Nortek Security and Control 00137 Smart Charging Dock Station User Manual 10009954X2 Libris BT Quick Start Guide indd

Nortek Security & Control LLC Smart Charging Dock Station 10009954X2 Libris BT Quick Start Guide indd

Users Manual

Quick Start Guide
Numera, Numera Libris, “Measurably Better Health” are trademarks of
Nortek Security & Control LLC. All other company and product names used herein
may be trademarks, or registered trademarks of the respective companies.
Copyright © 2016 Nortek Security & Control LLC 10009954 X2
Quick Reference
Turn Libris ON: Press the Call Button and
hold until the Battery Indicator  ashes.
Turn Libris OFF: Press the Call Button
twice quickly; hold the second press for
7 seconds or until Libris plays a message
con rming your request to turn off. Press
the Call Button again to con rm.
Place an emergency call:
1. Press and hold the Call Button.
2. Listen for the alert tone, followed by the
audio message: “Calling your response
team now. Please hold the device and
position the microphone near your
mouth to complete your call”.
3. Your response team will answer and
notify emergency services for you.
For more information about Libris visit
www.numera.com
Battery & Cellular Indicators
Battery Indicator around Call Button
shows the level of battery charge.
Battery
Indicator Status*
Action
Required
Green Good Ready for use
Amber Moderate No action needed
Red Low Charge soon
*Battery is designed to hold a charge for 36 hours
but may be reduced as a result of user activity, cellular
coverage, talk time, device-speci c settings, and
device life.
Cellular Indicator on top of Libris shows
cellular signal strength.
Cellular
Indicator
Signal
Strength*
Green Strong
Amber Moderate
Red No Signal
*A cellular signal may not be available in all areas.
1. Cellular Indicator shows
cellular signal strength.
2. Battery Indicator shows battery status.
3. Call Button initiates a two-way
call to response team.
4. Program Indicator shows when
optional Pendant devices are added.
5. Power Connector for power cord.
6. Program Button used to add
optional Pendant devices.
About Libris
PRINTER’S INSTRUCTIONS:
INSTRUCTIONS, QUICK GUIDE, CHARGER, NUMERA - P/N: 10009954 X2 - INK: 4/C + COATING - MATERIAL: 80 LB. VELVET COVER - SIZE: FLAT 16.000” X 4.750” FOLDED 2.750” X 4.750” - TOLERANCE: ± .125" - SCALE: 1-1 - ROLL FOLDING: Z-FOLD, FINISH WITH COVERS SHOWING - SIDE 1 OF 2
#00000-AAAAAa
S30-xxxxx
Step 6:
Review User Guide
The User Guide provides key information
about Libris, including Important Safety
Information. Please review it carefully and
keep it nearby for reference.
If you have questions, call your
response team.
By activating your
Numera Libris you
agree to the Terms of
Use and understand
the Important Safety
Information in the
Numera Libris User
Guide.
o
f
d
y
User Guide
IMPORTANT:
Pendant Calling Devices will only
operate within a limited distance from
the Charger. Maximum recommended
distance is 150 feet from the Charger.
1
2
3
456
REGULATORY INFORMATION
We, Nortek Security & Control, LLC of 1950 Camino Vida Roble STE 150, Carlsbad, CA 92008, declare under our sole
responsibility that this device complies with Part 15 of the FCC rules.
FCC & IC Notice
This device complies with Part 15 of the FCC Rules and Industry Canada license exempt standard(s). Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference received that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician to help.
WARNING: Changes or modifi cations not expressly approved by the manufacturer could void the user’s authority
to operate the equipment.
To satisfy FCC/IC RF exposure safety requirements, a separation distance of 20 cm or more should be maintained
between this device and person’s body (excluding extremities: hands, wrists, feet and ankles).
Step 1:
Activate Libris
1. Insert the Power Cord into the Charger.
Plug the large end of the Power
Cord into a standard wall outlet.
2. Place Libris in the Charger.
3. Libris will automatically turn
on and begin activation.
4. Follow the voice prompts until directed
to connect to your response team.
Step 2:
Call to Set Up
1. Press and hold the Call Button.
2. Your response team will answer shortly
to customize Libris and complete set up.
3. After the call, charge Libris in the Charger
for 4 hours. Then it is ready for use.
Step 5:
Wearing Libris
Libris can be worn on a belt using the
Belt Clip, or as a pendant around your
neck using the Lanyard/Clip. If worn
with the Lanyard, Libris should be
worn under clothing to prevent excess
movement of the device.
To attach the Belt Clip or Lanyard/Clip:
1. Align the notched side of
Clip with the notched area
on the back.
2. Press inward until the Clip
notches are nested within
the Libris notches.
3. Firmly push the Clip toward
the top of Libris. It is secure
when you hear a click or you
can no longer see the notches
on the Clip.
Step 3:
Adding Pendants
The Libris Charger can be programmed to
recognize optional Pendant Calling Devices.
To add a Pendant Calling Device:
1. Be sure the Libris is in the Charger
and the Charger is powered on.
2. Press and release the Program
button on the rear of the Charger. The
Program indicator will light amber.
3. Within 20 seconds, activate a
Pendant Calling Device.
4. The Program indicator should light green
when the Pendant is recognized.
5. Repeat steps for additional Pendants.
Step 4:
Testing Pendants
If optional Pendant Calling Devices are
added, they must be tested.
To test Pendant Calling Devices:
1. Be sure the Libris is in the Charger
and the Charger is powered on.
2. Activate a Pendant Calling Device by
pressing the button on the Pendant.
3. Your response team will answer
shortly to verify your testing.
Enjoy new
freedom
This Quick Start Guide will help you set
up and activate Libris. Please read
this entire guide before using Libris
to ensure it is set up correctly and
ready for use.
1
2
1
What’s in the Box
Libris Charger Lanyard/Clip Belt Clip
Power Cord Quick Start Guide User Guide
CONTENTS
ick Sta
rt
Guid
Quick Start Guide
User Guid
User Guide
IMPORTANT:
Libris is not ready for use until you have:
• Charged Libris in the Charger for 4 hours
• Completed a call with the response team
IMPORTANT:
Pendant Calling Devices can only place
an emergency call if the Libris is resting
in the Charger and the Charger Power
Cord is plugged into AC power.
Pendant Calling Devices do not have
a speaker or microphone, talk to the
response team through the Libris unit.
PRINTER’S INSTRUCTIONS:
INSTRUCTIONS, QUICK GUIDE, CHARGER, NUMERA - P/N: 10009954 X2 - INK: 4/C + COATING - MATERIAL: 80 LB. VELVET COVER - SIZE: FLAT 16.000” X 4.750” FOLDED 2.750” X 4.750” - TOLERANCE: ± .125" - SCALE: 1-1 - ROLL FOLDING: Z-FOLD, FINISH WITH COVERS SHOWING - SIDE 2 OF 2
1
2
4
3

Navigation menu