National Formosa University R-TEST Radius-Test User Manual RF x
National Formosa University Radius-Test RF x
User Manual
User Manual
一、 Product Type and Name
l Product Name: Laser Radius-Test
l Type: Laser Radius-Test
二、 Introduction
This product complies with ISO 10791-6 specifications and suite for A-TYPE, B-TYPE, C-TYPE and
turning and milling machine five-axis machine testing equipment.
It is a high performance and cost-effective solution for testing equipment and Ideal for Industrial
Applications that require fast time to market.
三、 Features
This product includes 2.4 GHz IEEE 802.11n Single Stream and can be connected to Personal Computer
or Notebook through Wireless Network. It supports Infrastructure and SoftAp Networking Modes.
Personal Computer or Notebook need to support 2.4 GHz IEEE 802.11n, too.
Operating Voltage:
l 3.15V to 3.45V (3.3V typical)
l Temperature Range: -40°C to +85°C Industrial
l Low-Current Consumption:
n RX mode: 64 mA (typical)
n TX mode: 246 mA at 18 dBm (typical)
l Power Saving Mode:
n Sleep: 12 μA (typical)
RF/Analog Specifications:
l Frequency: 2.412 to 2.472 GHz
l Channels: 1-13
l Modulation: DSSS, CCK, BPSK, QPSK, 16QAM, and 64QAM
l Sensitivity: -94 dBm
Personal Computer or Notebook Specifications:
l CPU :Pemtium4 or higher
l RAM: 0.5GByte or higher
l OS: Windows XP ,7,8,10
l Disk Space: 10MByte
l Wirless: 2.4 GHz IEEE 802.11g/n
四、 Installation
Step1: Turn ON the Power Switch and Power ON.
FCC Statement
Federal Communications Commission (FCC) Statement
RADIO FREQUENCY INTERFERENCE BTATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: 1) this device may not cause harmful interference, and 2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try correct the
interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction manual.
You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.