Nikon 8152EB Wireless Remote Controller User Manual Operational description
Nikon Corporation Wireless Remote Controller Operational description
Nikon >
Users manual
N1544 User manual
（Product Summary）
・Wireless remote controller for camera with Bluetooth Smart technology
・Replaceable coin battery CR2032*1pc
・Connection distance: Up to 10m or more
・Waterproof 1m（IPX7）
・2 color LED red / green
（Mode Description）
This product has four modes shown below.
１．Power OFF mode： Power OFF state
２．Search mode for new device： Green LED Blinking（Slow）
３．Search mode for paired device：Green LED Blinking（Fast）
４．Connected mode：Bluetooth connected state. LED blink is dependent on the device
（Operating manual）
In power off mode (1), this production enters Search mode for new device(2) or Search
mode for paired device (3) with button① long press.
When it is completed connected to the device, it is possible to send commands to the
device.(4)
It transmits the movie command with button② press ,release command with button③
press ,and function command with button④ press.
In power on mode(2)(3)(4), it enters Power off mode(1) with button① long press.
Button①
Button②
Button③
Button④
LED
Federal Communication Commission Interference Statement
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Part 15 Subpart B
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Part 15 Subpart C §15.247
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment has very low levels of RF energy that is deemed to comply
without testing of specific absorption rate(SAR).
FCC Part15 and IC RSS-Gen
This device complies with part 15 of FCC Rules and Industry Canada’s licence-exempt
RSSs. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des
CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'appareil doit accepter tout
brouillage subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Part 15 Subpart C §15.247
RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that is deemed to comply without testing of
specific absorption rate (SAR).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour
un environnement non contrôlé et respecte les règles les radioélectriques (RF) de la FCC
lignes directrices d'exposition et d’exposition aux fréquences radioélectriques (RF)
CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui est considérée
comme conforme sans évaluation du débit d’absorption spécifique (DAS).
Industry Canada Statement
RSS-Gen
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject
to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Compliance
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that is deemed to comply without testing of
specific absorption rate (SAR).
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour
un environnement non contrôlé et respecte les règles d’exposition aux fréquences
radioélectriques (RF) CNR-102 de l’IC. Cet équipement
émet une énergie RF très faible qui est considérée comme conforme sans évaluation du
débit d’absorption spécifique (DAS).