switch, and all doors and tailgate will be locked.
To unlock
Press the UNLOCK switch, and all doors and tailgate will be unlocked.
To boot release
Press the BOOT RELEASE switch twice, and boot will be released.
PANIC MODE
When you press the PANIC switch, the vehicle starts sounding the horn and flashing the headlight
intermittently. These functions continue for 180 seconds unless any of the buttons on the transmitter are
pressed.
△ NOTE
The indicator lamp comes on each time a switch is pressed.
If the UNLOCK switch is pressed and any of the doors or the tailgate is not opened
within approximately 30 seconds, relocking will automatically occur.
The keyless entry system does not operate in the following conditions:
• The key is left in the key cylinder.
• The doors or tailgate is open.
The remote control switch will operate within about few meters from the vehicle.
However, the operating range of the remote control switch may change if the vehicle is
located near a power station, or radio/TV broadcasting station.
If either of the following problems occurs, the battery may be exhausted.
• The remote control switch is operated at the correct distance from the vehicle, but
the doors and the tailgate are not locked/unlocked in response.
• The indicator lamp is dim or does not come on.
For further information, please consult your service point.
-5-
-
Immobilizer System
The immobilizer system is designed to reduce significantly the possibility of vehicle theft.
The purpose of the system is to immobilize the vehicle if an invalid start attempt.
A valid start attempt can only be achieved by using a key “registered” to the immobilizer
system.
△ NOTE
In the following cases, the vehicle may not be able to receive the registered ID code from
the registered key and the motor may not start.
• When the key contacts or is close to other metallic or magnetic object.
• When the key grip contact metal of another key.
• When the key contacts or is close to other immobilizing keys( including
keys of
other vehicles).
In cases like these, remove the object or additional key from the vehicle key and turn the
key
back to “ACC” or “LOCK” position. Then try again to start the motor.
△ CAUTION
Don’t make any alternations or additions to the remote control switch
and immobilizer system; alternations or additions could cause failure of
their.
-6-
-
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’ authority to operate the equipment.
This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of this device.
-7-
-