Netronix 9900-11215-000 PCI 10/100 LAN Card User Manual 46765

Download:
Mirror Download [FCC.gov]
Document ID	46765
Application ID	MGdiY97U0rOro5zZRgcRBw==
Document Description	8
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	13.66kB (170786 bits)
Date Submitted	1999-07-09 00:00:00
Date Available	1999-08-23 00:00:00
Creation Date	2001-06-11 13:35:13
Producing Software	Acrobat Distiller 4.0 for Windows
Document Lastmod	2001-06-11 13:35:20
Document Title	46765.pdf
Document Author:	VicodinES /CB /TNN

EXHIBIT 7
USER’S MANUAL OF EUT
Wake-On-LAN
10/100 Fast Ethemet PCI
Adapter
User's Guide
Ver. 2.0
Fcc Statement
This device emails! with Pat! 15 of the FOO Rules.
Operation is sublet: to the following two conditions:
(1) This device may not wuss hennful Imam and
(2) Thin device must wept any lnterierenoe received.
Inducing interference that may cause undesired operation.
Warning! This Equipment has been tested and lpum to
compiy with the “mas for e am e cruel device. Pursuant
m Part 15 oftl'le FCC rules. These LImiB are Mm to
provide reasonable protection agalnet hanniul interference
In a residential installation. This equipment generates.
uses and In radiate radio lrequerm/ energy and. it not
Installed and used In accordance with the Instructions, may
mule harrniui Interference to radio communications.
However. there is no guarantee that interference will not
occur In a partiwlar Installation. II this equipment does
cause harmful Interierenoe to radio or television reception,
which can be determined by turning the equipment all and
no, he user is encouraged to try to correct the inlerferenm
by one or more of the tolowing measures:
l Reorient or relocated the receiving antenna.
I increase the separation between the equipment and
receiver.
I Connect the equipment Into an Quite! an a circuit
diiferent from the! to which the receiver is conneded.
l Consult the dealer or an experienced redlo ITV
technician for help.
You are wutioned that changes or modifiation not
expreesty approved by the party responsible for comment;
could void your authority to operate the equipment.
CE-Mark Warning
In a darneetk: environment this product may cause radio
inletierence In which case the user may be required to take
adequate measures.
Cowrimte1999, All right Reserved.
Document Version: 20
All Trademrks and lace names are the properties of the?
respective immerse
FR
1. Introduction
Congratulations on the purchasing at your new 10/100 N»
Way Fast Ethernet FCI adapter, This document describes
the network adapter installation. This adapter supports
1OBASE~T11 OOBASE-YX Fast Ethemat and Wake-On-LAN
teatures and complies with the electrical and protocol
requlrements a! the PCI Lml Bus Specification, Revision
2.0 and 2.1.
1.1 Features
The 10/100 Fast Ethernet PCI adapter is a cast eitect‘rve,
high-performance network Antennae card. It operates in
|OBASE-T and NONE-TX mudes and integrates easily
with Fast Ethernet hub and switch.
‘ Wake-On-LAN supported
' IEEE 8023 standards 1OBASE-T and 1005ASE~TX
standards
- 32bit bus master for mgr» throughput and low CPU
utilization
- Full-duplex operation at both ruMbps and lOOMbps
- Support 10/100Mbps auto-sensing capability
- chn diagnostic LED mounted on bracket for easily
viewmg and lruuhleshoolrng
' Single shield RJ-45 connector for using at either
Speed (Category 3, l or 5 UTP cable for 10Mbps
Operatlon, and Category 5 UTP cable tor 100mm
Operation)
- Plug and Play Installaucn
- Test program (include Wake-On-LAN events)
' Network driver on the diskette for Windows 95, 96,
NT. Netware, SCO Unix and Picket driver.
' FCC,CE certification
1.2 System Requirements
To use the adapter, yuu need the follwing com
~ A PCIbased computer
- A PCl master mode expansion slot that is compliant
wrth PCI bus specifications. revisions 2‘0 and 2 1
' A 3 5-inch.1.44ME diskette drlve
- The following cables:
To operate at “Mb/s. 5 Category 3, 4, 5 UTP Cable
To operate at mouth/st a Category 5 UTP cable
2. Installation
This sentien describes how to instill the adapter. Fur
connecting to the network you must have the following:
1 Network adapter card installed to youroomputer.
2v Cabling (compatible wrth network topology)
3. Connect the Wake-On-LAN cable to the mother board
(It the woL is necessary)
4. Software for the adapter Cird Oomaln! both oonfigurallon
utilities and drivers
2.1 Unpack and Inspect
Clullon:
Under ordinary circumstances. this adapter card
Will not be attested by static charge as may be
received through your body during handling of the
unit In special circumstances where you may
cany an extraordinarily high stfltic charge it had
better reduce the Charga by mucriing a ground
before handllng the adamercarid.
shipping gift box and careluily remove all items.
n to this Users guidei please check the foliowmg
- brie 10/100 Fast Ethernet PCI Adapter card
- One WOL (Wake~0n-LAN) cable
- One a 5 Drivers and Utilities diskelte
Not-z
If any of the listed items are missing please
contact your distributor or reseller
2.2 Install the Adapter
1 Turn Ml the computer.
2 Remove the computers cover, in accordanoe to its
manual,
1 Intert the contact edge of the adapter card into the
connector at any available PCI Bus master expanlicn
slut Press the card firmly into the connector to PCI slot.
Please make sure mm the card's contacts are fully
seated in the PCI slot
4 Install the bracket screw that secures me card to the
Computer chassis.
5 Connect the WOL cable to the mother board. ‘tflhe WOL
teature required.
5 Replace the computers cover.
7 Connect the CATS ur CATS UTP cable to the RJ45
network ounnector
8. Remove [Drivers and Ulllttles] diskette from ltle PC
diskette drive
9. Turn on the computer
10 Ifthe BlOs sermon of your computers boot program is
Plug and Play compliant. then at pnwev up the eros will
configure any newly installed adapter automatically,
Note:
Due to some PIug-n—Play BIOS progrems' problem, It
happens occasrunally that a newly installed adapter is
assigned an Imerrupt Numberwhlch is already used
by inuther device adapter In such a case, the confllct
of Interrupt Number will cause faults in the behavioraf
both devices. Then it re necessary to run the CMOS
Setup util , and manually assign a nun—connrct
Intermpt Number.
fifi
2.3 Connect Fast Ethernet
Calegcry 5 UTP cable is required for Fasl Enamel
cpemllon. The maximum cable run between tnu fldnpter
and the supporting hub Is 300“ (100an Make the natwerk
onnneqlon by plugging one end OHM cable into the R445
receptade ofthe adapten and the other end intn one pm in
me hub.
mun Huh I 2:1
3 . . i "' Tmstea Pnernble
‘ l l mm Max)
SQ EQ fig SQ
2.4 Connect 10Mbps Ethernet
Category 3, Category 4‘ and Category 5 UTP cable, as well
as EIAITIA 568100 ohm ST'F' cable‘ all qualification under
Ethernet cabling rules The maximum cable length run
between this adapter and the supporting hub “s 300 lt
Make the neawork connection by plugging one and DI the
cable lnlo the RJ-45 receptacle of this adapter, and the
other end into (ha hub
7mm m Camel—j 7
mm Max; l j
mew
To wake up Target Machine with Maglc Packet
Steffi Target Machine
Target Machine is necessary in use the WOL cable
link the Wake On LAN connector on adapter With
your motherboardi check BIDS  ACPL Wake On LAN
lunction must be enable:
SIepZ: Target Machine.
Select  then the system will setup
wakeup event and wait a magic packet to do system
wakeup
Step3: Master Machine.
Select  then the system will setup
wakeup event and wait a magic packet to do system
wakeup
SIEPZ: Master Machine.
Select to send a wakeup frame.
SiapZS. Target Mlchine '
ACPI Testing events will be show
Device Stale l' PASS
Device State 2. PASS
Device State 3: PASS
Nate:
Adapter testing program can not be used in Windows
95/98 DOS mode. Do not load any device drivers,
memory manager, and anti-virus saltware The testing
program only can work in clean DOS prompt.
After an n; the  item, the
Screen will display like,
Node ID ....... ' 00 e(] 7d C0 ill) (JI
Network Speed. lflDMbps
[/0 Base EOUUH
‘ ll
Disabled
interrupt ..
Ful I‘Duplex
Pass Count Fail Count
A. 1/0 Register
B. lDOMst Locpback
C. lOMbps Luopback
D. Cable Cannection
 lest reminds you that the connectiun
link mighl he fail, either the Cable is not connected or the
cable link falls.
For the 
7 The Wmdnws system will inslall lhe driver automalicairy
8. Reboot the Windows system.
MM
Please execute the lollowing commands:
Fm Netware Cllent
LSL
NETODI
IPXODI
NETX or VLM
F.
LOGIN 
For Neiwsre Server
LOAD NETSRV
BIND IPX TO NETSRV
The help file h!|p1210.exe In [he diskette will describe the
deml driver inslailaliofl mlormahnn for all popular operating
systems.
2.5 Drivers and Utilities Diskette
The [Divers and Utilities] diskette contains all the popular
operating system drivers.
- Novel! NuiWare(ciient Isaiver)
NT 35 , NT4YO
Windmus 95/98
Mlcrosofi Clicnt (NDIS 2.0 DOS/052)
iMnduws For Workgroup 3.11
v . and so on
2.6 Software Installation
Please refer tn ” Quick Installation Guide"
2. 7 Test Program
This test progmm verifies configuration of the adapter and
assists the isolation of any faults in operation. Test
procedure are optional. and will only be useful in the
unusual event manners is a fault, such as an interrupt
number ccnfllct among your wmputefs add on cards. It
your installation provides normal operation, you do not
need these test pruoedurss,
At your Dos prompt. type the lollvwing command
a:\rs-l1210.exe 
The opening screen is displayed as following:
Wew Current Configuration
Set Up New Configuration
Run Diagnostifi
Exit RSET1210
Choose  itsm allows you to set
up the Network Speed, 10 or 100m, and Transmvsslan
Mode. Full or Hall Duplex, and so on. Choose (Run
Diagnostics> item to run the ndspler test program
Adapter test program includes:
r

The Power Management Test is available fol WOL adaptar
only

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
Create Date                     : 2001:06:11 13:35:13
Producer                        : Acrobat Distiller 4.0 for Windows
Author                          : VicodinES /CB /TNN
Title                           : 46765.pdf
Modify Date                     : 2001:06:11 13:35:20-04:00
Page Count                      : 11

EXIF Metadata provided by EXIF.tools