Nikko Co TN6750 Remote Control Toy Transmitter User Manual 100022B eng 3L

Download:
Mirror Download [FCC.gov]
Document ID	349092
Application ID	FNOWc1CeUTHvMMYu/sCayA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	163.95kB (2049326 bits)
Date Submitted	2003-08-18 00:00:00
Date Available	2003-08-13 00:00:00
Creation Date	2003-08-18 14:40:15
Producing Software	Corel PDF Engine Version 11.633
Document Lastmod	2003-08-18 14:40:15
Document Title	100022B_eng-3L
Document Creator	CorelDRAW Version 11.0

RDC-100022B-FCC JEEP RUBICON
English
3 language
English / Français / Español
NIKKO
ST-40800
Owner's Manual
Manuel du lutilisateur
Manual del Propietario
PRINTED IN MALAYSIA
IMPRIME EN MALAISIE
IMPRESO EN MALASIA
• Recharge the Battery
Before You Start to Operate
• Recharger la batterie avant d'allumer
• Recargue la bateria antes de
empezar a jugar
Please read this manual throughly before starting to operate.
Keep the manual for future reference.
FEATURES
2-channel full function: Forward, reverse, left/right turn and stop
Front and rear suspension system
2 x 2 speed in forward running
BATTERY REQUIREMENTS
Vehicle : Ni-Cd battery energy pack
(9.6V, 620-650mAh)
Transmitter : 1 x 9V(006P)battery
ATTENTTION: JOUET ELECTRIQUE
Non recommandé pour les enfants de moins de 8 ans. Comme aves tous les appareils électriques, des précaut
ons doivent être observées pendant la manipulation et l'emploi pour éviter toute décharge électrique.
Entrée: secteur 120 VAC, 60 Hz seulement
Sortie: 12VDC 200mA
PARENTS ATTENTION
Il est recommandé de vérifier périodiquement l'absence de risque potentiel sur ce jouet et tous les
accessoires et de réparer o remplacer les pieces potentieliement dangereuses.
Lisez attentivement ce manual avant de commencer à jouer.
Conservez ce manual pour toute référence ultérieure.
CARACTERISTIQUES
2- canaux et toutes les fonctions:
marche avant, arrière, virage à droite/ gauche et arrêt.
Système de suspensions avant et arrière
2 x 2 vitesses en marche avant
PILES
Véhicule : Batterie autonome Ni-Cd
(9,6V, 620-650mAh)rechargeable
Emetteur : 1 pile 006p(9V)
PRECAUCÓN: JUGETE ELÉCTRICO
No recomendado para niños de menos de 8 años de edad. AL igual que con todos los productos eléctricos,
para evitar un shock eléctrico, se deben observar precauciones especiales al manipular y usar este juguete.
Entrada: Solamente 120 VAC, 60 Hz.
Salida: 12 VDC, 200mA
ATENCIÓN PADRES
Se recomienca que este juguete y todos sus accesorios sean examinados periódicamente para tratar
de encontrar peligros potenciales provocados por piezas que necesiten ser reparadas o cambiadas.
Por favor, lea completamente este manual antes do comenzar
a hacer funcionar su Porsche.
Guarde oste manual para referencias futuras.
CARACTERÍSTICAS
Funciones completas mediante dos canales: Avance, retroceso, giros a la izquierda/
derecha y detención.
Sistema de suspensión delantero y trasero
Velocidad 2 x 2 durante el avance
PILAS USADAS
Vehiculo : Bateria de pilas do Ni-Cd
"energy pack" de
(9,6V, 620-650mAh)
Transmisor : 1 pila de 9 V (006P)
D/SALLY/100022B/100022B-FCC
23-5-03
RDC-060002A ( FCC )
English
3 language
English
RECHARGING
"WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT."
Household
outlet
* The newly purchased Ni-Cd pack is not charged.
Recharge before operate.
1. Join the connector of the charger to the
connector of the Ni-Cd battery pack.
Charger
Household
outlet
2. Plug the charger into an electrical outlet.
3. Recharge for about 4-5 hours.
Ni-Cd battery pack
4. When the recharging is over, plug out the
charger from the electrical outlet and detach
the connectors.
OR
Charger
Ni-Cd battery pack
CAUTION
Do not charge Battery Pack immediately after use.Wait until it is cooled before charging.
Avoid short circuits. Short circuits will cause overheating, burning of the cords and other
damages to the Battery Pack and Charger.
The Ni-CD Battery Charger should be used for charging one Battery Pack . Do not use the
charger for charging other types of batteries and battery packs.
Do not use the Charger as a direct current outlet for other electrical appliances or machines.
Make sure that the Battery Pack and Charger are kept out of the hands of infants and small
children while charging.
Do not charge near fires, where the temperature is extremely high, or where it is wet or damp.
The charger will become slightly heated while charging. Allow sufficient free space around the
Charger.
If the power of the battery pack is weak in spite of proper charging. The batteries may be worn out
from repeated use. Replace it with a new Ni-CD battery pack.
Dispose of use Ni-CD battery packs correctly.
Disconnect the supply before making or breaking connections to the battery.
WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.
Please use this battery charger only for the charger of the rechargeable battery pack.
The NI-CD battery pack should be recharged under the supervision of an adult.
BEFORE YOU START
1. HOW TO ATTACH ANTENNA TUBE
Antenna wire
Antenna tube
Antenna tube
holder
Pass the antenna wire through the antenna tube, then insert the tube into the antenna tube holder.
If the antenna tube cannot be successfully inserted into the antenna tube holder, try holding the
root of the antenna wire with fingers of one hand and extending the wire with fingers of the other
hand.
* Note: Be careful not to pull antenna wire too strong.
RDC-100022B-FCC JEEP RUBICON
English
3 language
English
2. HOW TO INSTALL TRANSMITTER ANTENNA
Place the transmitter antenna into the antenna
holder to screw it in clock-wise.
Do not extend the antenna when installing. It’s
dangerous. If the antenna is not screwed in
securely, the vehicle may move erratically. Screw
the antenna securely.
3. HOW TO INSTALL THE BATTERIES
One 9 volt (006P) battery
Transmitter
To remove the battery lid, press the
point marked “OPEN” and pull the lid
downward.
Install battery and make sure that (+) and (-) poles
are positioned properly.
* Dispose the used batteries separately from
other trash.
Vehicle
When installing a Ni-Cd battery pack, make sure that the power switch of the vechile is OFF.
(1) Join the connectors of the vehicle and
the Ni-Cd pack.
(2) Fix the battery case into the battery
compartment of your vehicle and push
in all the way.
Battery compartment
Battery’s Connectors
+ -
+ -
Vehicle's connector
RDC-100022B-FCC JEEP RUBICON
English
3 language
English
(3) Press down the battery stopper.
When you connect the connectors. Make sure the
vehicle switch is in the “OFF” position.
Fixed connectors properly.(The connectors are
designed to be connected in only one
way so that the positive(+) and the negative(-)
terminals are connected accurately.)
Disconnect the connectors immediately after
played.
When you disconnect the connectors, don’t pull the
cords.
Avoid short circuits because it is very dangerous.
Remove all the batteries both from the vehicle and
the transmitter after played.
Battery’s Connectors
Battery’s Connectors
+ -
+ -
Vehicle's connector
Vehicle's connector
4. HOW TO PLAY
(1) Extend the transmitter antenna.
can control the vehicle at a longer dis* You
tance by holding the transmitter higher with
the antenna straight up.
(2) Turn on the transmitter by operating
the control stick. (The power indicator will light up.)
English
RDC-100022B-FCC JEEP RUBICON
3 language
English
Power
Switch
High
Low
(3) Turn ON the power switch of the vehicle.
(4) Start operation.
FORWARD RUNNING
You can enjoy the excitement of 2 stages of speed
from Normal (LOW) to High (TURBO) speed
forward running by operating the speed control
stick.
LOW
SPEED
Low
High
Low
High
TURBO
(HIGH SPEED)
Forward/Reverse
control stick
Steering
control stick
FORWARD
LEFT / STRAIGHT / RIGHT
STOP
(NEUTRAL)
Low
High
REVERSE
Red LED
power indicator
(5) Turn OFF the vehicle after playing.
(6) To prevent damage from battery leakage, remove all the batteries from
transmitter and vehicle after playing.
RDC-100022B-FCC JEEP RUBICON
English
3 language
English
TO ADJUST STEERING ALIGNMENT
Adjust the steering alignment when the vehicle does not run straight forward.
Turn the steering alignment lever towards
Turn the steering alignment lever towards
“L” if the vehicle runs towards right.
“R” if the vehicle runs towards left.
Select a SAFE place to operate your vehicle, Do not drive in the street. Avoid driving on SAND or
through puddles of WATER. These hazards can impair performance. Check the surface ahead
of you and watch for obstacles.
The radio receiver in your vehicle and transmitter are sensitive instruments. Do not leave Vehicle
or Transmitter near sources of HEAT or under DIRECT SUNLIGHT for long periods of time.
Avoid leaving Vehicle or Transmitter OUTSIDE OVERNIGHT. NIGHT DAMPNESS IS
HARMFUL TO INTERIOR MECHANISM.
Cleaning and maintenance:
This toy vehicle needs periodic maintenance and cleaning.
Warning to the parents:
The charger for the Ni-Cd battery pack needs periodic inspection to see that the lead wires,
plugs, outer case, and other parts are not damaged in any way. If any of the parts
are damaged, do not use the charger until it is completely repaired.
Caution:
Keep out of reach of small children under 36 months old as there is danger of getting hurt.
CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE
MANUFACTURER FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
RADIO INTERFERENCE:
Sometimes erratic behavior or loss of control of vehicle
is the result of interference caused by high tension wires, high voltage transformers, certain types of building, concreate walls or narrow places where RADIO SIGNALS sent from
your transmitter MAY BE SCATTERED thus making it DIFFICULT for your vehicle to
receive a GOOD RADIO SIGNAL. If you encounter this type of behavoir or loss of control,
CHANGE TO A DIFFERENT LOCATION.
You will encounter INTERFERENCE if ANOTHER radio controlled vehicle or CB radio is
operating ti the vicinity on your SAME FREQUENCY.
RDC-100022B-FCC JEEP RUBICON
English
3 language
English
DO NOT operate your vehicle on tick-piled carpets. It can be dangerous since the carpet
fiber may twine round a shaft and cause a motor overheated.
THE RBRCTMSeal on the nickel cadmium battery pack indicates
that Nikko America is voluntarily participating in an industry
program to collect and recycle these batteries at the end of their
useful life. The RBRC program provides a convenient
alternative to disposing nickel-cadmium batteries into the trash
or municipal waste stream, which is illegal in some areas.
Nikko America's payments to RBRC makes it easy for you to drop
off the spent battery pack at local retailers who sell
replacement nickel-cadmium batteries.
You may also contact your local recycling center for information
on where to return the spent battery pack. RBRC is a trademark of
the Rechargeable Battery Recycling Corporation.
THE FCC WANTS YOU KNOW
This device complies with part 15 of the FCC Rules, Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Your R/C car might cause TV or radio interference even when it is operating properly.
To determine whether your R/C car is causing the interference, turn off your R/C car.
If the interference goes away, your R/C car is causing the interference.
Try to eliminate the interference by:
• Moving your R/C car away from the receiver.
• Contacting your local store for help.
If you cannot eliminate the interference, the FCC requires that you stop using your
R/C car.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Page Count                      : 7
Create Date                     : 2003:08:18 14:40:15
Modify Date                     : 2003:08:18 14:40:15
Producer                        : Corel PDF Engine Version 11.633
Creator                         : CorelDRAW Version 11.0
Title                           : 100022B_eng-3L

EXIF Metadata provided by EXIF.tools