New Bright Co TH1 Remote Controller for Toy User Manual Manual

New Bright Industrial Co Ltd Remote Controller for Toy Manual

Manual

Download: New Bright Co TH1 Remote Controller for Toy User Manual Manual
Mirror Download [FCC.gov]New Bright Co TH1 Remote Controller for Toy User Manual Manual
Document ID1714279
Application IDZJ79WZhWdfDjBlYj8THXTA==
Document DescriptionManual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize43.24kB (540461 bits)
Date Submitted2012-06-04 00:00:00
Date Available2012-06-04 00:00:00
Creation Date2012-04-26 13:10:40
Producing SoftwareHewlett-Packard Intelligent Scanning Technology 3
Document Lastmod2012-05-30 15:03:57
Document TitleManual
Document Author: spqacxzh [ SZ05W497 ]

Battery Installation
locate and align arrow on balmy pack with arrow inside batheiy compartment.
Place battery pack in balmy compartment and slide batteiy iotwafd in direction of arrow.
Once in plate, tum loddng tab to keep battery pack secure.
if bamry pan is not completely m place locking lab will not fully tum.
FeatUres and Functions
Power Button Wheel Alignment'
{Steering Trim)
' if vehid: pulls to the Ieh or right durihg iorward driving the Steering film méy
need to be adiusted. The Steering Trim’ is located on bottom cl chassis between
the fmnt wheels,
’ Vehicle will Automatically shut down afier 30 minutzs oi mamvizy to save
battery life.
Transmitter
Features and Functions
Left/Right Steering
Battery Compamnent
Forward/Reverse
Pairing vehicle and transmitter:
110m Powet Button on undesid! olvehide .
2. Press button.
3, Hold wansmittu within cne fool of which
all Press and hold one of the fun: Ame pairing balms on the nanuninev.
5 From tires will slightly move left and rigl’n indicatlng the vehkle and transmitter have
autc paired.
NOTE: Vehicle will Automatically shul dwm aha! 30 mlnlms of inactivity to save battery Ilia
Body Shell Removal
Locate the body pins on lap of vehitle body.
Pull pins as shown and set aside,
Lift and lemme body shell.
Transmitter
Battery installation
1.Locate and remove the Battery Compartment
Cover which is located on the trontiace of the
Transmitter.
2. lnsert 2 "AA' size batteries.
Make certain the positive (+) and negative (—)markings on the batteries are in
the same position as the positive (+) negative H markings inside the Battery
Compartment,
3 Replace Battery Compartment
Cover making certain that the
Battery Compartment tab has
"snapped" into the locked
position.
Note: When replacing Transmitter batteries:
Do not mix old and new batteries
Do not mix alkaline, standard or rechargeable batteries
the alkaline batteries only.
New Bright
Cautions
Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery
Pack to coal before recharging. Recharging a hot or warm Battery Pack will
shorten the life of the Pack.
Do not recharge a Battery Pack if it appears to be damaged or leaking.
Always unplug Charger when not in use.
Always remove Battery Padt from Battery Compartment when not in use.
Do not dispose batteries in fire. Leakage. explosion and personal injury may
OCCU'.
Dispose of Lithium Ion Battery Pack properly
Do not attempt to disassemble Battery Pack or Charger.
Do not use Battery Charger for any use other than instructed in this booklet.
Only an adult should charge Batteries.
Do not attempt jumps or tricks with this vehicle,
Do not insert the antenna wire Into electrical socket outlets.
FCC CAUTION:
The manuiacturer is not responsible ior radio interference caused by unauthorized frequency
modification to this equipment. Such modifications could void the user‘s authority to operate the
equipment. ‘
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are deslianed to provide reasonable protection
against harmful ‘ terference in a residential installation. is equipment generates, uses and can
radiate radio uency energy and, if not installed and used in accordance with the instructions,
may cause harm l interference to radio communications However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the uipment
off and an, the user is encouraged to try to correct the interference by one or more of e
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
» Consult the dealer or an experienced radio/TV technician for helpt

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2012:04:26 13:10:40Z
Modify Date                     : 2012:05:30 15:03:57-04:00
Page Count                      : 4
Producer                        : Hewlett-Packard Intelligent Scanning Technology.3
Author                          : spqacxzh [ SZ05W497 ]
Creation Date                   : 2012:04:26 13:10:40Z
Mod Date                        : 2012:05:30 15:03:57-04:00
Metadata Date                   : 2012:05:30 15:03:57-04:00
Creator                         : spqacxzh [ SZ05W497 ]
EXIF Metadata provided by EXIF.tools
FCC ID Filing: G6DTH1

Navigation menu