Nexpro Limitada BLISS MOBILE PHONE User Manual QuikGuide BLISS TIGO AGOS13 copia
Nexpro International Limitada MOBILE PHONE QuikGuide BLISS TIGO AGOS13 copia
Contents
- 1. USER MANUAL
- 2. USERS MANUAL
USER MANUAL
Warning
Specific Absorption Rate (SAR) information SAR tests are
conducted using standard operating positions accepted
by the FCC with the phone transmitting at its highest
certified power level in all tested frequency bands,
although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while
operating can be well below the maximum value, in
general, the closer you are to a wireless base station
antenna, the lower the power output. Before a new model
phone is a available for sale to the public, it must be tested
and certified to the FCC that it does not exceed the
exposure limit established by the FCC, Tests for each
phone are performed in positions and locations (e.g. at
the ear and worn on the body)as required
by the FCC. For body worn operation, this model phone
has been tested and meets the FCC RF exposure
guidelines when used with an accessory designated for
this product or when used with an accessory that contains
no metal and that positions the handset a minimum of 1.5
cm from the body.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
‐‐Reorient or relocate the receiving antenna.
‐‐Increase the separation between the equipment and
receiver.
‐‐Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
‐‐Consult the dealer or an experienced radio/TV
technician for help.