New Bright Co 838H Radio Control Toy Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	965683
Application ID	8ZpibLEFMKPoDtadhYpAiQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	69.21kB (865100 bits)
Date Submitted	2008-07-05 00:00:00
Date Available	2008-07-05 00:00:00
Creation Date	2008-07-01 10:12:47
Producing Software	Hewlett-Packard Intelligent Scanning Technology 3
Document Lastmod	0000-00-00 00:00:00
Document Title	User Manual
Document Author:	spqacwzh [ SZ05W497 ]

COELCCO EDPROD:CT
NOT RECOMMEND ED FOR CHILDREN UNDER 8 YEARS O AC E
AS WITH ALL ELE CTRIC PRODUCTS PRECAUTIONS SHOULD LDDE
OBSERVED DURING HANDLING AND USE TO PREV EIITEL ECTRIC
SHOCK. INPUT: 120V AC OOHZ SW. OUTPUT: 7V DC ISOmA.
OWN ER’S MAN UAL
Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.
mummy/mama
Ramon/aw
New Bright
Igs Table of Contents _
Table of Contents
Component Checklist
Charging the Battery
Battery Installation in Vehicle
Vehicle Features and Functions
Antenna Placement
Transmitter Features and Functions
Transmitter Battery Installation
Proper Use
Precautions and Care
Trouble Shooting and Support
Warranty information
New Bright
Womponent Checklist 7
To protect components from damage, they may be packed in the Styrofoam tray out a!
plain sight, Please search Styrofoam tray and remove all of the components shown
below. Sytroloam should be saved for storing your vehicle.
Vehicle
Battery Charger
6.0V NiCd Battery Pack
Transmitter
(2) “AA" Batteries
(2) Vehicle Antenna Tubes
the Batte i ~* ,
Ag W M
IMPORTANT!
The included GV NiCd battery pack is NOT charged prior to shipment
and must be charged at least 8 hours before the first use.
Hold Button
To Remove
Battery Charger
Batten] Pack
1. Plug the Charger into a standard indoor electrical outlet.
2. Insert the GV NiCd rechargeable battery pack securely into the charging cradle'(as shown
above). Be sure the arrows are properly matched. A
3. Allow battery to charge tor a minimum of 8 hours on the initial two chargés. Subsequent
charges require only 4 hours.
4. Charge will last approximately 15 minutes depending on terrain and driving style.
5. This power unit is intended to be correctly orientated in a vertical or floor mount position.
IMPORTANT: It is normal tor the battery pack to become warm after charging and/or use. Be
sure to allow the battew pack to cool before using or recharging. Recharging a warm battery
pack will greatly reduoe the battery life.
Battery pack can be charged up to 1,000 times!
ATTENTION PARENTS:
o The Battery Charger & Battery Pack need to be periodically examined for potential
hazards. Any potentially hazardous parts need to be repaired or replaced,
Vehicle
theatms and Functions I é
ON/OFF Switch
llMllLll
' if vehicle pulls to the left or right during forward driving the Steering Trim may need to be
adjusted. The Steering Trim is located on bottom 0! chassis between the tram wheels.
Antenna
‘Vehicle and Transmitter Antenna
VEHICLE
1. Locate the Vehicle
Antenna Wire, which
leads through an opening
on the top of the Vehicle.
2. Slide the Vehicle Antenna
Wire through the Vehicle
Antenna Tube. Insert the
tube into the opening on
the top of the Vehicle.
3. Tie a simple knot in the
Vehicle Antenna Wire to
hold the Vehicle Antenna
Tube in place.
TRANSMITTER
1. Locate the Transmitter
Antenna Wire, which leads
through an opening on the
top of the Transmitter.
2. Slide the Transmitter Antenna
Wire through the Transmitter
Antenna Tube. Insert the tube
into the opening on the top of
the Transmitter.
3. Tie a simple knot in the
Transmitter Antenna Wire
to hold the Transmitter
Antenna Tube in place.
Transmitter
i Features and Functions
FCC CAUTION:
The manuiacturer is not responsibie for vadio inierieienoe caused by unauthorized frequency modiiicaiion
to this equipment. Such modifications couid void the user's authority to operate the equipment.
. Locate the Transmitter Battery Compartment, which is on the back at the
Transmitter.
. Move the Battery Compartment Lock towards the Battery Compartment and
remove the Battery Compartment Cover.
. Insert 2 “AA" batteries. Make certain the plus (+) and minus (—) markings on
the batteries are in the same position as the plus (+) and minus (—) markings
inside the Battery Compartment.
. Replace Battery Compartment Cover making certain that the Battery
Compartment Lock has “snapped" into the locked position.
Note: When replacing Transmitter batteries:
Use alkaline batteries only.
Do not mix old and new batteries.
Do not mix alkaline, standard or rechargeable batteries.
Proper Use
luPrecautions and Care
Switch vehicle OFF Brush areas where
when not in use‘ dirt gets trapped. m
M. a:
Wipe body with a Do not use chemicals
soft rag or cloth. or water to clean.
Trouble Shooting §t,Support
90% of all difficulties experienced with radio controlled vehicles
are due to either weak batteries or batteries that have been installed incorrectly.
When batteries become weak, the vehicle may not necessarily stop completely
but may exhibit slow response, slow speed or erratic behavior.
Problem -Vehlcle does not move or moves slowly.
- Make certain there are fresh alkaline batteries in the transmitter and that they have
been installed in the correct position.
- Are the (+) and (-) markings on the alkaline batteries in the same position as the (+)
and (—) markings in the Transmitter Battery Compartment?
- Has the Battery Pack been installed in the vehicle?
- Has the rechargeable Battery Pack been fully charged?
- Are the (+) and (—) markings on the Battery Pack in the same position as the (+) and
(—) markings in the Battery Compartment?
» Are the metal contact tabs touching, rusty or dirty in the transmitter?
» Make certain that the vehicle ON/OFF switch is in the "ON” position
~ Make certain that the transmitter antenna is securely attached to the transmitter.
Problem - Vehicle moves by itselt or exhibits reduced range from the transmitter.
» Make certain there is no outside radio interference in your area The best way to test
this is to take the vehicle as tar away from radio towers, electrical lines or tall buildings
as possible to ensure no further radio interterence will occur.
NOTE: This equipment has been tested and lound to comgéy with the limits tor a Class B digital device, pursuant to
Part 15 at the FCC Rules. These limits are design to provide reasonable protection against hamttul
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, it not installed and used in accordance with me instructions, may cause hamvful interlerence to
radio communications. However, there is no guarantee that imerterenoe will not occur in a particular
installation. It this equipment does cause harmful interlerence to radio or television reception, vmich can be
determined by turning the equipment oil and on, the user is encouraged to try to oorreot the interference by
one or more of the iotlcwing measures:
- Fleorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit ditlerent lrcm that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician tor help.
New Bright
a 5 Warranty Informationfiv
- Do not recharge Battery Pack it it is hot or warm to the touch. Allow Battery Pack
to cool before recharging Recharging a hot or warm Battery Pack will shorten the
lite of the Pack.
- Do not recharge a Battery Pack it it appears to be damaged or leaking.
- Always unplug Charger when not in use.
- Always remove Battery Pack from Battery Compartment when not in use.
-Do not dispose batteries in lire. Leakage, explosion and personal injury may occur.
- Dispose of NiCd Battery Pack properly,
- Do not attempt to disassemble Battery Pack or Charger.
- Do not use Battery Charger tor any use other than instructed in this booklet.
- Only an adult should charge Batteries.
- Do not attempt jumps or tricks with this vehicle.
USA and Canada
Goday Limited Warranty
New Bright Indrstries warrants to the original purchaser that this product will be tree otdetects in materials and workmanship tor
sixty 160] days trom the date at purchase, New Bright will repair or replace the product, at our sole option. in the event at such a
detect within the warranty period. This warranty does not ower damage resulting from unauthoriled modikations. accident
misuse. or abuse.
In the event 01 adetect covered under this warranty, first call the toll tree number listed below. Many problems can be resettled in
this manner it necessary, you will be issued a return authorization tRAt number, and instnrcted on how to obtain a return ionn to
be used to return the produrx to us, postage prepaid and insured bythe consumer to the address listed on the return term,
When returning a detective product, ptease package the product, the return term with RM, and a copy at the dated sales receipt
as proot 0! purchase. it the product is retumed without a dated sates receipt. it will be excluded irom coverage under this
warranty. Please allow 4 to 6 weeks tor delivery oi repaired or replacement vehicle depending on your location.
New Bright Industries Iiabiity tor dateds In material and workmanship under this warranty shall be limited to repair or
replacement, at our sole ophon, and in no event shall we be responsible tor incidental, oonsaguenlial. or contingent damages
(exoept in those states that do not allow this exclusion or limitation).
Vatit only it USA, and Canada
Contact New arm customer Service at
Toll Free
tamer-3697
M~F seem to 5mm Eastern Time

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Page Count                      : 12
Producer                        : Hewlett-Packard Intelligent Scanning Technology.3
Author                          : spqacwzh [ SZ05W497 ]
Create Date                     : 2008:07:01 10:12:47

EXIF Metadata provided by EXIF.tools