Netgear orporated 16400362 11ac Wireless Router and Extender User Manual

Netgear Incorporated 11ac Wireless Router and Extender

User Manual

 Federal Communication Commission Interference Statement  This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the  following  two conditions:  (1)  This  device  may  not  cause  harmful  interference,  and  (2)  this  device  must  accept  any interference received, including interference that may cause undesired operation.  This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital  device, pursuant  to  Part  15  of  the  FCC  Rules.    These  limits  are  designed  to  provide  reasonable  protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio  frequency  energy  and,  if  not  installed  and  used  in  accordance  with  the  instructions,  may  cause harmful interference to radio communications.    However, there is  no  guarantee that  interference  will not  occur  in  a  particular  installation.    If  this  equipment  does  cause  harmful  interference  to  radio  or television  reception,  which  can  be  determined  by  turning  the  equipment  off  and  on,  the  user  is encouraged to try to correct the interference by one of the following measures:  -  Reorient or relocate the receiving antenna. -  Increase the separation between the equipment and receiver. -  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -  Consult the dealer or an experienced radio/TV technician for help.  FCC  Caution:  Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for compliance could void the user's authority to operate this equipment.  This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any  other  antenna  or transmitter.  For  operation  within  5.15  ~  5.25GHz  /  5.47  ~5.725GHz  frequency  range,  it  is  restricted  to  indoor environment. The band from 5600-5650MHz will be disabled by the software during the manufacturing and cannot be changed by the end user. This device meets all the other  requirements specified in Part 15E, Section 15.407 of the FCC Rules.     Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 29cm between the radiator & your body.  enable

Navigation menu