New Bright Co GF3710HA IROBOT TOY Transmitter & Receiver User Manual

New Bright Industrial Co Ltd IROBOT TOY Transmitter & Receiver

User Manual

Download: New Bright Co GF3710HA IROBOT TOY Transmitter & Receiver User Manual
Mirror Download [FCC.gov]New Bright Co GF3710HA IROBOT TOY Transmitter & Receiver User Manual
Document ID3101611
Application IDsb0taZCup+Ctw4jgFxehXw==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize136.31kB (1703885 bits)
Date Submitted2016-08-17 00:00:00
Date Available2016-08-17 00:00:00
Creation Date2016-08-03 14:41:39
Producing SoftwareAdobe PSL 1.1e for Canon
Document Lastmod0000-00-00 00:00:00
Document TitleUser Manual
Document CreatorCanon iR-ADV C5035 PDF

(H, k Trmflmtet
Battery Pack
LVQharging tile Battery 3 ' I
IMPORTANT! '
The included 12.5V Lithium Ion battery pack is only PARTIALLY CHARGED prior to shipment
and it is recommended the battery be fully charged before first use.
Charging Status
Light
Battery Charger
Push and
it Hold Button
" To Remove
12.8V Battery Pack
1. insert the 128V Lithium ion rechargeable battery pack securely into the charger and push
up to lock. Be sure the arrows are properly matched (as shown above).
2. Plug the Charger into a standard indoor electrical outlet. This power unit is Intended to be
correctly orientete_d in a yertiml or wall mount position
3 l Charging Status Light will be solid red while battery
is charging When charging is complete, light will blink green.
4. To remove the battery press and hold the release button and slide battery down to unlock
5.0harge Mil last approximately 12 minutes depending on terrain and driving style.
IMPORTANT: ltle norrnaliorthebetterypacktobecomewarr‘n attercharglng and/cross. Be sure,
to allow the battery pack to cool before using or recharging Hecharglng a warm battery pack will
greedy reduce the battery life.
ATTENTION PARENTS: ‘
s The Battery Charger 4 Battery Pack need to be periodically examined tor potential hazards. Any
potentlalty hazardous parts need to be repaired or replaced.
TRANSMITTER
<0 SmaHY’hme
Haida-r
Rams/Louver
Dég'ua: onpnrtiona!
Olive Control From heads
6)
owfim M
_‘ wantoemI : g >_ >
find vehvglg.._
Archie
TRANSMITTER ‘
T ® fligkafi Propcmnnal W Cam!
‘ M W Farwam‘ fer ”Reward Dr: ~19. Pull Joystick Bad: for Reverse Driving.
, Laiifar uhmmhxg. Push Jame}: Right for Rigm Tuming.
am Tim? v . _ , , .
, 1?: E353; 11% km? beak. Continue In hold to name treads ‘80” for Storage
mm 5mm 3:? m {rim m Confirm to hold to Hf! vehicle up Reiease
Banzai?
Am {git Rush and‘hoId Right Button to RomeAnn Right.
., 33¢ an Lewes My;
ml: (at: so Rome Wrist (met-0W2.
ROBOT FUNCTIONS
HHI‘H‘M «' .m
WMULIAN‘EflUS MQVEMENTS
Flam ”"1“5'252 in
bum J'e this cumhmamr‘ ‘ ruffle m
EDINL'
25% 'V' s2 flaw.
ROBOT FUNCTIONS
.4.”
mu.
ROBOT FUNCTIONS
Arivmm-(g Opt-mm m.
» IMPORTANH
.1 Do not attempt advanced epe'rations until basic wntrois have been mastered.
' STAIRS AND OTHER OBSIACLES ’
Mmdes. sad: with the REAR of the vehgv usmg REVERSE Dmve.
, mtionann as shown and raise wrist until flaw is poking
Trouble shooting & Support
Problem - Vehicle does not move or moves slowly.
- Make certain there are fresh batteries in the transmitter and that they have been
installed in the correct position.
- Are the (+) and H markings on the batteries in the same position as the (+) and (-)
markings in the Transmitter Battery Compartment?
- Has the Battery Pack been installed in the vehicle?
- Has the rechargeable Battery Pack been iully charged?
- Are the (+) and H markings on the Battery Pack in the same position as the (+) and
H markings in the Battery Compartment?
- Are the metal contact tabs touching, rusty or dirty in the transmitter?
- Make certain that the vehicle ON/OFF switch is in the "ON" position.
Problem - Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test
this is to take the vehicle as far away irom radio towers. electrical lines or tall
buildings as possible to ensure no lurther radio interierence will occur.
FCC CAUTION: .
Changes or modifications not expressiy approved by the party responsible ior compliance could
void the users authority to operate the equipment.
NO‘i‘Ezi'his uuwnthasbeortlested and bundtooormlymtflnirritsiouCIossE digitaldme. pulsuunttoPm 1501"
FCC Rulesiheu imfli In W to prw'tde roasombie protectm against harmiul madam in a Moment
imtallattonlhis W generates. uses andun more ram trsquemyenervyand, fl M'infllled and used in
means writ! the mum, may cause hamrtui “adorns in radio W mm. more Is no guarantee
that tmensrence wilt Mimi In a perinatal metal-1m it this Wt does cause hamlet interference to radio or
Ielev'mon reception. which can be determined by Mung the equipment oii and on. the user is encouraged to try n wired
the niemrlmwmumdmmmmm
- Rmflorrliocatothe root-ring mm.
-tncrusetheeoneution bum Itieoquipmemandrmr.
.mmeWirmoanmmemmamnmimmthm-msmm.
.wmwhrumwmmmum
., ‘New Bright
_ Cautions
Do not leave the toy unattended while charging it.
Battery charging should be done by adults.
Charge the toy on a non-flammable surface and keep it away from
flammable items
Turn the charger off when the toys battery is charged, and always
unplug it from the toy.
Disconnect AC wall chargers from outlets while not in use.
If the toy has been damaged, immediately stop use, unplug, and
safety move the toy away from flammable materials.
Follow the manufacturer’s instructions for charging the toy. DO NOT
charge longer than recommended.
RSS Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le present uppareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitatian est autorise’e aux
deux conditions suivantes : (1) I'appareil ne doit pas produire de brauillage,
et (2) l'utilisateur de l‘appareil doit accepter dout brouillage radioe’leatrique
subi, mérne si le brouillage est susceptible d'en compromettre le fanctionnement.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Creator                         : Canon iR-ADV C5035  PDF
Create Date                     : 2016:08:03 14:41:39+08:00
Page Count                      : 13
XMP Toolkit                     : Adobe XMP Core
Creator Tool                    : Canon iR-ADV C5035  PDF
Producer                        : Adobe PSL 1.1e for Canon
Format                          : application/pdf
Document ID                     : uuid:3892a157-0000-001e-8f33-0f6300000000
EXIF Metadata provided by EXIF.tools
FCC ID Filing: G6DGF3710HA

Navigation menu