NINGBO CSTAR IMP and EXP 0032 Bluetooth Cube Speaker With Rubber Band User Manual SL038 Speaker Manual 9 11 2

NINGBO CSTAR IMP&EXP; CO., LTD Bluetooth Cube Speaker With Rubber Band SL038 Speaker Manual 9 11 2

User Manual

1 LED 2 ON OFF 3 BT SPEAKER OFF ON 4 Product Specifications Model： Power Output：3W X 1 SNR: ≥70dB Frequency：20HZ-20KHz Input：DC5V/300mA Impedance：4Ω Battery : 300mAh 5 6 ON OFF 7 Using Bluetooth with the SL038Bluetooth Cube Speaker with Rubber Band SL038Slide the ON/OFF switch on the speaker to the ON position. Open your divce bluetooth mode“BT SPEAKER” should appear on your device. If “Not Connected” or similar message appears, select “BT SPEAKER”” to connect. Once paired, You can then stream audio to the speaker.CHARGE UNIT BEFORE USETo charge the battery connect the larger plug of the included USB charging cable to the powered USB port of USB/AC adapter.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequence energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not accor in a particular installation.if this equipmemt does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an autlet on a circuit different from that to which the receiver is connectec. • Consult the dealer or an experienced radio/TV technician for help. This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body. This device has been evaluated to meet general RF exposure requirement .The device can be used in portable exposure condition without restriction.

Navigation menu