Nikon WT02 Wireless Transmitter Module for Camera User Manual 1 of 3

Nikon Corporation Wireless Transmitter Module for Camera 1 of 3

Contents

User Manual 1 of 3

ii iiiCAUTIONModifi cationsThe FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by Nikon Corporation may void the user’s authority to operate the equipment.Notice for customers in the State of California, U.S.A.WARNING: Handling the cord on this product will expose you to lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.Nikon Inc.,1300 Walt Whitman Road, Melville, New York11747-3064, U.S.A.Tel.: 631-547-4200Notice for customers in CanadaATTENTIONCet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.Notices• No part of the manuals included with this product may be reproduced, trans-mitted, transcribed, stored in a retrieval system, or translated into any language in any form, by any means, without Nikon’s prior written permission.• Nikon reserves the right to change the specifi cations of the hardware and soft-ware described in these manuals at any time and without prior notice.• Nikon will not be held liable for any damages resulting from the use of this product.• While every effort has been made to ensure that the information in these manuals is accurate and complete, we would appreciate it were you to bring any errors or omissions to the attention of the Nikon representative in your area (address provided separately).Notice for Customers in the U.S.A.U.S.A. Federal Communications Commission (FCC)Declaration of ConformityThis device complies with Part 15 of the FCC rules. Operation of the device is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Products that contain a radio transmitter are labeled with FCC ID and may also carry the FCC logo.WT-2AFCC Radio Frequency Interference StatementThis equipment has been tested and found to comply with the limits for a Class B digi-tal device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow-ing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/television technician for help.CAUTIONThis class B digital apparatus meets all re-quirements of the Canadian Interference Causing Equipment Regulations.FCC Radiation Exposure StatementThe available scientifi c evidence does not show that any health problems are associ-ated with using low power wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue), exposure to low level RF that does not produce heating effects causes no known adverse health effects. Many stud-ies of low level RF exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such fi ndings have not been confi rmed by additional research. The Wireless Transmitter (WT-2A) has been tested and found to comply with the Federal Communications Commission (FCC) guidelines on radio frequency energy (RF) exposures. The maximum SAR levels tested for the Wireless Transmitter (WT-2A) has been shown to be 0.267 W/kg at Head.This device should not be co-located or operated with any other antenna or transmitter.$WT2_En_01 ii-iii 04.12.20, 3:50:45 PM

Navigation menu