Nikko Co TP6793 Radio Controlled Toy(Transmitter) User Manual ST40800 FCC Eng

Nikko Co Ltd Radio Controlled Toy(Transmitter) ST40800 FCC Eng

Users Manual

NIKKOST-40830PRINTED IN MALAYSIAIMPRIME EN MALAISIEIMPRESO EN MALASIAEnglish / Français / EspañolOwner's ManualManuel du lutilisateurManual del Propietario• Recharge the BatteryBefore You Start to Operate• Recargue la bateria antes deempezar a jugar• Recharger la batterie avant d'allumerATTENTTION: JOUET ELECTRIQUENon recommandé pour les enfants de moins de 8 ans. Comme aves tous les appareils électriques, des précaut ons doivent être observées pendant la manipulation et l'emploi pour éviter toute décharge électrique.Entrée: secteur 120 VAC, 60 Hz seulementSortie: 12VDC 200mAPARENTS ATTENTIONIl est recommandé de vérifier périodiquement l'absence de risque potentiel sur ce jouet et tous les accessoires et de réparer o remplacer les pieces potentieliement dangereuses.Please read this manual throughly before starting to operate.Keep the manual for future reference. FEATURES2-channel full function: Forward, reverse, left/right turn and stopFront and rear suspension system2 speed in forward runningPower/ Speed selector switchThe headlights light up when runningBATTERY REQUIREMENTSVehicle : Ni-Cd battery energy pack (9.6V, 620-650mAh)Transmitter : 1 x 9V(006P)batteryLisez attentivement ce manual avant de commencer à jouer.Conservez ce manual pour toute référence ultérieure.Por favor, lea completamente este manual antes do comenzara hacer funcionar su Porsche.Guarde oste manual para referencias futuras.PRECAUCÓN: JUGETE ELÉCTRICONo recomendado para niños de menos de 8 años de edad. AL igual que con todos los productos eléctricos, para evitar un shock eléctrico, se deben observar precauciones especiales al manipular y usar este juguete.Entrada: Solamente 120 VAC, 60 Hz.Salida: 12 VDC, 200mAATENCIÓN PADRESSe recomienca que este juguete y todos sus accesorios sean examinados periódicamente para tratar de encontrar peligros potenciales provocados por piezas que necesiten ser reparadas o cambiadas.PILESVéhicule : Batterie autonome Ni-Cd (9,6V, 620-650mAh)rechargeableEmetteur : 1 pile 006p(9V) CARACTERISTIQUESPILAS USADASVehiculo : Bateria de pilas do Ni-Cd "energy pack" de (9,6V, 620-650mAh)Transmisor : 1 pila de 9 V (006P) CARACTERÍSTICAS2- canaux et toutes les fonctions: marche avant, arrière, virage à droite/ gauche et arrêt.Système de suspensions avant et arrière2 vitesses en marche avantSélecteur de Puissance/ Vitesse.Les phares s'allument pendant la course.Funciones completas mediante dos canales: Avance, retroceso, giros a la izquierda/derecha y detención.Sistema de suspensión delantero y traseroVelocidad 2 durante el avanceConmutador selector de Potencia/ Velocidad.Las luces se encienden cuando corre.English 3 language1/10 RADIO CONTROL CAR9.6 VYou Choose! TTP 30/30 gives you the power to burn up those hills, or switch to a real high speed racing truck. More Power or more Speed, you are in control! KMNA-1/1040830-3BNMO-030306À vous de choisir ! La TTP 30/30 vous offre la puissance pour franchir des collines, ou la vitesse pour foncer sur un vrai circuit. Plus de Puissance ou plus de Vitesse, vous avez le contrôle ! ¡Usted elige! TTP 30/30 le brinda el potencial para trepar esas colinas, o cambie a un verdadero camión de carreras de alta velocidad. ¡Más potencia o más velocidad, usted tiene el control!3 BANDS1/10 SCALE FCC 3 BANDSSélecteur 3 bandes.3 bands selector switch.3 interruptor del selector de la banda.
English2English 3 languagePass the antenna wire through the antenna tube, then insert the tube into the antenna tube holder.If the antenna tube cannot be successfully inserted into the antenna tube holder, try holding the root of the antenna wire with fingers of one hand and extending the wire with fingers of the other hand.* Note: Be careful not to pull antenna wire too strong.1. HOW TO ATTACH ANTENNA TUBEAntenna wireAntenna tubeAntenna tube holderBEFORE YOU STARTDo not charge Battery Pack immediately after use. Wait until it has cooled before charging.Avoid short circuits. Short circuits will cause overheating, burning of the cords and other damages to the battery Pack and Charger.The Ni-Cd Battery Charger should be used for charging one Battery Pack. Do not use the Charger for charging other type of batteries and battery packsDo not use the Charger as a direct current outlet for other electrical appliances or machines.Make sure that the Battery Pack and Charger are kept out of the hands of infants and small children while charging.Do not charge near fires, where the temperature is extremely high, or where it is wet or damp.The charger will become slightly heated while charging. Allow sufficient free space around the Charger.If the power of the battery pack is weak in spite of proper charging, the batteries may be worn out from repeated use. Replace it with a new Ni-Cd battery pack.Dispose of use Ni-Cd battery packs correctly.Disconnect the supply before making or breaking connections to the battery.Only use batteries or accumulators of the recommended type or a similar type.WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.Please use this battery charger only for the charge of the rechargeable battery pack.The Ni-Cd battery pack should be charged under the supervision of an adult.CAUTIONRECHARGING "WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT."* The newly purchased Ni-Cd pack is not charged. Charge before operating. Household outletNi-Cd battery pack ORChargerHousehold outletChargerNi-Cd battery pack 1. Join the connector of the charger to the connector of the Ni-Cd battery pack.2. Plug the charger into an electrical outlet.3. Recharge for about 4-5 hours.4. When the recharging is over, plug out the charger from the electrical outlet and detach the connectors.When playing for the first time after purchase, or after a long interval, the battery power may be weak. Even after recharging, the playing time can be relatively short. The battery will gradually regain power after 2 or 3 repetitions of usage and recharging.KMNA-1/1040820-R KMNA-1/1040820-R1
English 3 languageEnglish32. HOW TO INSTALL TRANSMITTER ANTENNAPlace the transmitter antenna into the antenna holder to screw it in clock-wise.Do not extend the antenna when installing. It’s dangerous. If the antenna is not screwed in securely, the vehicle may move erratically. Screw the antenna securely.3. HOW TO INSTALL THE BATTERIESTransmitterOne 9 volt (006P) batteryTo remove the battery lid, press thepoint marked “OPEN” and pull the liddownward.Install battery and make sure that (+) and (-) poles are positioned properly.* Dispose the used batteries separately from other trash.VehicleWhen installing a Ni-Cd battery pack, make sure that the power switch of the vehicle is OFF.(1) Join the connectors of the vehicle and the Ni-Cd pack.++--++--Vehicle's connectorBattery’s ConnectorsBattery’s Connectors*Connect the battery’s connector to the vehicle’s connector properly as shown.Vehicle's connector
English4(3) Press down the battery stopper.English 3 language(2) Fix the battery case into the batterycompartment of your vehicle and pushin all the way. Battery compartmentWhen you connect the connectors. Make sure the vehicle switch is in the “OFF” position.Fixed connectors properly.(The connectors are designed to be connected in only oneway so that the positive(+) and the negative(-) terminals are connected accurately.)Disconnect the connectors immediately after played.When you disconnect the connectors, be careful do not pull the wire too strongly.Avoid short circuits because it is very dangerous.Remove all the batteries both from the vehicle and the transmitter after played. ++--++--Vehicle's connectorBattery’s ConnectorsBattery’s ConnectorsVehicle's connectorYou can control the vehicle at a longer dis-tance by holding the transmitter higher withthe antenna straight up.*(2) Extend the transmitter antenna. (3) Turn on the transmitter by operating the control stick. (The power indicator will light up.)PowerSwitch(4) Turn ON the power switch of the vehicle.4. HOW TO PLAY(1) Ensure that band selector switch on transmitter and vehicle are set to the same letter - A, B or C.A B CBand selector switch on transmitter Band selector switch on vehicle chassis
Adjust the steering alignment when the vehicle does not run straight forward.TO ADJUST STEERING ALIGNMENTTurn the steering alignment lever towards“L” if the vehicle runs towards right.Turn the steering alignment lever towards“R” if the vehicle runs towards left.English 3 language(7) To prevent damage from battery leak-age, remove all the batteries from transmitter and vehicle after playing.(6) Turn OFF the vehicle after playing.(5) Start operation.English5SFORWARD RUNNINGYou can enjoy the excitement of 2 stages of speed from Normal (LOW) to High (TURBO) speed forward running by operating the speed control stick.Steeringcontrol stickForward/Reversecontrol stickRed LEDpower indicatorFORWARDSTOP(NEUTRAL)REVERSELEFT / STRAIGHT / RIGHTLOWSPEEDTURBO(HIGH SPEED)LowLowHighHighLowHighBand selector switch
27MHz 49MHz ABCABC3 BANDS FOR FREQUENCY 27 MHz AND 49 MHz, ALLOWS UP TO 6 CARS TO RACE AT ONCE.English6English 3 languageHOW TO SET GEAR CHANGEOVER LEVERIf the selection lever should not move smoothly, slight turning of the rear wheels by hand will facilitate shifting.Set the gear changeover lever to "S" (left) or "P" (right)."P"- Power"S" - SpeedTHE HEADLIGHTS LIGHT UPThe headlights light up at normal beam during LOW SPEED driving.The headlights light up at high beam duringTURBO HIGH SPEED driving.The headlights light up when running.Set switch to 'P' and you have 30% more torque for wheel spinning power.Set switch to 'S' for 30% more top-end speed on smooth terrain.Turn
English7DO NOT operate your vehicle on tick-piled carpets. It can be dangerous since the carpet fiber may twine round a shaft and cause a motor overheated.TMTHE RBRC Seal on the nickel cadmium battery pack indicates that Nikko America is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life. The RBRC program provides a convenient alternative to disposing nickel-cadmium batteries into the trash or municipal waste stream, which is illegal in some areas.Nikko America's payments to RBRC makes it easy for you to drop off the spent battery pack at local retailers who sell replacement nickel-cadmium batteries.You may also contact your local recycling center for information on where to return the spent battery pack. RBRC is a trademark of the Rechargeable Battery Recycling Corporation.THE FCC WANTS YOU KNOWThis device complies with part 15 of the FCC Rules, Operation is subject to the following two conditions:(1) This device may not cause harmful interference.(2) This device must accept any interference received, including interference that may cause undesired operation.Your R/C car might cause TV or radio interference even when it is operating properly.To determine whether your R/C car is causing the interference, turn off your R/C car.If the interference goes away, your R/C car is causing the interference.Try to eliminate the interference by:• Moving your R/C car away from the receiver.• Contacting your local store for help.If you cannot eliminate the interference, the FCC requires that you stop using your R/C car.English 3 languageSelect a SAFE place to operate your vehicle, Do not drive in the street. Avoid driving on SAND or through puddles of WATER. These hazards can impair performance. Check the surface ahead of you and watch for obstacles.The radio receiver in your vehicle and transmitter are sensitive instruments. Do not leave Vehicle or Transmitter near sources of HEAT or under DIRECT SUNLIGHT for long periods of time.Avoid leaving Vehicle or Transmitter OUTSIDE OVERNIGHT. NIGHT DAMPNESS IS HARMFUL TO INTERIOR MECHANISM.Cleaning and maintenance:This toy vehicle needs periodic maintenance and cleaning.Warning to the parents:The charger for the Ni-Cd battery pack needs periodic inspection to see that the lead wires, plugs, outer case, and other parts are not damaged in any way. If any of the parts are damaged, do not use the charger until it is completely repaired.Caution:Keep out of reach of small children under 36 months old as there is danger of getting hurt.CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.RADIO INTERFERENCE:Sometimes erratic behavior or loss of control of vehicle is the result of interference caused by high tension wires, high voltage transformers, certain types of building, concreate walls or narrow places where RADIO SIGNALS sent from your transmitter MAY BE SCATTERED thus making it DIFFICULT for your vehicle toreceive a GOOD RADIO SIGNAL. If you encounter this type of behavoir or loss of control, CHANGE TO A DIFFERENT LOCATION. You will encounter INTERFERENCE if ANOTHER radio controlled vehicle or CB radio is operating ti the vicinity on your SAME FREQUENCY.

Navigation menu