Nextivity orporated D32-21366CU Provider-Specific Consumer Signal Booster User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2971145
Application ID	DXM4pLwRbKQoYf2UYkRMVA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	16.52kB (206560 bits)
Date Submitted	2016-04-26 00:00:00
Date Available	2016-10-23 00:00:00
Creation Date	2016-04-26 10:39:42
Producing Software	Adobe PDF Library 15.0
Document Lastmod	2016-04-26 10:39:43
Document Title	User Manual
Document Creator	Adobe InDesign CC 2015 (Macintosh)

PRODUCT INFORMATION
Cel-Fi DUO Smart Signal Booster
®
STOP!!!
Do not call your service provider
until you have read the Quick Start Guide.
If you need help, visit: http://www.celfihelp.com
Safety Precautions
• Use Cel-Fi indoors. It should not be
used outdoors.
• These products are designed to be
used with a direct plug-in power supply
unit that shipped with the product.
When installing the equipment, all the
requirements of the manufacturer and
the referenced standards must be met.
• There are no user serviceable parts
inside.
• CAUTION: Changes or modifications
to this product not expressly approved
by Nextivity may void your right to
operate the equipment.
Warranty
Nextivity Inc provides a limited warranty
for its products. For details, please refer to
http://cel-fi.com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users,
be liable under contract, tort, strict liability,
negligence or any other legal or equitable
theory with respect to the Products or any other
subject matter of this Agreement (i) for any lost
profits, cost of procurement of substitute goods
or services, or special, indirect, incidental,
punitive, or consequential damages of any kind
whatsoever or (ii) for any direct damages in
excess of (in the aggregate) the fees actually
received by Nextivity from End User with respect
to the Products actually purchased and paid for.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are
trademarks of Nextivity, Inc.
FCC Statement (Applicable in the USA only)
FCC
The device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation of the device.
To comply with RF exposure requirements the
antenna shall be installed to ensure a minimum
separation distance of 20 cm from persons. The
antenna may not be co-located or operated in
conjunction with other transmitting devices.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS
DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers
consent to the use of signal boosters. Some
providers may not consent to the use of this
device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved
antennas and cables as specified by the
manufacturer.
Antennas MUST be installed at least 20 cm (8
inches) from any person.
You MUST cease operating this device
immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not
be provided or may be inaccurate for calls served
by using this device.
When used with any mobile device utilizing the
1710-1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10
meters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC
enforcement action.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
PRODUCT INFORMATION
Cel-Fi DUO Smart Signal Booster
®
STOP!!!
Do not call your service provider
until you have read the Quick Start Guide.
If you need help, visit: http://www.celfihelp.com
Safety Precautions
• Use Cel-Fi indoors. It should not be
used outdoors.
• These products are designed to be
used with a direct plug-in power supply
unit that shipped with the product.
When installing the equipment, all the
requirements of the manufacturer and
the referenced standards must be met.
• There are no user serviceable parts
inside.
• CAUTION: Changes or modifications
to this product not expressly approved
by Nextivity may void your right to
operate the equipment.
Warranty
Nextivity Inc provides a limited warranty
for its products. For details, please refer to
http://cel-fi.com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users,
be liable under contract, tort, strict liability,
negligence or any other legal or equitable
theory with respect to the Products or any other
subject matter of this Agreement (i) for any lost
profits, cost of procurement of substitute goods
or services, or special, indirect, incidental,
punitive, or consequential damages of any kind
whatsoever or (ii) for any direct damages in
excess of (in the aggregate) the fees actually
received by Nextivity from End User with respect
to the Products actually purchased and paid for.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are
trademarks of Nextivity, Inc.
FCC Statement (Applicable in the USA only)
FCC
The device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation of the device.
To comply with RF exposure requirements the
antenna shall be installed to ensure a minimum
separation distance of 20 cm from persons. The
antenna may not be co-located or operated in
conjunction with other transmitting devices.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS
DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers
consent to the use of signal boosters. Some
providers may not consent to the use of this
device on their network. If you are unsure, contact
your provider.
You MUST operate this device with approved
antennas and cables as specified by the
manufacturer.
Antennas MUST be installed at least 20 cm (8
inches) from any person.
You MUST cease operating this device
immediately if requested by the FCC or a licensed
wireless service provider.
WARNING. E911 location information may not
be provided or may be inaccurate for calls served
by using this device.
When used with any mobile device utilizing the
1710-1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10
meters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC
enforcement action.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Consult the dealer or an experienced radio/TV
technician for help
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Designed by Nextivity in California.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
www.Cel-Fi.com for details.
Copyright
Copyright © 2016 by Nextivity, Inc. All rights
reserved. Reproduction or media conversion by
any means is protected by copyright and may only
occur with prior written permission of Nextivity.
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
• Consult the dealer or an experienced radio/TV
technician for help
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Designed by Nextivity in California.
legal_DUO-NA-English_16-0425
Copyright
Copyright © 2016 by Nextivity, Inc. All rights
reserved. Reproduction or media conversion by
any means is protected by copyright and may only
occur with prior written permission of Nextivity.
legal_DUO-NA-English_16-0425
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK
Bureau in Europe:
Whitehill Way, Swindon, UK
SN5 6QR
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
www.Cel-Fi.com for details.
SN5 6QR

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.6-c067 79.157747, 2015/03/30-23:40:42
Create Date                     : 2016:04:26 10:39:42-07:00
Metadata Date                   : 2016:04:26 10:39:43-07:00
Modify Date                     : 2016:04:26 10:39:43-07:00
Creator Tool                    : Adobe InDesign CC 2015 (Macintosh)
Instance ID                     : uuid:5461bbf5-498e-6c41-8473-7b0b69719f3b
Original Document ID            : xmp.did:B626C39852206811B6A4D97738D90740
Document ID                     : xmp.id:cd5d642c-5d56-4df8-8e2e-8e08a1390da5
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:5a0a4414-0860-4ba5-ab13-ed06daeb82b5
Derived From Document ID        : xmp.did:F97F117407206811871FE6BE57A2A30D
Derived From Original Document ID: xmp.did:B626C39852206811B6A4D97738D90740
Derived From Rendition Class    : default
History Action                  : converted
History Parameters              : from application/x-indesign to application/pdf
History Software Agent          : Adobe InDesign CC 2015 (Macintosh)
History Changed                 : /
History When                    : 2016:04:26 10:39:42-07:00
Format                          : application/pdf
Producer                        : Adobe PDF Library 15.0
Trapped                         : False
Page Count                      : 2
Creator                         : Adobe InDesign CC 2015 (Macintosh)

EXIF Metadata provided by EXIF.tools