Nexus ID Solutions SC93200MDBVG3 Access Control Door Reader User Manual

Nexus ID Solutions AB Access Control Door Reader

User manual

CidronVG3 Firmwarev1.7 Upgrade Manual upgrade Step
RS485 2018.07.12(Slim)
Sep1: Connect CidronVG3.
8.T/GPIO3
7.GPIO1
6.GPIO2
5.GND
4.B/RX
3.A/TX
2.GND
1.DC+
RS485
4.B/RX
3.A/TX
2.GND
1.DC+
16.K-LED
15.BZ
14.R-LED
13.G-LED
12.D-/TX
11.D0
10.D1
9.D+/RX
PS :RS485 communication mode
Step2: Select “Start” → “Program” → “Accessory” → ”Communication” →”hyper
terminal”
to open the hyper terminal software:
Step3: Input any name in the Name Option defined yourself, such as:
Step4: Choose correct serial port you now using, and click “OK” button:
Step5: Setting correct port parameters as the following:
If “main menu “display, Input the key “1” at once.
Then there will emerge “CCC….
Step6: Click the button with red circle：
Step7: Choose protocol “Ymodem”, click “Browse” button to search for the file you need
download, then click “Send” button,:
Note：Firmware document must be BIN document.
Program is downloading, please wait…….
Step8: When download completed, software will also show successful and Card reader
will restart
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Information to user.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

Navigation menu