Nikko Co TP6731H Radio Controlled Toy (Transmitter) User Manual 1 of 2

Download:
Mirror Download [FCC.gov]
Document ID	472704
Application ID	BIHBWouXmLHKA5vHDIFoyQ==
Document Description	Users Manual 1 of 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	303.03kB (3787822 bits)
Date Submitted	2004-09-24 00:00:00
Date Available	2004-09-24 00:00:00
Creation Date	2004-09-22 17:22:38
Producing Software	Adobe PDF library 5.00
Document Lastmod	2004-09-22 17:23:34
Document Title	Users Manual 1 of 2
Document Creator	Adobe Illustrator 10.0

English/Français/Español
1/10 RADIO CONTROL STREET CAR CAUTION: ELECTRIC TOY
NOT RECOMMENDED FOR CHILDREN
UNDER 8 YEARS OF AGE. AS WITH
ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING AND USE TO PREVENT ELECTRIC SHOCK.
INPUT: 120VAC, 60HZ,
OUTPUT: 12VDC, 200mA
Owner’s Manual
Manuel du lutilisateur
Manual del Propietario
ATTENTION
PARENTS
It is recommended that this toy
and all accessories be periodically
examined for potential hazards and
that any potential hazardous parts
be repaired or replaced.
:help@nikkoamerica.com
PRINTED IN CHINA
IMPRIME EN CHINE
IMPRESO EN CHINA
* Recharge the Battery
Before you Start to Operate
* Recharger la batterie avant d’allumer
* Recargue la bateria antes de empezar a jugar
l Please read carefully before starting to operate.
l "Warning! use under the direct super vision of an adult.
l KEEP THE DISPLAYBOX AND THE MANUAL FOR FUTURE REFERENCE.
l Use Ni-Cd battery pack(9.6V) and charger for this model.
FEATURES
BATTERY REQUIREMENTS
l 2-channel full function: Forward, re verse,
left/right turn and stop.
l 2 speed in forward running
2 speeds by transmitter operation
Vehicle: 1 x NI-CD or NI-MH rechargeable
bat tery pack(9.6 V)
Transmitter: 1 x 9V(006P)battery
l Front and rear suspension system
l Rear wheel differential gear
l The Headlights lightup when running
English
RECHARGING
*The newly purchased Ni-Cd pack is not
charged.Recharge before operate.
1. Join the connector of the charger to
the connector of the Ni-Cd battery
pack (9.6 V).
2. Plug the charger into an electrical outlet.
Household outlet
Charger
3. Recharge for about 4-5 hours.
OR
4. When the recharging is over, plug out the
charger from the electrical outlet and detach the connectors.
Ni-Cd battery pack (9.6 V)
CAUTION:
n Do not charge Battery Pack immediately after
use.Wait until it is cooled before charging.
n Avoid short circuits. Short circuits will cause overheating, burning of the cords and other
damages to the Battery Pack and Charger.
n The Ni-CD Battery Charger should be used for
charging one Battery Pack . Do not use the
charger for charging other types of batteries and
battery packs.
n Do not use the Charger as a direct current outlet for
other electrical appliances or machines.
n Make sure that the Battery Pack and Charger are
kept out of the hands of infants and small
children while charging.
n Do not charge near fires, where the temperature is
extremely high, or where it is wet or damp.
n The charger will become slightly heated while
charging. Allow sufficient free space around the
Charger.
n If the power of the battery pack is weak in spite of
proper charging. The batteries may be worn out
from repeated use. Replace it with a new Ni-CD
battery pack.
n Dispose of use Ni-CD battery packs correctly.
n Disconnect the supply before making or breaking
connections to the battery.
n WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.
n Please use this battery charger only for the charger of the rechargeable battery pack.
n The NI-CD battery pack should be recharged under the supervision of an adult.
PREPARATION FOR STARTING OPERATION
1. HOW TO ATTACH ANTENNA TUBE
Pass the antenna wire through the
antenna tube, then insert the tube
into the antenna tube holder.
Antenna wire
If the antenna tube cannot be successfully inserted into the antenna
tube holder, try holding the root of
the antenna wire with fingers of
one hand and extending the wire
with fingers of the other hand.
Antenna tube
Antenna tube holder
* Note: Be careful not to pull antenna wire too strong.
English
2. HOW TO INSTALL TRANSMITTER ANTENNA
Place the transmitter antenna into the
antenna holder to screw it in clockwise.
Don’t install the antenna extended. It’s
dangerous.
If the antenna is not screwed in securely, the vehicle may move erratically. Screw the antenna securely.
English
3. HOW TO INSTALL THE BATTERIES
One 9 volt (006P) battery
Transmitter
To remove the battery lid, press the
point marked “OPEN” and pull the
lid downward.
Vehicle
Install battery making sure that (+) and (-) poles
are positioned properly.
* Dispose the used batteries sep a rate ly from
other trash.
When installing a Ni-Cd battery pack, make sure
that the power switch of the vehicle is OFF.
Battery stopper
Battery compartment lid
1 Use a coin to turn the battery stopper
to the "OPEN" position.
Join the connectors of the vehicle
and the Ni-Cd pack.
2 Let the battery compartment lid slide
forward a little with a pressure on to
the latch
English
Battery compartment
Fit the battery case into the battery
compartment of your vehicle and push
in all the way.
5 Press down the battery compartment lid
when Use a coin to turn the battery stopper
Vehicle's Connector
Battery's Connector
When you connect the connectors. make certain the vehicle switch is in the "OFF"
position.
Set connectors properly.(The connectors are designed to be connected in only one
way so that the positive(+) and the negative(-) terminals are connected accurately.)
Disconnect the connectors immediately after a run.
When you disconnect the connectors, don't pull by the cords.
Avoid short circuits because it is very dangerous.
Remove all the batteries both from the vehicle and the transmitter after a run.
HOW TO PLAY
Extend the transmitter antenna.
You can control the vehicle at a longer distance by holding the transmitter higher with
the antenna straight up.
2 Turn on the transmitter by operating the
control stick. (The power indicator will
light up.)

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2004:09:22 17:23:34-07:00
Create Date                     : 2004:09:22 17:22:38-07:00
Creator                         : Adobe Illustrator 10.0
Producer                        : Adobe PDF library 5.00
For                             : �������i, NIKKO Co.,Ltd.
Title                           : ���̖��ݒ�-5
Bounding Box                    : 18 43 281 412
Creator Version                 : 10
Container Version               : 9
Page Count                      : 4
Mod Date                        : 2004:09:22 17:23:34-07:00
Creation Date                   : 2004:09:22 17:22:38-07:00
Metadata Date                   : 2004:09:22 17:23:34-07:00
Image Height                    : 369
Image Width                     : 263
Image Size                      : 263x369
Megapixels                      : 0.097

EXIF Metadata provided by EXIF.tools