Nietzsche Enterprise SMG0305 Wireless Magnetic Reed Switch Sensor User Manual

User Manual

The Federal Communication Commission Statement

This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to

Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. T

his equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction, may cause harmful interference to

radio communication. However, there is no guarantee that interference will not occur

in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one of more of the following measures: -

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced Radio/TV technician for help.

Use only shielded cables to connect I/O devices to this equipment. You are cautioned that change or

modifications not expressly approved by the party responsible for compliance could void yo

ur authority to

operate the equipment.

THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE

FOLLOWING TWO CONDITIONS:

This device may not cause harmful interference and

2 This device must accept any interference received, including interference that may cause undesired

operation.

The antenna used for this transmitter must not be collocated or operation in conjunction

with any other antenna or transmitter.

Notice : The changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change

to the antenna or the device is permitted. Any change to the antenna or the device could result

in the device exceeding the RF exposure requirements and void user’s authority to operate

the device.