Nextivity orporated MBLE Bluetooth LE module User Manual 2
Nextivity Incorporated Bluetooth LE module Users Manual 2
Contents
- 1. Users Manual 1
- 2. Users Manual 2
Users Manual 2
PRODUCT INFORMATION
Cel-Fi® PRO Smart Signal Booster
PRODUCT INFORMATION
Cel-Fi PRO® Smart Signal Booster
If you need help, visit: http://www.celhelp.com
Safety Precautions
• Use Cel-Fi indoors. It should not be
used outdoors.
• These products are designed to be
used with a direct plug-in power supply
unit that shipped with the product.
When installing the equipment, all the
requirements of the manufacturer and
the referenced standards must be met.
• There are no user serviceable parts
inside.
• CAUTION: Changes or modications
to this product not expressly approved
by Nextivity may void your right to
operate the equipment.
Warranty
Nextivity Inc provides a limited warranty for its
products. For details, please refer to http://cel-.
com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users, be
liable under contract, tort, strict liability, negli-
gence or any other legal or equitable theory with
respect to the Products or any other subject mat-
ter of this Agreement (i) for any lost prots, cost
of procurement of substitute goods or services,
or special, indirect, incidental, punitive, or con-
sequential damages of any kind whatsoever or
(ii) for any direct damages in excess of (in the
aggregate) the fees actually received by Nextiv-
ity from End User with respect to the Products
actually purchased and paid for.
See cel.com for list of patents covering this
product.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are trade-
marks of Nextivity, Inc.
FCC Statement (Applicable in the USA only)
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS
DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers
consent to the use of signal boosters. Some pro-
viders may not consent to the use of this device
on their network. If you are unsure, contact your
provider.
You MUST operate this device with approved
antennas and cables as specied by the manu-
facturer.
Antennas MUST be installed at least 20 cm (8
inches) from any person.
You MUST cease operating this device immedi-
ately if requested by the FCC or a licensed wire-
less service provider.
WARNING. E911 location information may not
be provided or may be inaccurate for calls served
by using this device.
When used with any mobile device utilizing the
1710-1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10 me-
ters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC en-
forcement action.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digi-
tal device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
If you need help, visit: http://www.celhelp.com
Safety Precautions
• Use Cel-Fi indoors. It should not be
used outdoors.
• These products are designed to be
used with a direct plug-in power supply
unit that shipped with the product.
When installing the equipment, all the
requirements of the manufacturer and
the referenced standards must be met.
• There are no user serviceable parts
inside.
• CAUTION: Changes or modications
to this product not expressly approved
by Nextivity may void your right to
operate the equipment.
Warranty
Nextivity Inc provides a limited warranty for its
products. For details, please refer to http://cel-.
com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users, be
liable under contract, tort, strict liability, negli-
gence or any other legal or equitable theory with
respect to the Products or any other subject mat-
ter of this Agreement (i) for any lost prots, cost
of procurement of substitute goods or services,
or special, indirect, incidental, punitive, or con-
sequential damages of any kind whatsoever or
(ii) for any direct damages in excess of (in the
aggregate) the fees actually received by Nextiv-
ity from End User with respect to the Products
actually purchased and paid for.
See cel.com for list of patents covering this
product.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are trade-
marks of Nextivity, Inc.
FCC Statement (Applicable in the USA only)
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS
DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers
consent to the use of signal boosters. Some pro-
viders may not consent to the use of this device
on their network. If you are unsure, contact your
provider.
You MUST operate this device with approved
antennas and cables as specied by the manu-
facturer.
Antennas MUST be installed at least 20 cm (8
inches) from any person.
You MUST cease operating this device immedi-
ately if requested by the FCC or a licensed wire-
less service provider.
WARNING. E911 location information may not
be provided or may be inaccurate for calls served
by using this device.
When used with any mobile device utilizing the
1710-1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10 me-
ters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC en-
forcement action.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B digi-
tal device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a resi-
STOP!!! Do not call your service provider
until you have read the Quick Start Guide.
STOP!!! Do not call your service provider
until you have read the Quick Start Guide.
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR
Nextivity Inc Headquarters:
12230 World Trade Drive
Suite 250 San Diego, CA 92128, USA
http://www.nextivityinc.com
Bureau in Europe:
Whitehill Way, Swindon, UK SN5 6QR
PI_PRO-NA-English_14-1104 PI_PRO-NA-English_14-1104
dential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no guar-
antee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
Industry Canada (IC) Statement
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For situ-
ations when multiple carrier signals are present,
the rating would have to be reduced by 3.5 dB, es-
pecially where the output signal is re-radiated and
can cause interference to adjacent band users.
This power reduction is to be by means of input
power or gain reduction and not by an attenuator
at the output of the device.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Gain 100dB
Bandwidth 35Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22dBm per band
Downlink 16dBm per band
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouil-
lage est susceptible d’en compromettre le fonc-
tionnement.
Compliance Contact
In the event of regulatory compliance issue,
please contact Nextivity Inc. directly. Contact in-
formation is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
CEL-FI.com for details.
Copyright
Copyright © 2014 by Nextivity, Inc. All rights re-
served. Reproduction or media conversion by any
means is protected by copyright and may only oc-
cur with prior written permission of Nextivity. De-
signed by Nextivity in California.
dential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no guar-
antee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
Industry Canada (IC) Statement
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For situ-
ations when multiple carrier signals are present,
the rating would have to be reduced by 3.5 dB, es-
pecially where the output signal is re-radiated and
can cause interference to adjacent band users.
This power reduction is to be by means of input
power or gain reduction and not by an attenuator
at the output of the device.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Gain 100dB
Bandwidth 35Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22dBm per band
Downlink 16dBm per band
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouil-
lage est susceptible d’en compromettre le fonc-
tionnement.
Compliance Contact
In the event of regulatory compliance issue,
please contact Nextivity Inc. directly. Contact in-
formation is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
CEL-FI.com for details.
Copyright
Copyright © 2014 by Nextivity, Inc. All rights re-
served. Reproduction or media conversion by any
means is protected by copyright and may only oc-
cur with prior written permission of Nextivity. De-
signed by Nextivity in California.