Ningbo EverFlourish Smart Technology EF202T1 Remote control transmitter User Manual EMW202T1 EMW202US RF manual E
Everflourish Electrical Co., Ltd. Remote control transmitter EMW202T1 EMW202US RF manual E
User Manual
Instruction Manual for
RF Remote Socket and Transmitter
Ref: EMW202T1 + MW202US-RF
Function
1. The remote control socket turns on and off the connected lighting or appliance by a wireless
transmitter using radio frequency up to 25 meters away.
2. It is ideal for lighting control, for the purposes of home automation and energy saving.
3. The receiver has the indicator light for power supply status.
Operation
1. No command setting required.
2. Connect the remote control socket to the mains power supply.
3. Turn off the appliance before connecting to the remote control.
4. Remove the plastic tab at the battery holder on the transmitter to allow battery contact.
5. Press the corresponding “ON”, “OFF” button on the transmitter to switch on and off the
connected appliance by remote control
6. The indicator on the receiver blink once for every reception of power on/off
7. When the indicator light on the transmitter goes dim, it means the battery is in low power. Open
the battery holder (as per below figure) and replace it with equivalent battery in correct polarity
Caution
1. Always switch off your appliance before connection.
2. For INDOOR USE ONLY
3. Appliances to be connected to the remote control socket MUST NOT exceed the voltage and
frequency ratings as in “Specifications”.
Specifications
EMW202US-RF
1. Power Rating : 120VAC, 60Hz,
2. Resistive load: 1000W max.
3. Frequency: : 433.92 MHz
4. Distance: : up to 80 feet in open area
EMW202T1
1. Battery : CR2032 3VDC (included)
2. Frequency : 433.92 MHz
3. Distance : up to 80 feet in open area
Holder:
Everflourish Electrical Co., Ltd.
Renjiu Village, Wuxiang Town, Yinzhou, Ningbo, 315111 P.R. China
Caution:
This device complies with Part 15 of the FCC Rules and Industry Canada
licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Prudence
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.