Nextivity orporated Q34-251266CU Provider-Specific Consumer Signal Booster User Manual

Nextivity Incorporated Provider-Specific Consumer Signal Booster

Contents

User Manual

PRODUCT INFORMATIONCel-Fi® QUATRA Networked Smart BoosterIf you need help, visit: http://www.celhelp.comSafety Precautions•  Use Cel-Fi indoors.  It should not be used outdoors.•  These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit.. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.•  There are no user serviceable parts inside.•  CAUTION: Changes or modications to this product not expressly approved by Nextivity may void your right to operate the equipment.WarrantyNextivity  Inc  provides  a  limited  warranty  for  its products. For  details, please  refer to  http://cel-.com/warranty.Limitation of LiabilityIn no event shall Nextivity, nor its directors, employees,  agents,  suppliers  or  End  Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any  lost prots, cost  of procurement  of substitute goods or services, or special, indirect, incidental, punitive, or consequential  damages  of any kind whatsoever  or  (ii)  for  any  direct  damages  in excess  of  (in  the  aggregate)  the  fees  actually received by Nextivity from End User with respect to the Products actually purchased and paid for.See  cel.com  for  list  of  patents  covering  this product. TrademarkCel-Fi, IntelliBoost, and Nextivity logo are trademarks of Nextivity, Inc.FCC Statement (Applicable in  the  USA only) This is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE  with your wireless provider and have your provider’s consent. Most wireless providers consent  to  the  use  of  signal  boosters.  Some providers  may  not  consent  to  the  use  of  this device on their network. If you are unsure, contact your provider.You  MUST operate this device with approved antennas  and  cables  as  specied  by  the manufacturer.Antennas  MUST  be  installed  at  least  20  cm  (8 inches) from any person.You  MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.WARNING.  E911  location  information  may  not be provided or may be inaccurate for calls served by using this device.When used  with any  mobile device  utilizing  the 1710-1755  MHz  band,  the  FCC  limits  booster equipment  placement  to  a  maximum  of  10 meters  above  ground  level.  Installation  of  this equipment  which  does  not  comply  with  federal requirements  may  subject  the  owner  to  FCC enforcement action.This  device  complies  with  part  15  of  the  FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE:  This  equipment  has  been  tested  and found to comply with the limits for a Class B digital device,  pursuant  to  part  15  of  the  FCC  Rules. These limits are designed to provide reasonable protection  against  harmful  interference  in  a residential installation. This equipment generates, If you need help, visit: http://www.celhelp.comSafety Precautions•  Use Cel-Fi indoors.  It should not be used outdoors.•  These products are designed to be used with a direct plug-in power supply unit that shipped with the Network Unit.. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.•  There are no user serviceable parts inside.•  CAUTION: Changes or modications to this product not expressly approved by Nextivity may void your right to operate the equipment.WarrantyNextivity  Inc  provides  a  limited  warranty  for  its products. For  details, please  refer to  http://cel-.com/warranty.Limitation of LiabilityIn no event shall Nextivity, nor its directors, employees,  agents,  suppliers  or  End  Users, be liable under contract, tort, strict liability, negligence or any other legal or equitable theory with respect to the Products or any other subject matter of this Agreement (i) for any  lost prots, cost  of procurement  of substitute goods or services, or special, indirect, incidental, punitive, or consequential  damages  of any kind whatsoever  or  (ii)  for  any  direct  damages  in excess  of  (in  the  aggregate)  the  fees  actually received by Nextivity from End User with respect to the Products actually purchased and paid for.See  cel.com  for  list  of  patents  covering  this product. TrademarkCel-Fi, IntelliBoost, and Nextivity logo are trademarks of Nextivity, Inc.FCC Statement (Applicable in  the  USA only) This is a CONSUMER device.BEFORE USE, you MUST REGISTER THIS DEVICE  with your wireless provider and have your provider’s consent. Most wireless providers consent  to  the  use  of  signal  boosters.  Some providers  may  not  consent  to  the  use  of  this device on their network. If you are unsure, contact your provider.You  MUST operate this device with approved antennas  and  cables  as  specied  by  the manufacturer.Antennas  MUST  be  installed  at  least  20  cm  (8 inches) from any person.You  MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.WARNING.  E911  location  information  may  not be provided or may be inaccurate for calls served by using this device.When used  with any  mobile device  utilizing  the 1710-1755  MHz  band,  the  FCC  limits  booster equipment  placement  to  a  maximum  of  10 meters  above  ground  level.  Installation  of  this equipment  which  does  not  comply  with  federal requirements  may  subject  the  owner  to  FCC enforcement action.This  device  complies  with  part  15  of  the  FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE:  This  equipment  has  been  tested  and found to comply with the limits for a Class B digital device,  pursuant  to  part  15  of  the  FCC  Rules. These limits are designed to provide reasonable protection  against  harmful  interference  in  a residential installation. This equipment generates, STOP!!! Do not call your service provider  until you have read the User Manual.STOP!!! Do not call your service provider  until you have read the User Manual.PRODUCT INFORMATIONCel-Fi® QUATRA Networked Smart Booster
Nextivity Inc Headquarters:12230 World Trade Drive Suite 250 San Diego, CA 92128, USA http://www.nextivityinc.comBureau in Europe:Whitehill Way, Swindon, UK    SN5 6QRNextivity Inc Headquarters:12230 World Trade Drive Suite 250 San Diego, CA 92128, USA http://www.nextivityinc.comBureau in Europe:Whitehill Way, Swindon, UK    SN5 6QRPI_QUATRA-English_15-0629 PI_QUATRA-English_15-0629uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,  may cause  harmful interference to  radio  communications.  However,  there  is  no guarantee that interference will not occur in a particular  installation.  If  this  equipment  does cause  harmful  interference  to  radio  or  television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to  correct  the interference  by one or  more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.•  Connect  the  equipment  into  an  outlet  on  a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for helpExternal Antenna (option):Only use with approved Cel-Fi MIMO Panel Antenna A52-X12-100.Industry Canada (IC) StatementThe Manufacturer’s rated output power of this equipment  is  for  single  carrier  operation.  For situations  when  multiple  carrier  signals  are present, the rating would have to be reduced by 3.5 dB,  especially where  the output  signal is  re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of  input  power  or  gain  reduction  and not by an attenuator at the output of the device.La  puissance  de  sortie  nominale  indiquée  par le fabricant pour cet appareil concerne son fonctionnement  avec  porteuse  unique.  Pour des  appareils  avec  porteuses  multiples,  on  doit réduire  la  valeur  nominale  de  3,5  dB,  surtout  si le  signal  de  sortie  est  retransmis  et  qu’il  peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle réduction doit porter sur la puissance d’entrée ou sur le gain, et ne doit pas se faire au moyen d’un atténuateur raccordé à la sortie du dispositif. This  device  complies  with  Industry  Canada license-exempt  RSS  standard(s).  Operation  is subject  to  the  following  two  conditions:  (1)  this device  may  not  cause  interference,  and  (2)  this device  must  accept  any  interference,  including interference that may cause undesired operation of the device.Gain 100dBBandwidth 75MhzInput and Output Impedances50 ohmOutput PowerUplink 22dBm per bandDownlink 16dBm per bandLe  présent  appareil  est  conforme  aux  CNR d’Industrie Canada applicables aux appareils radio  exempts  de  licence.  L’exploitation  est autorisée  aux  deux  conditions  suivantes  :  (1) l’appareil ne doit pas produire de brouillage, et  (2)  l’utilisateur  de  l’appareil  doit  accepter tout  brouillage  radioélectrique  subi,  même  si  le brouillage  est  susceptible  d’en  compromettre  le fonctionnement.Compliance ContactIn  the  event  of  regulatory  compliance  issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com. PatentsThis product is covered by Nextivity, Inc., US patents and patents pending. Please refer to CEL-FI.com for details. CopyrightCopyright  ©  2016  by  Nextivity,  Inc.  All  rights reserved.  Reproduction  or  media  conversion  by any means is protected by copyright and may only occur  with  prior  written  permission  of  Nextivity. Designed by Nextivity in California.uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,  may cause  harmful interference to  radio  communications.  However,  there  is  no guarantee that interference will not occur in a particular  installation.  If  this  equipment  does cause  harmful  interference  to  radio  or  television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to  correct  the interference  by one or  more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.•  Connect  the  equipment  into  an  outlet  on  a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for helpExternal Antenna (option):Only use with approved Cel-Fi MIMO Panel Antenna A52-X12-100.Industry Canada (IC) StatementThe Manufacturer’s rated output power of this equipment  is  for  single  carrier  operation.  For situations  when  multiple  carrier  signals  are present, the rating would have to be reduced by 3.5 dB,  especially where  the output  signal is  re-radiated and can cause interference to adjacent band users. This power reduction is to be by means of  input  power  or  gain  reduction  and not by an attenuator at the output of the device.La  puissance  de  sortie  nominale  indiquée  par le fabricant pour cet appareil concerne son fonctionnement  avec  porteuse  unique.  Pour des  appareils  avec  porteuses  multiples,  on  doit réduire  la  valeur  nominale  de  3,5  dB,  surtout  si le  signal  de  sortie  est  retransmis  et  qu’il  peut causer du brouillage aux utilisateurs de bandes adjacentes. Une telle réduction doit porter sur la puissance d’entrée ou sur le gain, et ne doit pas se faire au moyen d’un atténuateur raccordé à la sortie du dispositif. This  device  complies  with  Industry  Canada license-exempt  RSS  standard(s).  Operation  is subject  to  the  following  two  conditions:  (1)  this device  may  not  cause  interference,  and  (2)  this device  must  accept  any  interference,  including interference that may cause undesired operation of the device.Gain 100dBBandwidth 75MhzInput and Output Impedances50 ohmOutput PowerUplink 22dBm per bandDownlink 16dBm per bandLe  présent  appareil  est  conforme  aux  CNR d’Industrie Canada applicables aux appareils radio  exempts  de  licence.  L’exploitation  est autorisée  aux  deux  conditions  suivantes  :  (1) l’appareil ne doit pas produire de brouillage, et  (2)  l’utilisateur  de  l’appareil  doit  accepter tout  brouillage  radioélectrique  subi,  même  si  le brouillage  est  susceptible  d’en  compromettre  le fonctionnement.Compliance ContactIn  the  event  of  regulatory  compliance  issue, please contact Nextivity Inc. directly. Contact information is available at www.nextivityinc.com. PatentsThis product is covered by Nextivity, Inc., US patents and patents pending. Please refer to CEL-FI.com for details. CopyrightCopyright  ©  2016  by  Nextivity,  Inc.  All  rights reserved.  Reproduction  or  media  conversion  by any means is protected by copyright and may only occur  with  prior  written  permission  of  Nextivity. Designed by Nextivity in California.

Navigation menu